The lamp into the case between seats (Z4 2006) always still open, except when I lock the car for the night. At that time the case locks, the lamp turn off and the alarm turn on (red light flash). Wath can I do to turn off that light when I drive ? Another one, my exterior mirrors don't work correctly, I can move them left, up and down but not on the right. Is it an electrical or mechanical problem ? Thank You, Jean Boutin

Body Control Module (BCM)
Below the left side of the I/P to the left of the steering column.
Has three connectors.connector #1 52-Way F AMP Hybrid (BK) Body Control Module (BCM) C1 Pin
Wire Color
Circuit No.
Function
1
TN
860
Front Windshield Wiper Switch High Signal
2
WH
1459
Security System Sensor Supply Voltage
3
PK
1439
Ignition 1 Voltage
4
TN
28
Horn Relay Control
5
OG
300
Run Relay Control
6
TN
707
RAP Relay Coil Control
7
TN/WH
1969
Headlamp High Beam Relay Control
8
--
--
Not Used
9
PK/WH
1970
Headlamp Low Beam Relay Control
10
WH
1080
Park Lamp Relay Control
11
YE
749
Security Indicator Control
12
GY
91
Windshield Wiper Switch Signal 2
13
YE
196
Windshield Wiper Motor Park Switch Signal
14
TN
1835
Low Reference
15
L-GN/BK
1137
DRL Ambient Light Sensor Signal
16
YE
5066
Brake Pedal Position Sensor Signal
17
BK/WH
1651
Ground
18
--
--
Not Used
19
BK/WH
151
Ground
20
BK/WH
1651
Ground
21
YE
5
Crank Voltage
22
PK
1239
Ignition 1 Voltage
23
BN
1141
Accessory Voltage
24
--
--
Not Used
25
WH/BK
644
12-Volt Reference
26
PK/BK
109
Hood Ajar Switch Signal
27
OG
5688
10-Volt Reference
28
GY/BK
5689
Low Reference
29
BN/WH
230
Low Reference
30
PK
1444
I/P Dimming Control
31
OG/WH
812
I/P Dimming Voltage
32
--
--
Not Used
33
BN
5077
Low Reference
34
BN/WH
1571
Traction Control Switch Signal
35
GY/BK
1598
Courtesy Lamps Switch Off Signal
36
PK/BK
1597
Courtesy Lamps Switch On Signal
37
TN/WH
1455
Keyless Entry Signal
38
L-GN
1037
Class 2 Serial Data
39
L-GN
526
Stop Lamp Supply Voltage
40
L-GN
80
Key In Ignition Switch Signal
41
L-BU/WH
1314
Left Front Turn Signal Lamp Supply Voltage
42
D-BU/WH
1315
Right Front Turn Signal Lamp Supply Voltage
43
GY/BK
690
Courtesy Lamp High Control
44
OG
1732
Inadvertent Power Courtesy Lamp
45
--
--
Not Used
46
RD/WH
340
Battery Positive Voltage
47
OG
228
Windshield Washer Pump Control
48
GY
8
Instrument Panel Lamp Supply Voltage
49
D-GN/WH
1135
A/T Shift Lock Control Solenoid Control (w/o AQW)
GN/WH
1135
A/T Shift Lock Control Solenoid Control (AQW)
50
RD/WH
240
Battery Positive Voltage
51
RD/WH
2440
Battery Positive Voltage
52
RD/WH
1240
Battery Positive Voltage
Connector #2 52-Way F Receptacle 0.64, 2.8 (BK) Release Tool/Test Probe: 12094429/J-35616-4A
Body Control Module (BCM) C2 Pin
Wire Color
Circuit No.
Function
1
--
--
Not Used
2
OG/BK
780
Driver Door Lock Switch Lock Signal
3
D-GN
5512
Liftgate Open Switch Signal
4
D-BU
245
Passenger Door Lock Switch Unlock Signal
5
L-GN/BK
748
Right Rear Door Ajar Switch Signal
6
YE/BK
1181
Right Rear Door Open Switch Signal
7
L-BU/BK
747
Left Rear Door Ajar Switch Signal
8
L-GN
1177
Right Front Door Open Switch Signal
9
L-BU
1134
Park Brake Switch Signal
10
L-BU
2380
Rear Parking Assist Chime Signal (UD7)
11
OG/BK
781
Driver Door Lock Switch Unlock Signal
12-15
--
--
Not Used
16
WH
193
Rear Defog Relay Control
17
TN/WH
746
Right Front Door Ajar Switch Signal
18
D-BU/WH
1179
Left Rear Door Open Switch Signal
19-21
--
--
Not Used
22
L-GN
1123
Door Lock Key Switch Lock Signal
23
WH
5075
Current Sensor Signal
24
PU
1124
Door Lock Key Switch Unlock Signal
25
TN
126
Left Front Door Open Switch Signal
26
GY/BK
745
Left Front Door Ajar Switch Signal
27-29
--
--
Not Used
30
WH
17
Stop Lamp Supply Voltage
31
L-BU
244
Passenger Door Lock Switch Lock Signal
32-33
--
--
Not Used
34
PK/BK
1303
Liftgate Ajar Switch Signal (Early Production)
35
YE
2080
Low Reference
36
PK
2435
Low Reference
37
YE/BK
2079
Driver Heated Seat Cushion Temperature Sensor Signal
38
GY
2434
Passenger Heated Seat Cushion Temperature Sensor Signal
39
TN/WH
2430
Passenger Heated Seat Relay Control
40
PU
2477
Driver Heated Seat Relay Control
41
--
--
Not Used
42
L-GN
24
Backup Lamp Supply Voltage
43
YE
18
Left Rear Stop/Turn Lamp Supply Voltage
YE
18
Left Rear Stop/Turn Lamp Supply Voltage
44
GY
8
Instrument Panel Lamp Supply Voltage
45
L-GN
275
Park/Neutral Position Park Signal (E58 w/o AQW)
L-GN
275
Park/Neutral Position Park Signal (E59 w/o AQW)
L-GN
275
Park/Neutral Position Park Signal (AQW)
46
TN
694
Driver Door Lock Actuator Unlock Control
47
--
--
Not Used
48
D-GN
19
Right Rear Stop/Turn Lamp Supply Voltage
D-GN
19
Right Rear Stop/Turn Lamp Supply Voltage
49
RD/WH
440
Battery Positive Voltage
50
BK
550
Ground
51
TN
294
Door Lock Actuator Unlock Control
52
GY
295
Door Lock Actuator Lock Control

Your best bet , take it to a qualified repair shop .
SMART ENTRANCE CONTROL UNIT PFP:28596 Description EKS003A2 OUTLINE The smart entrance control unit totally controls the following body electrical system operations. ? Warning chime ? Rear window defogger and door mirror defogger ? Power door locks ? Remote keyless entry system ? Vehicle security system ? Interior lamp ? Battery saver control BATTERY SAVER CONTROL Interior Lamp/Map Lamp/Vanity Lamps The lamps turn off automatically when the interior lamp, map lamp or/and vanity lamps are illuminated with the ignition key in the OFF position, if the lamp remains lit by the door switch open signal or if the lamp switch is in the ON position for approximately 10 minutes. After lamps are turned off by the battery saver system, the lamps illuminate again when: ? Driver's door is locked or unlocked, ? Door is opened or closed, ? Key is inserted into or removed from the ignition key cylinder. Rear Window Defogger/Door Mirror Defogger Rear window defogger and door mirror defogger are turned off approximately 15 minutes after the rear window defogger switch is turned on. INPUT/OUTPUT

Warning chime Key switch (Insert) Ignition switch (ON) Lighting switch (1st or 2nd) Seat belt buckle switch LH Front door switch LH Warning chime (located in smart entrance control unit)

Nothing for you to remove ! Without a factory scan tool U can do nothing .
TIME CONTROL UNIT PFP:28491 Description (Without Power Door Locks) EKS003A6 OUTLINE The time control unit totally controls the following body electrical system operations. ? Warning chime ? Rear window defogger INPUT/OUTPUT System Input Output Warning chime Key switch (Insert) Ignition switch (ON) Lighting switch (1st or 2nd) Seat belt buckle switch LH Front door switch LH Warning chime (located in time control unit) Rear window defogger Ignition switch (ON) Rear window defogger switch Rear window defogger relay

SMART ENTRANCE CONTROL UNIT PFP:28596 Description EKS003A2 OUTLINE The smart entrance control unit totally controls the following body electrical system operations. ? Warning chime ? Rear window defogger and door mirror defogger ? Power door locks ? Remote keyless entry system ? Vehicle security system ? Interior lamp ? Battery saver control BATTERY SAVER CONTROL Interior Lamp/Map Lamp/Vanity Lamps The lamps turn off automatically when the interior lamp, map lamp or/and vanity lamps are illuminated with the ignition key in the OFF position, if the lamp remains lit by the door switch open signal or if the lamp switch is in the ON position for approximately 10 minutes. After lamps are turned off by the battery saver system, the lamps illuminate again when: ? Driver's door is locked or unlocked, ? Door is opened or closed, ? Key is inserted into or removed from the ignition key cylinder. Rear Window Defogger/Door Mirror Defogger Rear window defogger and door mirror defogger are turned off approximately 15 minutes after the rear window defogger switch is turned on.

Warning chime Key switch (Insert) Ignition switch (ON) Lighting switch (1st or 2nd) Seat belt buckle switch LH Front door switch LH Warning chime (located in smart entrance control unit)

Does it have power locks ?

TIME CONTROL UNIT PFP:28491 Description (Without Power Door Locks) EKS003A6 OUTLINE The time control unit totally controls the following body electrical system operations. ? Warning chime ? Rear window defogger INPUT/OUTPUT System Input Output Warning chime Key switch (Insert) Ignition switch (ON) Lighting switch (1st or 2nd) Seat belt buckle switch LH Front door switch LH Warning chime (located in time control unit) Rear window defogger Ignition switch (ON) Rear window defogger switch Rear window defogger relay

Sorry I am not familiar with the model.

Most cars of 2013 vintage use an electric release for the boot or tailgate and often there is no other type of release. If this is the case it is worth checking the vehicle handbook for the possibility of an emergency release.

When the electric release doesn't work, depending on the level of sophistication of the system, it could be a fuse, faulty wiring, faulty release button or switch or a faulty lock release motor or solenoid. It is unlikely the lock is faulty.

The last time I encountered a non-opening boot I had to remove the rear seat and wriggle into the boot and remove the boot lid trim panel and locate the wiring in order to connect an independent 12 volt supply direct to the lock solenoid. Once the boot was open it was a simple matter to replace the switch.

The previous time was similar except the problem was a worn lock and the time before the wiring had broken inside the harness where it jumped from the body to the tailgate.

rough usage of door handle bends internal mechainism,you will need to remove door panel iside car and replace door opening mechanism or repair it

Sounds like a problem with a door sensor or the body control module. The body computer takes signals from the doors and activates the horn in the case of theft. It also powers the door locks.
You may be able to pull the fuse for the bcm but that could cause more problems when you go to start the truck.

get remote checked wires might need re soldering or replace remote with new one. Cheapest place to purchase one is at a key cutting place or lock retailer.

Instrument Panel Fuse Block
The instrument panel fuse block access door is
located on the driver side edge of the instrument panel.

Pull off the cover to access the fuse block.

The vehicle may not use all of the fuses shown.

Fuses Usage
1 Rear Seats
2 Rear Accessory Power Outlet
3 Steering Wheel Controls Back light
4 Driver Door Module
5 Dome Lamps, Driver Side Turn Signal
6 Driver Side Turn Signal, Stop lamp
7 Instrument Panel Back Lighting
8 Passenger Side Turn Signal, Stop lamp
9 Passenger Door Module, Driver Unlock
10 Power Door Lock 2 (Unlock Feature)
11 Power Door Lock 2 (Lock Feature)
12 Stop lamps, Centre High Mounted Stop lamp
13 Rear Climate Controls
14 Power Mirror
15 Body Control Module (BCM)
16 Accessory Power Outlets
17 Interior Lamps
18 Power Door Lock 1 (Unlock Feature)
19 Rear Seat Entertainment
20 Ultrasonic Rear Parking Assist, Power Liftgate
21 Power Door Lock 1 (Lock Feature)
22 Driver Information Centre (DIC)
23 Rear Wiper
24 Cooled Seats
25 Driver Seat Module, Remote Key less Entry System
26 Driver Power Door Lock (Unlock Feature)

I can't be of much help, except to indicate what Honda says about the seats, and to give you a URL to look at:
Using a Seat Belt Locking Clip
Always use a seat belt locking clip when you secure a child seat to your car with a lap/shoulder belt. This helps prevent the seat from shifting position or overturning. A locking clip is usually included with the child seat. If you need a clip, contact the seat's manufacturer or a store that sells child restraints.
The URL will take you to a more complete reference to your car manual regarding child restraints.
https://techinfo.honda.com/rjanisis/pubs/om/AC9595/AC9595O00020A.pdf
Hope this helps you.

check to see if the door sensor, is damaged, telling th computer when the door is closed