The turn signals on my ford exploer don't work

SOURCE: No turn signals, hazards or brake lights

replace the turn signal switch in the steering column

SOURCE: Hazard Lights Won't Work on 96 Taurus

FIRST Check for Blown Fuse Then Locate Flasher Units @ Fuse Block to Determine Wiitch one is Hazard Turn On Key Then Turn Syg. Feel Flashers The One you feel Clicking is For Turn The Other IS Flasher Replace this Flasher unit.

1. Verify the customer's concern by operating the turn signal/hazard flasher lamp to duplicate the condition.
2. Inspect to determine if one of the electrical concerns apply: VISUAL INSPECTION CHART Electrical

• Circuitry open/shorted.
• Fuse junction panel Fuse:

• Damaged multi-function switch.
• Miniature bulb burned out.
• Damaged lamp.

1. If the inspection reveals obvious concern(s) that can be readily identified, service as required.
2. If the concern(s) remains after the inspection, determine the symptom(s) and go to the Symptom Chart. See: ProceduresSymptom Chart(s)

SOURCE: My hazard lights work but the turn signals wont

There are actually 2 flashers for you car. One for the T/S's, and one for your hazards. I actually just replaced the T/S one on my wifes car a few months ago. It is on the right hand side of the steering wheel inside the dash, about level with the radio.

SOURCE: 2001 jeep Tj pdc diagram trying to locate fuse for

sounds like it is either flasher or switch assembly.

SOURCE: 99 Chevy Tahoe... Rear turn signals, brake lights, and hazards

I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!