What you have is a bugga-boo-something is shorting out or corroded-so what this does is to confuse the main cpu that controls the lights-check the light sockets for corrosion-check your wire harness for wires that are rubbed bare or broken- pinched-start with the lighting wires -unfortunately this problem that is confusing the cpu could be any where in the wiring harness-cheers Denny
SOURCE: abs on dashboard stays lit all the time.
The only way to know axactly what happen is with a diagnostic computer.
Because the ABS use a Speed sensor on each of the wheels.
Hydraulic selenoids on the ABS box or Module..
If the light is on. its mean the Anti Lock Brake System is inactive., You gonna brake like any car with no ABS.
I hope this information work for you.
SOURCE: installing a Nissan Sentra Passenger Side Manual Non Folding Mirror.
had to install a driver side non folding mirror, fairly simply to say the least. There's a cover on the interior of the door, near the window, remove the cover, remove the 3 screws, need i believe a 10mm socket. If a power window, unhook the circuit. Replace new mirror.
SOURCE: Nissan Sentra shifter lamp replacement
Transmission shift indicator light on center console.
First make sure the fuse is good.
If the fuse is good then remove the screws holding the center console cover. You will need a long and short phillip screwdriver. Look for screws in the cup holder, under the handbrake handle and where the console runs under the dash. You may have to move seats forward/backward to reach the screws. When you attempt to raise the console cover you will notice you overlook a screws. Remove them also. You may be able to reach the bulb without removing the gear shift handle. DO NOT TOUCH any other electronics you see. The AIRBAG ACTUATOR is located here also. Replace bulb. Test before reassembly. Good Saturday morning project.
SOURCE: brake light, 2008 Nissan Sentra
Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.
186 views
Usually answered in minutes!
×