SOURCE: TCS, SLIP and ABS lights on
Check your brake fluid first. If that is low, top it off and recheck. If its ok, than you will need one of the rear ABS sensors. You will need to plug it in and find out which side it is. That's really the only ABS issue that car has. One of the rear ABS sensors fails.
SOURCE: tcs light come on along with abs an hand break light
You most likely knocked the electric plug loose when you changed the brakes, go back and make sure they are tight.
SOURCE: 2003 hyundai elantra gls abs/tcs light on
unless you can discover what DTC (Diagnostic Trouble Code) has been recorded/set in the control module, it's anyone's guess.
Testimonial: "thankyou"
SOURCE: Problem with ligh ABS and TCS ! What to do?
There are a lot of things that could cause this. We need to pull the codes in the ABS module to see what code(s) are setting and diagnose those codes. Check around the local auto part store to see if they can check ABS codes. Some might be able to check it for free.
Most of the time its one of the speed sensor or the harness to the sensor. Sometimes its the connection, where it hooks up under the body by the drivers side sliding door. There is a few connections there.
The one for the ABS is the 4 wire connection. Make sure that connector is clean and no corrosion or water is in there.
Hope this helps; also keep in mind that your feedback is important and I'll appreciate
your time and consideration if you leave some testimonial comment about
this answer.
Thank you for using Fixya, and have a nice day
37 views
Usually answered in minutes!
×