Washer fluid for windshield wipers stop working on 2002 pontic grand prix

The washer bottle reservoir is only partly visible located on top of your battery box...the top cap should still have the illustration of the wiper symbol...most of the bottle is not visible hidden by the battery...Hope this helps.

Check the wires at the pump for power.

lil piece of dirt in the sprayer, might be able to take a needle and poke it some and get it un stopped..

Hello, you'll will need to remove wiper motor crouling to get the wiper motor. There will be two rods attached to the wiper motor. Now, this arms operate the wipers on your auto wind shield.
One of the arms have came loose from it ball joint. GB....stewbison

If you have just changed the wiper arms, they may not have been reinstalled correctly.....hoever if it has just started happening,,,,,???

unfortunately this is a wiper motor fault....not the switch.......inside the motor is a PARK function.....this is where the wipers will stop after doing a swipe across the windscreen and the switch is turned off.........this park function is a section inside the motor that cannot be removed and replaced internally, and it would cost more than just a replacement wiper motor

Good luck and i hope this helps...
Please vote if you liked this response

Anti freeze check for leaks from your hoses and radiator.

While the wipers are in the parked state, just loosen off (or remove) the wiper arm from the drive spigot and re-position the driverside wiper arm to the correct position.
Re-tighten arm drive mount and all should be well.

There is a switch to adjust them, but i haven't noticed a major difference. Its located on the wiper control blade.

When mine stopped working it was the washer motor easy to fix. right at the bottom of the tank ..Put somthing under it to catch the fluid and it just pulls out . unplug and replace. Danny

The fuse to your washer pump is shared with the wipers themselves. If your wipers work, then your pump should. I just had the same problem. You can replace the washer pump for $20. It's located behind the front passenger's side wheel well. Just remove the passenger wheel and wheel well covering to access the washer tank, and the motor. The pump pulls off, after removing the electrical plug and fluid line. When you pull the old pump out, the washer fluid will gush out. If you want to save any of this fluid, you may want to find a cloth or something to stop the flow. The new pumps snaps in quit easily.