2000 Nissan/Datsun Truck Quest Mini Van 3.3L SFI 6cyl
Flashers
Print
The turn signal/hazard lamp flasher is located behind the driver's side of the instrument panel to the right of the steering column.on the fuse block
REPLACEMENT
SOURCE: Turn signal light flasher unit
Remove the dash cover that has the fuse cover dorr on it (2 screws). Then remove the metal bracket ubder this panel (4 screws). Look up on the side next to center console.Next to a blue box is the flasher. Know if someone can figure out how to remove flasher let me know.
SOURCE: 2000 quest speedometer not working
Most common is the speedometer, for you speedometer issue. As for your radio display. If the radio works but has no display, then it's a radio problem not a fuse.
Thanks Jay!
SOURCE: where is the flasher relay for an 01 Nissan Quest
M11 location near left side of steering wheel near the middle of the column
Combination Flasher unit.
3 wire Color
Orange
Purple
Red
let me know
SOURCE: Location of Turn signal flasher for 95 Nissan 4wd 4cyl MT
Found it!! - It is indeed under the dash, directly above the clutch pedal arm and attached to the brake support bracket. The original one was black and NOT round. It's about 1.5 inches long and 1 inch square. The three wires drop down out of the bottom and there is a connector release you have to push to release the wires. The flasher relay itself can slide off the mounting point, with a little extra pressure, pushing towards the left side (outward) of the truck. (left hand drive models).
SOURCE: 1997 nissan quest camshaft sensor where is it & how to replace it
The camshaft sensor is located inside the distributor and is part of it, in order to replace it you must replace the distributor,to replace remove the dist cap. mark the location of the rotor,by marking where its pointing to, then mark the dist housing, so now theres a mark on the rotor and housing to show where rotor points, next mark the location of dist going into housing, mark the shaft and the block,because it spins in block this way you can line back up.next remove hold down bolt and pull out,mark the new dist in exacat same spots as the old so you can install back the same,you may have to put it in and pull it out until your marks are lined up,this way the timing will be dead on, when done you can check timing. good luck
1,136 views
Usually answered in minutes!
×