Question about Ford Edge

Open Question

Removing driver side door panel on 2007 ford edge

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 250 Answers

SOURCE: How to remove drivers door panel on a 2007 Nissan Tiida hatchback

The door handle has a c clip behinde it that you can not see.Goto a auto parts store and thay will have a cheep tool to help you.(you need a special tool for this. The WINDOW CRANK handle has a 'c-clip' behind it. The door opening handle trim is held in by either a screw behind a plastic flap that will pop out(behind the lever)or it is held in at four points by plastic tabs (two on top and two on the bottom)that can be undone carefully with a screwdriver or the like. When this plastic trim is removed the door panel should come off.
Be aware that there are plastic clips (back side of the panel) on the perimeter of the panel that hold it in as well.
the tweeter panel just pops out look on the bottom of the door for screws and around the door handle and you will have to pop your window and door lock controls out and the reflector on the door pops out and there is two screws there then al you have is the clips behind the door they make tools for it but a flat tip screwdriver will be fine just get the tip close to the clip and pull it out .
1. Remove window crank (it has a kind of 'bent wire' c-clamp, which holds it onto the window crank shaft). 

2. Pry upwards the top plastic cover to the arm rest (this is a plastic coated foam rubber piece, on which you rest your arm). 

3. Remover the two now visible screws which fasten the arm rest onto the door. 

4. Remove the one screw fastening the inside door handle. 

5. With a blunt tool, gently hit the inside door handle in a forward direction (towards the door hinge). This will release the door handle from the door. 

6. Pry between the door panel and the door, to unsnap the snaps holding the door panel in place. 

7. Finally, lift door panel out and up to remove it from door. 

Posted on Feb 09, 2009

  • 2 Answers

SOURCE: removing door panel in 2000 toyota corolla

remove phillips scew and the door handle. remove padded arm rest on the door by lifting it up, and remove 2 screws. You can use a panel tool to remove the plastic toggle like pins holding the panel border in. Be as gentle as possible they may break due to becoming brittle.

Posted on Apr 06, 2009

  • 119 Answers

SOURCE: want to remove driver side door panel to gain access to power window motor

first remove the tweeter speker if equipped this comes off easily by gently prying from behind, then remove the small panel behind pull handle you"ll find a screw behind it\remove that,the next part is a little tricky the door grip needs to come off to achieve this place a small flat screwdriver at the top of the handle and pry forward the turn handle counterclockwise and this will release it from the clips you"ll then find 2 screws one at the top other at the bottom of door grip remove those and then gently pry from the bottom of the door panel to release the retaining clips thats it

Posted on Jul 14, 2009

  • 1986 Answers

SOURCE: removing door panel drivers side to connect mirror wiring behind this panel

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

lilward5
  • 5 Answers

SOURCE: how to remove front driver side door panel (2000 ford expedition)

There is a triangular piece, at top corner, covering a screw behind the mirror. Remove that screw. Remove the piece that covers the handle and remove the screw holding the handle to the door. Look through, where door handle was and remove another screw just above where the handle was. This screw is holding the panel to the actual door. Pop the cover off for the automatic door locks and disconnect them. Lift the panel in an upward direction.

Posted on Nov 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater blows hot on passenger side and at same time blows colder on driver side. what can i do to fix this problem


if its equipped with the dual climate knobs where you can set the heat to suit yourself on either side, you have an actuator, or an actuator door hanging up that operates the drivers side vents.

Dec 04, 2010 | 2007 Ford Edge SEL Plus

1 Answer

I own a 2000 ford f-250 my driver side window was shattered so i took it into a mechanic and he replaced the window i havent used the truck much in the last 18 months because of other problems but i just...


Parts stores sell door panel removal tools. Just watch for hidden screws in the door panel. The passenger side motor is replaceable, just involves removing the door panel and removing the power motor. The regulator may need lubricated, I'd do the drivers side after you get the glass out.

Mar 06, 2010 | 2000 Ford F250 Super Duty Crew Cabs

2 Answers

I cant find the door code for my 2007 ford edge driver side door lock thanks ,eric


it under the sterring wheel by the fuse box is where i found mine its a 5 didget code

Feb 23, 2010 | 2007 Ford Edge SEL Plus

1 Answer

Cann't get door panal off of drivers side door on 1999 ford Expedition


Remove the screw covers from the arm rest and remove the screws. Use a one inch stiff putty knife and slide between the door and the door panel. Move it right or left until you hit the retaining clip. Gently pry the door panel upward until the clip releases. Repeat this all the way around the bottom & both sides. When all are released push the door panel upward releasing in from the edge of the window opening.

Feb 10, 2010 | 1999 Ford Expedition

2 Answers

Ford Edge 2009,driver door lock not operational with key/fab


sounds like the lock actuator is bad this is a two sided device that operates from both sides it is possible that one side is not making contact the way that it should be. you will have to take the door panel off and visually look to see what has happened. one side m,ay be broken.

Dec 28, 2009 | 1997 Ford Explorer AWD

1 Answer

I own a 2007 trailblzer The driver side


try removing panel and check for loose or worn contacts, or replace the panel cluster with a new unit or one from a junked unit in good condition if cost is a factor

Sep 27, 2009 | Chevrolet TrailBlazer Cars & Trucks

2 Answers

Driver's side power window


window could have come out of the track. You'll have to take the door panel to see for sure

Aug 23, 2009 | 2003 Pontiac Grand Am

3 Answers

CHANGE CODE ON KEYLESS ENTRY SYSTEM FORD EDGE


Yes you can program your own code by inputting the original code then hit the no. 2 button then input your own 5 digit code.

Mar 16, 2009 | 2007 Ford Edge SEL Plus

1 Answer

Ford ka window switches not working


Check for loose wiring connections behind the door panel on the offending side.

Nov 27, 2008 | 2007 Ford Edge SEL Plus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...