Question about Cars & Trucks
Would start by checking all fuses then check to see if the cars fuel pump is dead. Unplug the air boot from air filter housing, spray a bit of starting fluid or carb cleaner. If car wants to start with spray I'd be looking at the fuel pump. If no change check to see if motor has spark. Pull a wire ground it out on something that's metal and crank, spark should jump to metal (ground).
Posted on Nov 17, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1994 Chevy Lumina Van
if you put some start stuff like you say and start if our gas pressure good the injector dont open first do you have a check engine light when you put the key on if no check computer fuses (ECM) check it out pierre
Posted on Jul 30, 2008
SOURCE: Engine will die
There is a Communication problem between the Transmission Control Module (TCM) and the Engine control module. That is the bad news and is why it's shutting down the engine.
The good news is i believe there is a TSB recall on the 2004 - 2007 chevy aveo for the P0700 problem so it should be covered under warranty.
Believe the TSB# 05-06-01-030D
Good luck and hope this helps and hope it's not a bad ECM. Check the wire harness to the ECM and TCM, look for broken wire or the harness it self gone apart.
Posted on May 24, 2009
If it was a stock rebuild the original PCM settings should be fine check all the fuses and wiring possibly something was damaged or left loose this stuff happens to the best of us.next the SES light needs to be reset with a scan tool make sure to record all codes stored in the computer as this will aid in diagnosing any problems. the car must be ran thru a drive cycle usually normal driving conditions of say a mix of city and highway driving until the PCM relearns all parameters like o2 sensors emissions sensors ect... this can also be checked with the scan tool in the readiness moniters these monitors will be reset every time the SES light is reset. when pumping the gas pedal 3 time you are just resetting the maintenance light.
Posted on Aug 03, 2009
Tips for a great answer:
Jun 09, 2017 | Cars & Trucks
Oct 09, 2014 | Cars & Trucks
Aug 08, 2011 | 1997 Chevrolet Lumina
May 27, 2011 | Chevrolet Lumina Cars & Trucks
Apr 14, 2010 | 1997 Chevrolet Lumina
Dec 26, 2009 | 1997 Chevrolet Lumina
Oct 07, 2009 | 1992 Chevrolet Lumina
Apr 10, 2009 | 1997 Chevrolet Lumina
Mar 02, 2009 | 1997 Chevrolet Blazer
66 people viewed this question
Usually answered in minutes!