Question about 2008 Dodge Grand Caravan

1 Answer

ELCTRONIC THROTTLE CONTROL

WHERE IS THIS LOCATED?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Prodigy:

    An expert who has answered 500 questions.

  • Dodge Expert
  • 652 Answers

Throttle body under the hood

Posted on Nov 21, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

JjMy volvo1998s70idles rough when accelerated it run fine what could be the problem


could be either a coil pack not working properly, or mass air flow sensor, or could also be the throttle body. its elctronic

Mar 25, 2015 | 1998 Volvo S70

1 Answer

Get out of limp mode no codes


What make and model vehicle and year ? Any lights lit on dash , ETC , wrench light . any messages on driver information center , reduced power. does the vhicle have elctronic throttle control .Some automatic transmissons can have problems that cause a limp mode.Some modules set codes that you need a good scan tool to read them, not a cheap code reader. or do you just have a low power situation ? plugged catyalitic converter. maybe !

Jan 12, 2015 | Cars & Trucks

1 Answer

Where are idle control and throttle position sensors located on 2011 Dodge Avenger with a 2.4 engine?


under hood look where the throttle cable connects behind it u will see a black looking module thats the throttle sensor the idle control is located just to the rite toward the filter as the mass sensor is there too

Jun 05, 2014 | Cars & Trucks

2 Answers

Where is trottle control vavle sensor


The Idle air control or throttle positioning sensor is located right on the throttle. Follow the throttle pedal cable to the bracket which the sensor is located

Nov 10, 2013 | 2004 Chevrolet Venture Passanger

1 Answer

I have the idle control air valve but dont know where to locate it on theengine


The Idle Air Control IAC, is normally located in the throttle body along with the Throttle Position Sensor TPS. The throttle body houses the throttle plate which either has a cable or electric motor that responds to the gas pedal. It is located at the end of the air cleaner/air inlet sytem. Year and type of vehicle would help to better answer.

Jan 27, 2011 | Dodge Ram 1500 Cars & Trucks

1 Answer

JameshunnicuDoes a fuel injected engine still have an idle control sensor? Where would it be located?


no idle control sensor but it has both an IAC, idle air control valve and a T, throttle position sensor
both are located at the throttle body

Sep 17, 2010 | 1995 Nissan Maxima

1 Answer

I have a 2005 ford mustang and i am on a trip to arkansas.two different lights came on.one looked like a small wrench an the other was the check engine.the car cut off while we were running 65 on...


the wrench light means there is-or-was a problem with the elctronic throttle control.
the is no mechanical throttle cable on this engine, it is "fly by wire" so to speak.
ussually when this happens, the computer will not allow anything over idle until the next key cycle and if it sees the problem again, it will only allow idle.
a lot of times this is a throttle position sensor concern or even the thottle actuator itself.
make sure the air filter and housing is claen and secure, installed properly.
you can try to spray some choke cleaner in the thyottle body itself and possibly clean some carbon buts thats probably not it.
most likely you will need a new throttle body assembly..... it comes with a new throttle position sensor on it. good luck

Aug 09, 2010 | 2005 Ford Mustang

1 Answer

2005 chevrolet colorado, 82,000mls reduced power, replaced fuel filter, air filter, and replaced all bad fuses. after i replaced the 02 oxygen sensor fuse, it work a-ok, then after i went to the bar that...


Hello. this is normally a problem with the elctronic throttle control system. you will need to have the system scanned for trouble codes for proper diag

Apr 03, 2010 | 2008 Chevrolet Colorado 2WD

1 Answer

A/c fan not working on all speeds


Easy fix,there is a small electronic computer control that the blower motor runs through...can be mounted on the blower motor or under dash near floorboard,,,some of the circuits blow out and goes to failsafe mode and blows on one speed only...go to parts store and tell them whats happening and they should be able to tell you where its located...its a small elctronic circuit board,and should be under 50 bucks...hope this helps...Lee

Jul 30, 2009 | 2002 Chevrolet TrailBlazer

Not finding what you are looking for?
2008 Dodge Grand Caravan Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...