At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Depends on if this is a 3.5L or 4.0L. The 4.0L is located on the driver side inside the water jacket. You will need a special tool to remove it - it is internal. Not too difficult of a job, and Autozone will rent the tool for free.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Aug 13, 2008 - aurora.................good luck. if u got the "short star" (3.5 dohc v6) good luck. if u got the 4.0........even better luck. happy trails. TonWon · 8 years ...
? 0:46 https://www.youtube.com/watch?v=5mjg_Ps1Ctg
Dec 13, 2012 - Uploaded by Brendan Doyle
Aurora 4.0 Exhaust Leak and Water Pump Whine. Brendan Doyle ... How to Install a Waterpump on a Cadillac Northstar engine. ...How to access spark plugs on a 2001 Oldsmobile Aurora 3.5L Engine - Duration: 3:19. Dennis ...
Oldsmobile Workshop Manuals > Engine, Cooling and Exhaust > Cooling System ...Aurora V6-214 3.5L VIN H SFI (2001) ... Install the new water pump gasket.
Mar 4, 2013 - 4.0? It's not that hard to replace but you need a special socket to changeit ... The starter motor sits in the "valley" between the two bank of cylinders ...
first there is a low coolant sensor in the over flow bottle,and the other is that you have a common GM motor problem. all GM cars and trucks have a intake manifold gasket leak
Look on the drivers side of the engine. You will see a small belt running off a pulley of the back of the front head. That is the water pump belt. The water pump is being the housing with the hose attached to it. You will need a special tool to remove the pump from the housing.
you might have a leak in the rear suspension load leveler. check connections with soapy water. locate where sound is coming from. fuel pump in tank is a slight hum and not that noticable, but the air comp for load leveler is. Also spray around rubber boots on shocks, also check load leveler switch on axle to frame for broken or loose lever control.
Hi, i would check the thermostat first unless the water pump is leaking
as the water pump is where the timing belt is is the timing belt needs
removing to get to the pump, take the thermostat out and place it in a
tub of boiling water and check if it opens up if it dont then it will
need replacing.
you need to bare in mind that it could also be head gasket failure so
make sure you get this tested if the thermostat is found to be in
working order.
IF YOU HAVE THE 4.0 ENGINE ROD BROKE PART OF WATER PUMP.YOU HAVE TO REPLACE WATER PUMP.YOU NEED TOOL J - 38816 TO REPLACE INSTALL AND REMOVE WATER PUMP.YOU CAN BUY TOOL AT ANY AUTO PARTS STORE.TORQUE FORWATER PUMP IS 73 FT LBS. TORQUE FOR WATER PUMP DRIVE BELT COVER IS 89 INCH POUNDS.
if you know for sure it is water. clean out the drain tube for the a/c. it's located by where the a/c lines go into the fire wall. it's a blacksoft rubber tube under the evaporator or coming out of the fire wall
the sensor is in the water jacket lower part of the engine block, u are lookin in the right place, u do need the car up so u can get to it from underneath, u can't see it from up top.
×