Question about 2002 GMC Envoy

1 Answer

Can you put a 2003 Trailblazer 4.2 engine in a 2002 envoy 4.2 without changing anything on the motor?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 227 Answers

I belive one had an AIR pump while the latter did not. there would be some differences in the manifolds and sensors.

Posted on Oct 23, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 30 Answers

SOURCE: 2002 Chevy Trailblazer Engine Codes

This is actually an easy swap out. Remove the electrical connection, remove the retaining bolt and pull out old one. I believe the sensor is located in the front passenger side of the engine on this particular model.

Posted on Aug 16, 2008

  • 691 Answers

SOURCE: how do you change brakes on a 2003 gmc envoy

don't need any special tools, standard sockets sets, "C" clams is a must unless your a He-Man and wrench set, plyer or needle nose will do. I assumed being 2003 your rotor never have been turn and i recommend every time you change your bakes is good idea to have your rotor turn. reason is it will make your pad last lot longer, removed any vibration and better even wear on the pad and eliminate any squealing although is not necessary to do so. make sure you get extra break fluid to bleed the brakes. get your self 5 feet long smallest vacum rubber hoses and a glass jar to bleed your brake fluid in. the rubber vacum hose you going to use to fit on to the bleeding nipple and run the other end of line to your the glass jar to save the brake fluid when you bleed the brakes. when removing caliper, check inspect make sure the rubber seals around your piston look good and not crack or deteriorated. before applying new pad make sure you open the bleed valve to reduce the pressure by turning the bleed nipple counter clockwise and leave it open attach that rubber hoses to the nipple because you going to press on the piston back into it housing with the "C" clamp in order for new pad to fit. becareful not to damage the rubber seals around the piston. its going to take lots of effort to push that piston back in so be a bare with it if needs to. once the pad is back in make sure you keep the reservoir full with brake fluid and then bleed the brake. two people is a good idea to do brake. one will do the pumping the brake and holding it down and other will bleed the nipple. I bleed it 2-3 time will do the job. good luck!

Posted on Jul 17, 2009

emissionwiz
  • 75822 Answers

SOURCE: reset 2003 trailblazer service engine light

is this the check engine yellow light?

Posted on Sep 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change a thermostat on a 2003 trailblazer


need to jack up and remove drivers side tire and using long extensions unbolt the thermostat housing from the lower side of engine or remove a few thing [alternator belt etc] and go through top its tight but the following link has video of both ways of doing replacement
How to replace thermostat 4 2 envoy or trailblazer

Jun 05, 2017 | Cars & Trucks

1 Answer

P0014 Diagnostic code, already replaced camshaft actuator & oil twice


code p0014 - Chevy TrailBlazer, TrailBlazer SS and GMC Envoy Forum

forums.trailvoy.com > ... > OEM Issues

Sep 8, 2007 - 11 posts - ‎8 authors
On my Trailblazer I have a code P0014 . this says Camshaft Position Actuator B ... If the desired and actual cam phase angle error exceeds its ... This diagnostic procedure supports the following DTC: ... replace the camshaft actuator solenoid, change the engine oil and filter, ... 2004 Chevy TrailBlazer LT P0014 - Camshaft Position Actuator Solenoid "Relearn"
11 posts
Dec 11, 2009
cam crank sensor mismatch
11 posts
Jul 4, 2009
More results from forums.trailvoy.com

Tech Code "dtc P0014" 2003 Trailblazer - Chevy S-10/Blazer ...

www.gm-trucks.com/.../72278-tech-code-dtc-p0014-2003-trailblazer/

Dec 31, 2007 - 14 posts - ‎6 authors
Tech Code "dtc P0014" 2003 Trailblazer - posted in Chevy ... it had been serviced before for the same thing in 2003 or 2004! ... replace the camshaft actuator solenoid, change the engine oil and .... The extended war. co. prob. would not be to happy since they already fixed the sensor once or twice already.

Replace a Camshaft Position Actuator Solenoid Valve on a ...

? 8:05
https://www.youtube.com/watch?v=4Dkdd287AKg

Jan 11, 2016 | 2004 GMC Canyon

1 Answer

2004 ENVOY WHERE IS MODULE RESISTOR


2002 - 2009 GM BLOWER MOTOR RESISTOR - YouTube

? 4:17
https://www.youtube.com/watch?v=WWi-_-kY-dM
Sep 5, 2012 - Uploaded by davesgarage512
I have a 2003 GMC Envoy and my issue is when I shut the blower off it still ... Can this issue also be remedied ...

2004 GMC ENVOY Blower Motor Control Module / Resistor



Nov 28, 2015 | 2004 GMC Envoy SLT

1 Answer

I want to know if the engine from an 2002 trailblazer will fit in an 2003 envoy?


OF COURSE; IT ALL DEPENDS ON HOW MUCH WORK YOU ARE WILLING TO DO.

Jun 20, 2015 | 2003 GMC Envoy

1 Answer

I just bought a 4.3 l V6 engine with trans out of a 2000 Trailblazer, will they fit into 1995 trailblazer without changing anything


Thanks for the picture! Answers a couple of big questions. "Trailblazer" didn't come out til' 2002 and it came with an Inline 6, not a V6 and an optional V8. This looks like a Blazer with the V6, so if this was taken out of a 2000 Blazer with the V6, you should be golden putting into a 1995 Blazer which came stock with that same engine.

May 15, 2015 | Chevrolet TrailBlazer Cars & Trucks

1 Answer

Tailgate on a 2002 trailblazer will not open. unlock button wont let it open. what fuse do I need to check or do I open from inside?


  • There was a Technical Service Bulletin concerning this.

  • Bulletin No.: 03-08-52-002
  • Date: March 27, 2003

  • Technical - Subject:
  • Remote Keyless Entry Inoperative (Reprogram Liftgate Module)
  • Models:
  • 2002-2003 Chevrolet TrailBlazer, TrailBlazer EXT
  • 2002-2003 GMC Envoy, Envoy XL
  • 2002-2003 Oldsmobile Bravada
  • Condition
  • Some customers may comment that the Remote Keyless Entry (RKE) is inoperative at times.

  • Cause
  • An anomaly has been identified with the software in the Liftgate Module (RKE functions). The Liftgate Module software is affected when the temperature is approximately 40°C (104°F).

  • Correction
  • Using normal SPS reprogramming procedures, reprogram the LGM Liftgate module. The information was released on TIS version 2.75 or newer broadcast in March 2003.

  • There is a fuse block under the rear seat on the drivers side. Fuse # 3 and # ^ are the ones you will check for the Lift Gate.
  • Often the problem can be in the harness going to the module.
  • Sometimes the module needs replaced and then reprogrammed.
  • Here is a copy of your owners manual for free http://www.extendedgmwarranty.com/owners-manual/chevrolet/2002-Chevrolet-TrailBlazer.pdf
  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.
Regards, Tony

Oct 01, 2011 | 2002 Chevrolet TrailBlazer

1 Answer

2002 envoy code co550


you need to replace the tccm and get it programmed.


2-04-21-006E: Inoperative 4WD/AWD Lamps, Inoperative 4WD/AWD System, DTC C0550 Set No Communication with TCCM (Reprogram Transfer Case Control Module) - (Jul 20, 2006)
999999995.gif Subject: Inoperative 4WD/AWD Lamps, Inoperative 4WD/AWD System, DTC C0550 Set, No Communication with TCCM (Reprogram Transfer Case Control Module) Models: 2004 Buick Rainier 2002-2004 Chevrolet TrailBlazer, TrailBlazer EXT 2003-2004 Chevrolet Avalanche, Silverado, Suburban, Tahoe 2002-2004 GMC Envoy, Envoy XL 2003-2004 GMC Sierra, Yukon, Yukon XL 2004 GMC Envoy XUV 2002-2004 Oldsmobile Bravada with Electronic Shift or Active Transfer Case (RPOs NP1, NP4 or NP8)

This bulletin is being revised to add Subject information and change the labor operation. This bulletin cancels and supersedes Bulletin Number 03-04-21-006. Please discard Corporate Bulletin Numbers 02-04-21-006D and 03-04-21-006 (Section 04 -- Driveline/Axle).
ConditionSome customers may comment that the 4WD/AWD indicator lights on the selector switch do not work, or the 4WD/AWD system may be inoperative and/or the service 4WD light is illuminated. The condition is typically intermittent and always occurs at key-up. Upon investigation, the technician may find DTC C0550 set.
CauseThe Transfer Case Control Module (TCCM) has not received the wake-up call during key-up and has remained in the "sleep mode".
When the TCCM is in the "sleep mode", it will not communicate with the class II bus or the Tech 2®.
Correction
  1. Try to communicate with the TCCM. If no communication, go to step 2. If communication is possible, go to step 5.
  2. Remove the underhood (ATCM or TREC) TCCM fuse.
  3. Wait 30 seconds.
  4. Reinstall the fuse. The module should "wake up" and communicate with the Tech 2®.
  5. Check for codes in the TCCM. If a C0550 is found current or in history with or without other codes, replace the module and go to step 6.
  6. Reprogram the TCCM with the latest TIS software using normal SPS procedures.
  7. Verify operation and that no codes are present.
Important: For the 2002 model year, the TCCM must be replaced and reprogrammed.
Warranty Information

Jul 29, 2011 | 2002 GMC Envoy

1 Answer

The air on my 2003 trailblazer only blows when on 4 or 5


Check out the link below, your blower motor resistor pack is probably defective.

Blower Resistor Replace link
http://www.sparkys-answers.com/2009/01/2002-gmc-envoy-no-low-blower-speeds.html

Jul 27, 2011 | 2003 Chevrolet TrailBlazer

1 Answer

Where is the location of blower motor resistor for heater on 2003 envoy


Go to link below for directions on how to change resieter. It is for a trailblazer but you do it the same on an envoy also.

http://forums.trailvoy.com/showthread.php?t=32751&highlight=BLOWER+MOTOR+RESISTOR

Good Luck

Nov 20, 2009 | 2003 GMC Envoy

2 Answers

I have a service engine soon light and the code that appeared when check is 1481, do you know what this means?


Service Engine Soon (SES) or Check Engine Light On, DTC P0480, P0526/P1481/P1484 Set (Replace Engine Cooling Fan Wiring Harness) #05-06-02-012B - (10/19/2006)

Models:2004-2006 Buick Rainier
2002-2006 Chevrolet TrailBlazer, TrailBlazer EXT
2002-2006 GMC Envoy, Envoy XL, 

Some customers may comment that the Service Engine Soon (SES) or Check Engine light is illuminated. This condition may be intermittent and upon investigation, the technician may find either DTC P0480, P0526, P1481 or P1484 set.

This condition may be caused by the cooling fan harness chaffing against the plastic guide it routes through. This contact may damage the insulation of the wires enclosed in that harness.

Replace the wire harness: 
Part Number 89024920 Description Harness Assembly, Engine Cooling Fan Wiring

Good luck and keep me posed. 

Aug 11, 2009 | 2003 GMC Envoy

Not finding what you are looking for?
2002 GMC Envoy Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...