Question about Cars & Trucks

1 Answer

I have the front left turn signal not working but the bulb is wotking fine when it is in normal use. I change the bulb but still same. The rear bulb iss blinking very fast when when I use the turn signal, do you think thereis a problem with the flasher? How I can check it? Where is the flasher for Taeho 2009

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 100 Answers

When one bulb burns out, the other bulb blinks very fast. If the bulb is know to be good, then you probably have a fault with the signal circuit. Check for 12V at the load, (Bulb) if you have power there, then the bulb may not be making good contact in the socket. Doubt if the flasher is the problem..

Posted on Nov 17, 2013

  • Mohamed UAE Nov 17, 2013

    I just replace the front bulb as I was expexting it is faulty. When I use I hazard signal the bulb become off.

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 7 Answers

SOURCE: left turn signal problem on06' chevy tahoe

check your left light fixture.make sure you have a good contact.sometimes they burnout

Posted on Feb 07, 2009

  • 35 Answers

SOURCE: 1997 Cheverolet z71 blinker problem

the most common problem is the light boeard in the tail lights usually replace the board full of bulb sockets and that takes care of it but before condeming the board make sure you are getting power to it

Posted on Mar 08, 2009

  • 5 Answers

SOURCE: Chevy Cavalier 2001 turn signal blinks fast

If new bulbs don't work, it is probably the harness that holds the bulb. I had to replace both on my car after fighting with the problem for over a year and not knowing.

Posted on Mar 19, 2009

  • 52 Answers

SOURCE: Left turn signal blinks fast in rear and regular in front

the bulb is blown out. you need to change it. also if the bulb is not blown out or if the blinker still blink fast after you change the bulb then you have a ground problem. just remove that blinker light and check the ground wire on it. if you need to replace it and find a good groun on the car. you should be fine. this is all it is .

Posted on Jun 04, 2009

kidspeedy
  • 321 Answers

SOURCE: left rear turn signal light on my 1999 chev. s10 is not working

any increase in bink speed is direcly related to a bulb being burt out.

Posted on Jun 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Left turn signals won't flash, Right side works fine. Replaced front and rear turn bulbs (rear was burned out). Bulbs come on fine on the left side, they just won't flash.


Gday mate, we had a problem with another late model vehicle similar to that, the bulb that was put into the reverse light was not exact brand product ( ohmage was slightly wrong ) and fowled up computer, correct bulb in place and disconnect battery to reset K A M ( keep alive memory) problem solved, BEWARE, some vehicles cannot have KAM reset except for dealer computer tethered reboot , just try putting the factory correct bulb(s) in and see how it goes, geoff. hope this helped.

Feb 11, 2012 | 1998 Buick LeSabre

2 Answers

My left turn signal goes too fast when i want to make a left turn but my right turn signal is fine... how do i make the left one normal again?


Replace the burned out bulb. It is flashing fast to alert you that bulb is burnt out. Turn on the side that works properly & note all bulbs flashing in front, rear & side. Most likely there is at least 1 burnt out on the other side.

Jun 25, 2010 | 2001 Cadillac DeVille

1 Answer

I have a 2002 pontiac aztek. My rear right signal/brake lamp does not work. When i signal left, the front and rear left lights flash normally. When i signal right, the front right light flashes normally...


as for the faster flashing thats as simple as a blown bulb, replace the bulb and see if that fixes the problem, it may fix the lot because the other symptoms you mention are a bad connection, if bulb is fine check the connection isnt loose or corroded over. if it is simply file it back to establish better connectivity,

Jun 22, 2010 | 2002 Pontiac Aztek

1 Answer

Jaguar xj6 break light cancels signal


Replace the turn signal switch. Bad contact inside causing a crossing of the circuits. When the turn signal is applied it should open the brake light circuit allowing for just the signal to work. Doesn't sound like the switch is doing it's job.

May 23, 2010 | 1989 Jaguar Vanden Plas

1 Answer

2003 Ford Explorer Sport rear turn signal acting up


if it's only the rear turn signal that does this, check the plug where the bulb snaps in. if loose or bad connection to bulb, it will sometimes work and sometimes not. if its both the front and rear turn signal bulbs, could be the combination switch. these were common failures on fords

Feb 18, 2010 | 2003 Ford Explorer Sport

1 Answer

1996 chev pickup - left rear turn signal does not work. Front turn signal is blinking fast. Have replaced bulbs and the lamp bases in taillight section. Right side is working fine. Could it be the flasher?


no it can not be the flasher. if bulbs and socket is good in left rear u may have no power or ground. need to check wiring to that lamp. also fast blinking is a normal condition when you have a lamp out

Nov 19, 2009 | 1996 Chevrolet C2500

2 Answers

Left rear turn signal light on my 1999 chev. s10 is not working


any increase in bink speed is direcly related to a bulb being burt out.

Jun 12, 2009 | 1999 Chevrolet S-10 Pickup

1 Answer

Jeep Liberty Left Rear Turn Signal Not Working


sounds like the bulb you have is the wrong resistance the new noen bulbs will do this

Nov 16, 2008 | 2004 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...