My drivers side bright headlight doesnt work, I replaced bulb and socket and it still doesn't work.
SOURCE: Driver side headlight bulbs burned out on 2003 VW Golf
There is a light cover in front of the battery... take this off and then look for the metal clamps holding the light housing in. (I say clamps, but they're more like glorified paper clips on either side of the fixture.) Press in on each side, pushing the clamps towards each other and pull the fixture out.
SOURCE: 2003 Mercury Sable headlight bulb replacement
This problem is now resolved, thanks to a prior post by sableowner.
http://www.fixya.com/cars/t1479995-2001_merc_sable_headlight_replacement
The 2003 Sable has the same headlight assembly and removal/replacement instructions as the 2001 Sable. Once I had this information in hand, bulb replacement was easy.
SOURCE: 2001 subaru outback headlight not working
chapmnfarm: your head lights use a "2" fuse system.
one for the left and one for the right.
The fuse box you are looking for is under the hood on the passenger's side. It is a black box roughly 8 inches long and 4-5 inches wide. When you remove the cover, you will see fuses and relays. What you are looking for is the section in the box which has a cluster of 7 fuses. 3 in one row and 4 in the other. On the outer parameter are two relays. The fuses you are interested in are located in the row of 4 fuses, with the two closest to the "L" shaped part of the box. Both of those should be 15 amp fuses.
The fuse below those should be a 20 amp which is the lighting switch and the one below it is a 15 amp which is for the interior lights and the clock.
Check your harness grounds in the engine compartment near the area you have the problem. There are ground wires which come out of the harness on both sides of the core support. The wires are black in color and have "EYES" crimped onto the ends of the wires. Both of them will probably be located about 4-6 inches below the upper tie bar on each side of the radiator. Odds are that the eyes will be large enough to pass a 6mm bolt through.
I hope what I have given you will resolve your problem. Lem me know,,good luck>>>>>>>>>>>>>>>
SOURCE: headlight socket replaced
this is relatively easy. First off remove the battery this will give you much more room to work. Identify which socket is not working, remove the round black rubber capping from the back of the headlight assembley. Pinch both sides of the metal clip that connects to the socket (you will also need to be sure after pinching to slide each side of the clip downward for the socket to release). Remove and replace socket. Once the socket is taken off your local parts store can easily locate a replacement. If you toook it apart you can put it back together.
SOURCE: How do you replace a Drivers side headlight bulb 2006 kia spectra
Helps to remove the battery, but small ahbds can do it.
Directly behind the lens is a big round cap ... twist it off. The bulb is held in place with a spring that locks in to a notch in the holder. When handling the new bulb, don't touch the glass. The oil from your skin will cause it to shatter when turned on.
59 views
Usually answered in minutes!
×