Fuel line replacement for 1997 saab 900

SOURCE: 900 Saab V6 extended cranking time

Hi, have you checked or replaced the oxygen sensors?

SOURCE: rough idle on 1990 saab 900 convertible, 16V

Because the car has adaptive technology, it may take a while to reset and adjust to the new, cleaner and better conditions than those to which it had previously adapted.

Did you change the cap and rotor? if the plugs needed replacement, likely they do too

Possible other causes include:

loose or corroded connections to any electrical component you disturbed (make a checklist and tick them all off as you check them);

mis-reinstallation of any F.I. part disturbed(checklist again)

obstructed water flow through the AIC valve;

improper voltage output from the AIC valve (for LH 2.4 systems, should output 8 volt at idle, dropping as load increases; for LH 2.4.2 system output 7 volt at idle etc; testing between terminals)33 and 17 at disconnected LH connector;

possible problem with MAF.

Hope this helps

Saabreur

SOURCE: 94 saab v6 serp belt replacement. does motor mount

Yes, the motor mount must come off to replace the serpentine belt on the 3.0 6 cylinder motors. Not as daunting a task as it may seem, just requires a jack and block of wood under the oil pan to support the motor.

SOURCE: do I have to drop the gas tank to replace the fuel

Hello gary_stev816: My name is Roger and I will answer your question for you. Yes to remove the fuel pump you will need to drop the fuel tank. Please use caution when doing this. Make sure you do not make any sparks. Please rate the answer you received. This is our way of tracking your answer helped. Should you need further help please just ask. Thank You for using Fix Ya. Roger

SOURCE: Saab 900 will not turn over, starter motor has been replaced.help

at least your problem is simple if all light turn on when you turn key and car dont start on the saab there is a 99% chance your fuel pump is bad replace that and enjoy your ride.