Question about 2003 GMC Envoy

1 Answer

The right front axel is lo0se at the transmission.can i take it out and still drive my 2003envoy

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 113 Answers

No it will need to be fixed. The Envoy was known for this problem and will need to go to a Trannie shop unless you are capable of doing repair yourself. Inside the case the bearing is shot. Either rebuild that one or get a good used one and swap it out

Posted on Nov 19, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What side of the car does the speed sensor mount on near the left front axel,RIGHT??


Depending on the vehicle it should be located on the passenger sided next to the transmission drive shaft, look for a plug with 2 wires going into a connector plug of some sort. wires usually come in blue and i believe black. In trucks I believe it is on the tail end of the transmission at the junction where the drive shaft meets up with the transmission. i hope that helps

Aug 07, 2015 | Cars & Trucks

1 Answer

Knocking noise


Probably a bad "CV" joint on one of the front axels. The CVs go bad every now and then and are not too expensive to fix. Any auto shop can/will do the repair. You will need a new axel for left or right front.

May 14, 2014 | Honda Civic Cars & Trucks

2 Answers

The drlive line goes into what part


The Drive Line is a general term that describes a variety of parts ...

Power starts with the engine ... power is transferred from the engine fly wheel through a clutch to the transmission ... through a series of gears to the 'tail shaft', the output of the transmission. The drive shaft inserts into the splines of the tail shaft. The shaft connects to the rear end where the power is divided between the rear tires through through a diferential. The axels connect to the diferential and deliver power to the hub towhich the tire is attached..

that is unless your car happens to be a front wheel drive ... which I dont think yours is.

Jun 13, 2010 | 1990 GMC Sierra

1 Answer

1993 Dodge Grand Caravan Transmission issue


A broken engine or tranny mount should not cause a front wheel to wobble. If this is happening with a grinding noise I'd expect more of a failing bearing or such. The grinding noise may also be a rotor of the brakes with poor pads. Yes, if a axel, or CV joint, is failing this can make noise too, often times a "clicking" type of noise. Best get the front of the van up on jack stands, remove the tires and inspect all of the front-end components; pay special attention CV joints, rotors and front axel area, loose movement in the axels?
I hope this may have helped,
Tom

Apr 16, 2010 | 1993 Dodge Caravan

1 Answer

1992 chevy k2500 4 wheel drive not engaging. was driving in 4 high with no problems. shut truck off and no 4wd. no lights and no 4wd. new rear end, new transmission.


I have a 19934x4 bought it with 4 wheel drive notworking. indicator lights for 4x4 would notlight up but transfer seemed to be shiftin ok. frontaxel woul ot ingauge. I repled the front axel actuator an works fine now no problem. actuator is on the passenger sid back of the front axel pigand has a plug, mine was 2 wireroundpin plug but some have a flat pin 4 wire plug. 70 dollars at NAPA. wasa realy simple replacement didnt even need to jack up the truck. the actuator h a pin that electronically puses out engauging te front axel. a easy test is to put the truck in 4 wheel high. holdthe brak and givei little gas ad havesomeoneelse stand to the side ofthe front of the truck and see if the front axel spins. ifso th actutor is te most likely prblem. hope this helps.

Dec 11, 2009 | 1993 Chevrolet K2500

1 Answer

Leaking transmission oil from the back of the gearbox and front axel on ford falcon 1991 eb wagon,post diagram of auto transmission box


YOU carnt have a transmission oil leak from the front axle on a Falcon as they are Rear wheel drive but could be the hose going to the radiator over the front end leaking But the rear end of G/Box should be only the OIL SEAL.

Sep 19, 2009 | Ford F Cars & Trucks

1 Answer

4 wheel drive light is on in my jeep


vacumn pod on the front axel is stuck on. Jack up the front wheels spin both tires at the same time and see if the front drive shaft turns. If it does the 4x4 on the axel is engaged. The front drive shaft on these should not turn when vacumn pod is disengaged. YJ's have a split axel on the right side inner axel shaft.

Apr 10, 2009 | 1992 Jeep Wrangler

1 Answer

My computer says to service the 4 wheel drive switch. Is this the switch that is supposed to disengage the power going to the front axle when I do not need it?


its your acuator on your front axel, it probley just not engaging right look at the wires to your transfer case and to your transmission make sure there in good shape

Mar 23, 2009 | 1996 Jeep Grand Cherokee

1 Answer

1998 pontiac gtp ,


remove the right side wheel
seperate the ball joint
you may have to remove the stablizer bar link
remove the drive axle nut 32mm or 1 5/16
slide the front of the axle back through the hub bearing
then pop the axle out of the transmission
then install your new axle and reassemble

Jul 17, 2008 | 1999 Pontiac Grand Prix

Not finding what you are looking for?
2003 GMC Envoy Logo

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...