Question about Nissan Cars & Trucks

1 Answer

1993 nissan put 2.4 choking on driving

1993 nissan 2.4 put choking on drive

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Nissan Expert
  • 110 Answers

Is this an Altima? then check intake gasket to head leaking vacume

Posted on Jan 06, 2014

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

geharbison
  • 101 Answers

SOURCE: 1993 4X4 BLASER 4WHEEL DRIVE

Your blazer is equipped with a shift on the fly four wheel drive. That means that at speeds less than fifteen miles per hour you can shift into or out of four wheel drive by simply pushing the four wheel high button. If you wish to shift into four wheel low. Stop, put the transmission into park or neutral, and push the four wheel low button. Same procedure for shifting back out. Never shift into or out of four wheel low while moving. And be careful in four wheel low. At full throttle your still barely moving, you don't want to blow your engine up!

Posted on Dec 31, 2008

  • 2 Answers

SOURCE: shifting into 4 wheel drive

For 4W Hi either be stopped or moving at a slow rate of speed (<20 MPH) and move your 4WD selector to the 4 Wheel Hi position.

For 4W Lo stop and move the selector from 2W Hi to 4W Hi then push down on the selector and move through N into 4W Lo.

Posted on Mar 07, 2009

  • 454 Answers

SOURCE: 1993 nissan altima what could be causing a screeching

It probably is a belt. You should look under the hood and check for a loose belt. Tighten as necessary. You should not be able to deflect the belt more than 1/2" in the center of the span of the belt.

Brakes will also make a screeching noise when they are worn out. This noise will also go away when you stop (of course). The sound is quite different than the belt sound.

Posted on Jan 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 Nissan Pathfinder 4wd starts and runs fine but it will not go into gear to drive or reverse,what is the problem?


How To put a Nissan Into 4 Wheel Drive - YouTube

? 2:09
https://www.youtube.com/watch?v=IirIxH0WIVI
Mar 13, 2011 - Uploaded by suzuki230
Just a quick How To, on putting your Nissan into 4 wheel drive. ... to warn the newbies not to drive on hard surface while in 4WDthis can ... If you're having difficulty engaging the 4wd low gear, you can steer ... Hey man i have a 1991 nissan pathfinder SE im going to install a ... How fast can you go on 4L?.

Nissan Pathfinder Questions - automatic will not go into any ...

www.cargurus.com > Questions > Nissan > Pathfinder

CarGurusautomatic will not go into any gear - was driving and parked. now it wonit go into gear. ... Asked by avips Apr 14, 2010 at 04:02 PM about the 1993 Nissan Pathfinder. Question type: Maintenance & Repair ... 2002 Nissan Pathfinder LE 4WD.

Automatic Transmission May Not Shift Correctly at High ...

repairpal.com > Problems > Toyota > 4Runner
truck periodically will not shift into drive at initial start-up. Will very often shift ... 1990Toyota 4Runner- Automatic Transmission100,000Visitor. I have very similar ...

10 Most Common Transmission Problems



Jan 01, 2016 | Nissan Cars & Trucks

1 Answer

1993 Mercedes 200e starts, but when cold starting, its not ready to drive for 2 mins


The fuel pump relay is very common on that model and can cause those symptoms, I would start there first

Dec 29, 2012 | 1993 Mercedes-Benz E-Class

1 Answer

1993 Nissan Maxima won't engage when in drive


check to see if there is a broken axle. if not, check the shift linkage going from the hand shifter to the transmition.

Nov 03, 2012 | 1993 Nissan Maxima

1 Answer

My 1993 nissan sentra se-r falls on its face at 3000 rpms just hitting the gas and driving it


Hello ,,i have run into a situation some what the same with another unit but i describes it quite well, i found a piece of fuel line that some one had replaced and the hose was not rated for gas, the line swelled on the inside and choked off the fuel flow at high demand, i`e pulling hills and hi RPM`s

Jun 01, 2012 | Nissan Sentra Cars & Trucks

1 Answer

Engine seized up


if your engine seized it wouldnt start again you must have either a sensor that is so clogged that chokes up the motor ,like a air idle control valev,o2 sensor,catalytic converter.could be either one of these...

Feb 13, 2010 | 1993 Nissan Altima

1 Answer

1993 nissan altima what could be causing a screeching


It probably is a belt. You should look under the hood and check for a loose belt. Tighten as necessary. You should not be able to deflect the belt more than 1/2" in the center of the span of the belt.

Brakes will also make a screeching noise when they are worn out. This noise will also go away when you stop (of course). The sound is quite different than the belt sound.

Jan 31, 2010 | 1993 Nissan Altima

1 Answer

Auto trans car chokes down and engine shuts off when in gear


the torque convertor is locking up,There is a plastic wire harness on top the transmission,Unplug it from the transmission and your troubles will cease,
If you want it repaired and transmission shop can do it,or you can drive it for ever unplugged

Jan 26, 2010 | 1993 Oldsmobile Cutlass Ciera

1 Answer

Order to put wires on nissan maxima


For the 1993 Nissan Maxixa 3.0L:

Firing Order:
1-2-3-4-5-6

Cylinders:
......(back)
1.......3........5
2.......4........6
......(front)

Distributor Connections:
...(back)
............1
......6
5.................2
............3
......4
..(front)

Oct 20, 2009 | 1993 Nissan Maxima

1 Answer

1993 Nissan Altima Gearshifter or Transmission problem


Sounds like a neutral safety switch in problem #1 and a sticky or faulty solinoid in problem #2
The tranny has quite a few solinoids that are electronic which sometimes burn out or fail with high mileage.
Hope this helps
Regards
Sam

May 12, 2009 | 1993 Nissan Altima

1 Answer

1993 Jeep Grand Cherokee Laredo wont drive when put into gear


No, not with out a lot of work. Electronics are most likely different on the 2 also.

Mar 11, 2009 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...