Hi,I think it would be a good idear to make shore all the lights and heaters ar
e turned off,then start the car and see if there is eney difference from when you turn the lights and heater on,if it is a little bit better when the lights and heater is off you could have a falty alternater.
best of luck hope this was some help.
SOURCE: My car stalls and doesn't
your car might have problem with Idling volve.I had the same problem and i got it rectified at dealers place.
SOURCE: 2002 sequioa sudden stall
Often when the battery is disconnected or replaced the computer will lose it's learned idle settings. You could try letting the engine idle in park until the engine temperature comes up to normal and leave it like that for a few minutes, then put the Air con on and let it idle again for a few minutes, then switch the air con off and put it into drive. If it does not stall, let it idle in drive for 2 minutes or so, and then do the same with the Air con on. This should relearn the base idle settings and stop it from stalling on you. Before you carry out this procedure you should make sure that when you replaced the battery you didn't remove any other plugs or knocked anything that may be causing the fault. If you try this procedure and it still stall when you select drive, you will need to get a Mechanic to check the vehicle over.
Hope this helps,
Mark.
SOURCE: engine light is on ,code P0171, hesitates when start driving
you will need a code reader to turn light off
SOURCE: 99 Toyota Corolla multiple misfire problem
This is what you need to do, change the plug wires, because if there is a bad wire you would definitely experiences sputter or a stutter, so do the plug wires and at the same time do the spark plugs, this should take care of your problem. if not let me know and i will give you the next step
Testimonial: "So far the car is working fine after I replaced the spark plugs and wires! Thanks so much!"
SOURCE: Check engine light is on; diagnostic code is
p2610 is engine contro module or ecu the cars main computer for both fuel injection and ignition,Remove the large block connector going to the ecu and spray both with contact cleaner,should sort it.
121 views
Usually answered in minutes!
×