When my r125 starts its quiet,but after riding for about an hour it gets noisy like a clicking noise when you release the throttle ,was told its not valve lifter noise but either a noisy injector or fast idle solenoid!!! Can these parts realy make the bike noisy on deceleration ????

if it's not mechanical noise check your exhaust sheilds for loosness.

Are you sure the lug nuts aren't loose?

The oil may be to thick or a partially blocked pick up (check the sump for a big dent) Lack of oil changes will also cause it as the oil starts turning to sludge & partially blocking things. As the oil warms it gets thinner allowing it to pass around the motor easier. I DON'T recomend the oil flushes. The motor may have to be partially disasembled eg: sump off to clean pickup or tappet cover off to replace lifters etc... Start by changeing the oil & filter with the recomended grade.

Have you tried flushing the engine crank case? You may have sludge clogging the valve lifter oil pressure ports. Get a can of Berrymans brand Chemtool, add it to a cold engine crankcase oil and run it for 5 miles or so, then change the oil and see if the noise level improves. Some tapping noise on cold start is normal and not a sign of any problem. If the noise goes away in my opinion I'd just do the flush of the system and then leave it alone.

This is most likely a noisy lifter (or valve tappet). In cold weather, the clearances in the valve train open up because metal contracts due to the cold. Once the oil pressure comes up after start the noise goes away because the larger clearance fills with oil and the lifter becomes "cushioned" with the oil. The proper fix is to have the valves adjusted. I believe in your model, that is done by putting shims on the lifters. This will quiet the noisy lifters. In the short term, you can try using a lighter weight oil for cold weather. This will get the oil to the lifters faster after start up and quiet the tapping more quickly. Once the weather warms again, shift back to the normal weight.

how long ago were tyres fitted? if very recently take back to who fitted them

it is the pedal box that is creaking NOT the clutch,quiet a common "fault",spray silicon around the pedals should cure it...

yes they can be a bit noisy depends on teh tread pattern

all the 3.6 liter engine,outlook, aura, vue anything with a 3.6 liter engine has noisy steering,there is no fix,,,just noisy

I don't know why you would replace the bar itself unless it is damaged. There are bushings that the bar is mounted on that are fairly easy to replace. As well, links on the ends that tend to wear. Any auto parts store can sell you these fairly cheaply.