Question about 2007 Mercedes-Benz R-Class

Open Question

How to close R350 rear side window

Very back windows located on the long extended rear will not close. Is there a special button located inside on the drivers side to remotely close? Please help!

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 19 Answers

SOURCE: A190 front side window stuck in half open position

Hi. The Front windows are on a seperate fuse from the rear and this MAY be your problem. the fuse for the front windows is fuse No 33 - 30amp. (that’s the fourth fuse from the left / centre row, the fuses are numbered) The Rear window fuse is No 42 just for information.

If the battery has been discharged you MUST!!! Reset the Power Windows and Traction control. It's very simple and the instructions are in your driver’s manual. But just in case you don’t have it, here they are:

Resetting the side Power Windows
If the voltage supply is interrupted (battery disconnected or flat), the side windows must be reset to prevent injury to driver or passengers:

  1. Turn the key to position 2 in the ignition lock.
  2. Press on the switches to the (Up or Closed position) pressure point until the windows are fully up, and hold for approximately 1 second.
Resetting the ESP (Electronic Stability Program or “Traction Control Systems”)
If the voltage supply is interrupted (battery disconnected or flat), the indicator lamp will light up while the engine is running.
  1. Turn the steering wheel from stop to stop while the engine is running. The indicator lamp will go out & the ESP system is reset.
If you need a copy of all the fuse values and locations etc. Post a reply here at FixYa with your email address and I will forward you a schematic diagram……..[did one for myself that’s easier to understand / follow than the Merc one]

Hope this helps!!!!

Posted on Jul 07, 2009

Ad
jasperoni
  • 203 Answers

SOURCE: top will not close clk 430 mercedes benz

did you recently have a dead battery? Either way try to resynchronize your windows (i'm not sure if you meant front window or rear quarter window). If you hold the window switch in the up position(car running and door closed) untill window reaches the top and continue to hold for 10 seconds the window will reprogram itself. try both front windows. This system is complicated and is best diagnosed via s.d.s. diagnostic machine. I will give you a couple of other possible easy remedies. If your vehicle is equiped with a ski window in the rear trunk panal the door must be shut, also your cargo cover must be shut and plastic lid secured. There are numerous micro switches that input to your soft top control unit-any one could cause the top to be inop. Check to make sure the switch on the cargo cover( retractable cover in trunk) is secured to it's housing, they do periodically fall off. Also if your roll bar ( rear head rests ) has been mechanically deployed You must hold the switch in the up position untill the rams lock back into the roll bar-does the roll bar operate? Always operate top with vehicle running because they are very voltage dependent. Your owners manual will explain how to manually raise top and some simple operation and repair remedies. If you are knowledgable about automotive electrical systems you can disconnect both leads from the battery and touch them together to drain the capacitors and it may reset the module( do not attempt if you are not knowledgable with automotive electricity because there are many things that can go wrong. hopefully I have been helpful.

Posted on Jul 25, 2009

  • 10 Answers

SOURCE: I have a station wagon 1985. Last night, in

Given that another window went out, the most likely cause is that the temperature / ice caused extra load on the motor for the window, and you blew the fuse. Replacing the fuse should fix it. The fusebox is under the hood, on the firewall, just in front of where the driver sits (near the hinge). You'll remove the two twist knobs to get at the fuses. Note that this car takes a different type of fuse than most cars sold in the US. There should be a paper guide inside the lid of the fusebox to tell you which fuse handles those windows. Sometimes the fuses don't look blown even when they are.

Posted on Feb 27, 2010

  • 1619 Answers

SOURCE: MBZ 1984 300D Driver side front window & passenger rear

Nope 1 fuse controls all the windows. Either its the switch or the window regulators themselves or due to the age the wiring.

Posted on May 04, 2010

  • 414 Answers

SOURCE: can a bad fuse be

Most likely the switch assembly for that side. My son had the same issue with his
81 Mercedes. These switches are special as they feed power from front window
switch to the rear window switch and is sold as an assembly. Autohausaz.com may carry it for you.

Posted on Jul 31, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Neither the driver's side or pass. side windows will work. Rear windows work.


What kind of car?? But check wiring. Open drivers door and between the hinges you will see a black rubber housing. Inside that housing are all the wiring that go to that door. Peel it back and check for broken wires. Every time the door is opened and closed those wires are bent back and forth and over time they will break not all of them but usually the window wires will because they are the thickest. All your windows rely on the main switch in that door to function properly.

Mar 04, 2013 | Cars & Trucks

2 Answers

How to program key fob for 2011 hyundai santa fe


Nonsense. I just programmed a new remote start fob on my 2011 Santa Fee limited and it worked just great. Follow the steps below and see what happens.
1. Open the drivers side door
2. Turn the Vehicle ignition to the ON position (Do not start the vehicle)
3. Locate the disarm/program button. (look closely, it is located on the wiring harness just inside the lower dash. it could be located just inside the fuse cover.)
4. Press and hold the disarm/programming button for 10 to 15 sewconds, the horm will beep 3 times. Release the disarm/programming button.
5. On the fob, press the Find/Panic button One time and the horn will beep one time.
6. Turn off vehicle ignition. (YOUR DONE)

Jun 08, 2012 | 2011 Hyundai Santa Fe

1 Answer

The driver side window will not come back up. the


I have this problem in my Buick Park Avenue. The two passenger side windows and the driver window work fine, but the rear driver side window won't close if it's opened. I disconnected the wire from inside the door to avoid further problems.

First try helping the window up, by gently pulling on it while you push the button. If this doesn't work and your vehicle is still under warranty, take it back to the place of purchase, the window motor will need to be serviced or replaced.

1208168.jpeg
Buick Rendezvous Window Motor


May 25, 2010 | 2002 Buick Rendezvous

1 Answer

I went to put down my convertible top and it hit something in the back seat and now it is stuck. I had to manually put it down, the electrical part of it is still not working, Can anyone give me some...


I don,t understand how roof hit something in back seat
If roof is down you need to use special tool located end of driver side dash
Flip of plastic cover to see tool
Check owner manual how to use
The tool will locate between rear seat,this will close and lock rear cover
Make sure both sides of rear cover lock,get friend to press down
Once rear cover is locked down,remove tool,and check opperation
Make sure doors shut and windows down

Apr 03, 2010 | 2005 Audi S4

1 Answer

Problem The rear hatch door will not unlock.


First, on the rear hatch, there is an actuator. On FX, when you close the trunk, it kind of **** the hatch closed all the way. When you press lock on the remote, this same actuator locks it as well.
Now,
1) when you unlock the car from the inside, go back there and press the button to open the hatch door manually, do you here any noises?
2) Close all doors, go back close to the hatch button and using the remote , lock the car and then unlock the car. you should hear a sound from the actuator locking and unlocking the lock on the rear hatch!

If you don't hear this, your actuator is inop.
Next step would be to check the fuses inside the car, on the left bottom driver side, and outside on the battery compartment.
It might be just a fuse.
If all fuses check ok, your actuator is most likely gone! Not ea expensive fix, just time consuming!

NOW, if you can hear the noises, then something is either broken inside the actuator or one of the cables is loose!
Hope that helps.
Also, what year and miles on your fx?

Oct 20, 2009 | 2004 Infiniti FX35

1 Answer

3 nonddriver windowswont open; did open from remote key


pcm needs to be updated it has a brain fart

Sep 28, 2009 | 2005 Honda Accord

1 Answer

1997 BMW Convertible driver/passenger windows won't go down


I had a similar problem with a '95 Olds. Turned out that the wires between the door frame and the driver's side door had broken from the constant flexing of the door opening and closing.

Jun 11, 2009 | 1997 BMW 328

4 Answers

2004 Jeep Grand Cherokee driver side power windows do not work


I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.

Nov 25, 2008 | 2004 Jeep Grand Cherokee

1 Answer

2004 tahoe


make sure than you have not split any fluids on the passenger front door most of the times is where the module to control the windows and doors is located, try by unpluging the batterie and the after a minute plug it back and see what happend but if any of your ft doors have been split with liquid or rain has gone inside then most likelly the module got moisture and not working

May 31, 2008 | 2003 GMC Yukon

Not finding what you are looking for?
2007 Mercedes-Benz R-Class Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...