SOURCE: 2001 hyundai elantra knock sensor
yes sir, the knock sensor is located on the side of the engine block, the side closest to the firewall. it is just a small circular object with a wire connector and one bolt
SOURCE: 2001 saturn sc2 gets code 341&340 camshaft sensor
if you have high resistance in secondary ign. system (plug wires, ign.coil) this will cause this code to set. make sure you are using a high quality spark plug wire set. not from autozone!!! and denso non platinum tipped spark plugs. also use a diaelectric grease on plug wires to keep moisture out.
SOURCE: Code: P0133 - O2 Sensor Circuit Slow Response Bank 1 Sensor 1
is this a 4 or 6 cylinder?
if a 4 cylinder it will only have 2 o2 sensors
V6 will have 4 o2 senors which the sensor will be the right side of the engine first sensor.
1st sensor on exhaust, I recommend if you change one change all, as this will make the computer when it rechecks the system you have all clean/fast responding sensors.
if you have a slow response it means the sensor is dirty and not reading well, which is usually caused by minor misfires that the engine computer dismisses, so a tune up would be recommended too.
SOURCE: I need to replace the
The flasher for your turn signals is actually the hazzard switch on the dash with the red triangle.It is the hazzard swicth as well as the flasher relay!! Hope this helps
SOURCE: locating camshaft positioning sensor on 2000 Daewoo Laganza
hi,
it is under the upper timing belt cover between the camshaft gears.
According to the manual touching anything related to timing belt
requires removing million parts including right front wheel. I suspect
this might be an overkill just to remove upper timing belt cover.
So my advice would be to get it done by some mechanic as u will not be able to do it and may damage other parts also.
Thanks!
Sandy
121 views
Usually answered in minutes!
×