Question about 1992 GMC Jimmy

1 Answer

Vortex vehicle does not always start and stalls out at traffic lights.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 100 Answers

Check your idle position sensor/throttle position sensor. can be removed and cleaned, may need new gasket when removed. use carb cleaner and Q tips.

Posted on Nov 17, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will bad oxygen sensor make a SUV stall?


I have yet to run into one that old mKe a vehicle not start. My first thought is to check for fuel pressure with a ful pressure gauge.

Feb 06, 2012 | 2000 GMC Yukon Denali

1 Answer

I am having fuel problems with my 2001 ford windstar. it was stalling on me off and on but always would start after about 30 minutes but this last time it wouldn't start at all. I replaced the fuel pump,...


My 2000 Windstar with the 3.8 liter V6 would stall when idling or at intersections. It ran fine down the road, but stalled at stop lights. The fix was to replace the Idle Air Control Valve. It is an easy to replace item, since it is held on by two bolts right on the top of the Air intake from the air cleaner. I tried to clean the old one, with spray cleaner, but it only helped a little. Since stalling at an intersection is dangerous, especially when you need to get out of the way of oncoming traffic, I opted to just buy a new replacement valve. You can get one from O'Reileys, Autozone, PepBoys, NAPA, et. It cost almost $100, but how much would getting hit cost if you could not get out of the way of oncoming traffic. Replacing it took about ten minutes. My Windstar is now reliable when I need to blast off from a dead stop after idling at a signal. My Windstar is the favorite family vehicle for mountain trips, beach trips, Vegas trips, and the surfboards, sleds, people all fit nicely.

Here is a link to the valve that I got a NAPA just to show you what a small simple, but vital, part it is.
http://www.napaonline.com/Search/Detail.aspx?A=CRB216639_0169844105&An=599001+102000+50028+2028059

Jan 07, 2011 | Ford Windstar Cars & Trucks

1 Answer

My probe is stalling at traffic lights. the rpms wont stay high enough to keep the engine running.


Most modern cars with fuel injection, have to maintain a certain range of fuel pressure. There is a schrader valve in the fuel line. At this point fuel pressure can be checked. Pressure is always present. This can be dangerous, even at low pressure. Hope this helps lbreen

Apr 22, 2009 | Ford Probe Cars & Trucks

2 Answers

1996 Camry 100 km stalling


You have one of two very common problems.
Number one may be a stuck open EGR valve
Number two would be a failing Idle Air Control valve (IAC).
Try this: Open the hood & locate the EGR valve, close to the firewall, behind the intake. Find & take with you a small hammer. The next time that it happens, open the hood & tap on the EGR valve. If it is sticking "open" the tapping may dislodge the carbon particles that are keeping it open.When the EGR valve is open, exhaust is getting into the intake at idle, and this will def stall out the car.
There is no repair to the IAC valve, it would need to be replaced if it is bad.
One of these two scenarios will cure your problem, I see it every day.

Oct 07, 2008 | 1994 Toyota Camry

1 Answer

1996 Grand Cherokee 4.0 Stalls


change the idle control valve located at intake manifold.

Sep 09, 2008 | 1996 Jeep Grand Cherokee

1 Answer

2002 Olds Bravada stalling after ABS light illuminates


computer relay in the power dist box ecm relay is what the chart says....

Jun 12, 2008 | 2002 Oldsmobile Bravada

Not finding what you are looking for?
1992 GMC Jimmy Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...