Question about 2011 Mahindra Scorpio

1 Answer

Pcm ign fuse

Dont. start

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

Left side under glowbox

Posted on Jun 19, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for the brain on a 99 chevy malibu


there are three fuse's for the ( pcm ) powertrain control module ! engine brain ! two are in the under hood fuse/relay junction block.
it is marked pcm / batt. fuse.10 amp. the other is pcm / ign fuse 10 amp. and then there is one in the let hand instrument panel fuse box. open the driver door at the end of the dash pull off end panel, fuse box behind there. fuse is marked pcm / acc 10amp .

now what is the problem your having ? i can help !

Jan 21, 2015 | 1999 Chevrolet Malibu

1 Answer

AVALANCHE 2003 WON'T START NO SPARK


Yes, it can be a fuse. Check the 15amp INJ1 fuse under the hood. Also check the IGN 0, PCM 1 and PCM B fuses.

0996b43f80241071-u0kuvkt5l3li3mon0hn4cwhe-1-0.gif

Aug 01, 2017 | Cars & Trucks

1 Answer

1999 Gmc Sierra 4.8L cranks/No Start Using snap-on Solus Scanner. I followed basic diagnostics: Checked fuses- good Pulled PCM and BCM codes- none No spark and no fuel. No ignition power to fuel...


Did you check your CKP and CMP power wires for a short to ground? Short to ground up stream might be pulling the voltage low from the PCM. Also.. have you pulled up the underhood fuse block just to see if there's any rodent damage to the wiring under there? That's a pretty common spot for rodents to cause problems.

Oct 03, 2013 | Cars & Trucks

1 Answer

Won't start.


ck the ign. switch

Jun 09, 2012 | 1999 Oldsmobile Silhouette

1 Answer

2000 t/c 3.8 turns over no spark new cam,crank sensor coil pak and computer 126000 mi


If the dealer did the work then they most likley checked the ASD relay which powers the fuel and ign. Also you should make sure you are getting a consistant signal from the crank sensor. If not the magnet may of broke inside the cover. Also you should have a ign fuse or PCM fuse. Also you may of lost your computer ground. Add a new one to verify. Make sure you have 12v on the hot pcm wire.

May 11, 2010 | 2000 Chrysler Town & Country

2 Answers

I dont have fire coming from coil pack and my truck wont start. I just replaced the coil pack a few times and they all did the same thing. I also replaced the distributor cap and rotor and wire plugs. What...


so spark either points to the PCM or the crank sensor. Providing you have checked fuses and if you havea ECM or IGN fuse and they check out good.

Mar 27, 2010 | 1993 Chevrolet K1500

1 Answer

Has no spark


well the easy answer is 20A ign fuse under the hood

however, lets check a few other things
1.) when you are cranking the vehicle is the check engine light on? If it is then this means that the PCM is not seeing the CKP... start searching for a loose connection at the CKP
2.) next swap the PCM power relay with the fuel pump relay and see if you get spark...if the relay is bad your vehicle still will not start because the bad fuse is now the fuel pump relay


Mar 24, 2010 | 1996 Lincoln Mark VIII

1 Answer

No power to ignition 96 camero dl


Check the wires to the distributer or to the modules could be poor or no conection. If you can turn the car over but no spark it's probably something to do with ignition, distributer, module, or wiring to the ignition.

Dec 28, 2008 | 1996 Chevrolet Camaro

Not finding what you are looking for?
2011 Mahindra Scorpio Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mahindra Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

sachin sharma
sachin sharma

Level 2 Expert

171 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Mahindra Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...