Question about Cars & Trucks

2 Answers

Hi my car dies when clutch is pressd or when i change gears, the RPM goes below 1 and car stops/Dies.. this happen only when car is running with AC ON .at idle this does not happen even if the AC is left on.. only happens while running ..like slowing down or changing gear ..without the AC The car works like charm

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers

Sounds like the car needs a tune up, or belt maybe too losse

Posted on Nov 17, 2013

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Cam or crank sencor

Posted on Nov 17, 2013

Testimonial: "like for Example iam cursing at 40km/hr speed and i see a speed breaker and there i reduce speed and hold my clutch to shift gear the car rpm drops and car dies ..u immideatly release the clucth and car comes back on this gives a sudden jerk in the car as engine comes back ....this hapens only while driving with AC this does not hapen when car is parkd ...its only while driving and only when AC is ON"

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 43 Answers

SOURCE: Truck idles rough but at

Give it a complete tune-up, New spark plug and wire.new Ignition coil. Depending on the engine either replace ,Cap and rotors or coil packs.Also might want to get the fuel injectors service

Posted on Nov 17, 2008

philriden
  • 146 Answers

SOURCE: 2002 camry battery changed, dies in idle

When you take your battery out and put a new one in all your computer controls have to be reset. You need to drive the car at 55 MPH for 2 min or so, stop, go through normal drive cycle, stop and go and then if it don't straighten out you need to clean the throttle body and the idle air control valve. Hope this helps. PHil

Posted on Jan 09, 2009

zyberwax
  • 1 Answer

SOURCE: 1996 VW Jetta with 2.0 engine. Dies when slowing from high RPM

I would check the EGR if your car has one it could be sticky, A Renault laguna we had did the same thing, died when letting it down to idle but would
recover, or when it died it would run fine on idle when restarted.
EGR was sticking on it. Vacuum lines could also be an issue.. EGR need vacum to work properly. Trotle body could also be worn, but normally that gives you an uneven idle.

Posted on Jul 23, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Shakes and dies when RPM goes below 1


intake idler unit needs cleaning unit is on the side of the intake not the one that controls throttle the other one. remove and clean out. or spray carb cleaner in to clean out. also clean the connectors on the wiring. should be fine after that, if not you will need to remove it and give it really good clean out.

Jul 21, 2017 | 2000 Ford Taurus

1 Answer

Hi my car dies when clutch is pressd or when i change gears while AC on


Have you tried raising the idle speed another 100 rpms ?

Nov 15, 2013 | 2008 Ford Ikon 1.6

1 Answer

2002 explorer RPM gauge drops below 500RPM when in idle/park. Then the vehicle dies. HELP


The cable needs to be replaced their is a spring in there and that's shot

Apr 25, 2017 | 2002 Ford Explorer

2 Answers

My car will start and idle fine sometime and sometime it dies and dies when put in gear


Engine stalls cold or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.

Nov 06, 2012 | 1986 Ford Mustang

1 Answer

1996 pontiac firebird when I push in on the clutch the voltage meter goes down and the engine dies


I would check out the clutch itself, plate, pad, cylinders, etc. But it could be something as simple as it idles at waaay to low of an RPM, which that is a simple twist of a screw to fix.

Jun 19, 2012 | 1996 Pontiac Firebird

1 Answer

Car dies at stop, or down-shifting into second gear.


try turning the idle screw counterclockwise. #5 in the pic below.
0900c152802664f5-qoourh23u0mln3qht2iy2cfx-2-0.gif

Jul 04, 2017 | 1985 Volkswagen Cabriolet

1 Answer

Hello. i have the ff. problems with my 1994 honda accord manual: 1. the engine dash "orange" light on and cant find solution from local mechanics: 2. engine rpm is 1300 when starts and 800 rpm...


first engine light is on a reason it has a code stored needs to be read,2.sounds like it needs throttle body cleaning,and3.if clutch is hard means master clutch cyl is bad if hydraulic and if manual cable is worn.











TIM...

Dec 02, 2010 | 1994 Honda Accord

1 Answer

1993 pathfinder xe dies on occassion after the rpm guage flutters


might be in the alternator with the heater and ac on it is drawing alot of extra jucie from the battery in which is putting a strain on the alternator in which is causing the engine to not get enough power to the coil to fire properly

Jan 25, 2009 | 1995 Nissan Pathfinder

1 Answer

Engine dies when placed into gear such as reverse or drive


sounds like it may be in the timing i had a car that did that and had to change the timing chain and gears out on it

Jan 23, 2009 | 1992 Buick Century

3 Answers

2001 Galant service engine light on & won't stay running/ runs rough


Try this: Disconnect the ecm control (where the air filter is housed)
Let me know if that worked.

Oct 02, 2008 | 2000 Mitsubishi Galant

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...