SOURCE: 1990 toyota camry
Well if it is a 4 cylinder the timing marks would be small hole in camshaft lined up with little dot on head at 12 o'clock position and the crank with the pulley on should line up with 0 on the timing indicator. If it is a 6 cyl then the marks would be- camshafts both with dots up and lined up with indicaters on heads and crank timing mark on 0 with the harmonic balancer installed. Hope this helps.
SOURCE: How to remove ignition cylinder from Toyota Camry 1993
Here are step-by-step instructions for the removal and re-installation of your ignition cylinder on your Toyota. Hope this sheds some light on the subject and solves your problem. Have a great day!
CAUTIONSome
models covered by this guidemay be equipped with a Supplemental
Restraint System (SRS), which uses an air bag. Whenever working near
any of the SRS components, such as the impact sensors, the air bag
module, steering column and instrument panel, disable the SRS, as
described in .
On some vehicles, it may be necessary to remove the steering wheel and combination switch first.
To install:
SOURCE: Maintanance light on a 2007 Toyota Camry LE
Push and hold trip button on dash with key off, turn key on but don't start, odometer will clock down, when it is finished, lite will go off
SOURCE: 1993 Toyota Camry V6 Timing Settings
Get a T belt from toyota. It has 3 white lines on
it and and arrow mark. 2 lines are solid and one is broken. Put the
arrow facing away from the engine. The cam gears have a dot punched
into them near a certain tooth. This is where the solid white lines
will line up with. The crank gear will have a dot also. It will line up
at 90 degrees from the top, towards the front of the car. This is where
the broken line will match up with. With the belt installed with all
lines on their proper dots and arrow away from the engine, you valve
timming is correct.
Of course you need to remove and compress the tensioner also. I assume you know this already since you didn't ask.
SOURCE: how to replace a fuel pump to a 4 cyl 1993 camry
The fuel pump is located in the fuel tank and it can be reached by removing the back seat of the car.
be sure to get a fuel pump of the same rating with the one you are replacing.
Good luck.
211 views
Usually answered in minutes!
×