Question about Cars & Trucks

Open Question

Ecm location for 1994 ford courier ute 2.6 efi petrol

I wish to install a cut out switch to the ECM live wire (box) but cannot locate same. Would it be known by another name?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: ford courier 4x4 ute starting problem

Hi,

If I understand you right, the problem is at certain times the engine will not crank, that is turn over when you turn they ignition key to START. And at times it will start and run normally.

Might it be that the issue is with the starter system. The starter system is initiated at the ignition switch when the key is turned to start. At this point, the ignition switch then provides +12VDC to a starter relay. The relay is but a remote switch with slightly higher amperage capacity. The starter relay then engages and supplies +12VDC to the staring solenoid. The starting solenoid then performs two (2) functions. It provides the switching action (hundreds amps) from the battery heavy cable to the actual starter motor. The solenoid likewise pushes a small pinion gear along the shaft of the starter motor to engage the ring gear. The ring gear is of course on the edge of the flywheel which in turn is attached to the crankshaft.

Starter system problems could be corrected by:
1. check battery, battery cables and connections;
2. charge the battery if required;
3. clean brushes and guides of brush holders of the starter motor;
4. clean the commutator and commutator segments;
5. check/replace the armature or field coils if determined to be defective;
6. in some extreme cases it could be the drive pinion or the flywheel gear ring is defective.
7. often it is the big switch that the solenoid activates that looses contacts causing no +12V internally to the motor.
8. Most likely would be a defective starter relay or the IGN switch itself. Relative to this, you might try and check the connectors/terminals and electrical joints.

In the picture below, the upper portion is the starter solenoid while the one below it is the actual starter.
c9b6a69.jpg
Given the amount of work to overhaul a starter, you might consider just replacing it.

This of course assuming that all other vital components of the car are working.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Posted on Jun 09, 2008

Ad
  • 75 Answers

SOURCE: location of the fuel pump relay or fuse

fuel pump in the fuel tank note that all ford are equipt with cut of suitch (interuptor) located under dach board in case of colision ,towing, ect.....this electrical devise wil stop the flow of the fuel to prevent car fire

Posted on Dec 21, 2008

dmfixit
  • 226 Answers

SOURCE: ecm 2 location 1996 gmc 1500 sierra

http://www.autozone.com/shopping/locsSelect.htm
engine control computer

Posted on Jan 06, 2009

emissionwiz
  • 76673 Answers

SOURCE: where is ecm box located on 99 tracer mercury

It is located under the dash, directly in front of the center floor console. The easiest way to access is to remove the console, which is very easy to figure out and do. The console is only held in place with about 6 phillips head screws

Posted on Jan 24, 2009

  • 1 Answer

SOURCE: Electronic Control Module Installation 1994 G20 Chevy Van

I just had the same problem. If it is a regular van try under the driver seat in a plastic box. If it is a conversion van try in a pannel just behind driver seat on side of van wall behind a pannel that looks like a vent.

Posted on Apr 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford Couirier/Mazda Bravo 1994 2.6 petrol 4x4 B2600 I need to buy new/used ECU (G618) replacement or upgrade for my 4x4 ute I want to know the compatible units i can use and best place to get one.


the ecu has to come out of the
same year and number as the engine and drive line
Ford Courier/Mazda Bravo 1994 2.6 petrol 4x4 B2600
source from
ebay
a 4x4 wrecker
an good auto electrican can referb your original
this is usa but might be a seller some where in australia

edit I added image of a G695
http://www.ebay.com/itm/OEM-91-92-93-MAZDA-B2600i-TRUCK-ENGINE-COMPUTER-CONTROL-MODULE-ECU-G618-18-881A-/1916530508691a07fc2d-2613-4d2f-a996-9a4d38ad626f.jpgford-couirier-mazda-bravo-1994-2-6#sln-36462275-ynwsor2g41t5qaon3uf1gyaf-5-2_2.jpgford-couirier-mazda-bravo-1994-2-6-ynwsor2g41t5qaon3uf1gyaf-5-3.jpg

Sep 11, 2016 | Ford Cars & Trucks

1 Answer

Why won't my 1992 ford Courier start?


run the fault codes to check for faults

May 02, 2015 | Ford Cars & Trucks

1 Answer

Where is the ecm located on1994 lexus es 300


ECM is located behind the glove box. I hope this helps

Aug 23, 2012 | 1994 Lexus Es 300

1 Answer

Rodeo petrol starts but wont rev


Holden Rodeo 1989 2.6mpi , start and only runs for 2 or so seconds themselves stalls, after putting on a fuel peesure gauge, fuel looked okay and slowly dropping, found the ECM relay was intermittently switching on and off, gave it a tap and the engine kept on running, relay not repairable, replace with new part. Located in the fuse and relay box on the right hand side of engine bay next to battery. Hope this helps.

May 24, 2012 | Holden Rodeo Cars & Trucks

1 Answer

Ecm location and illustration, please


FOr 1994 Toyota Camry 2.2L EFI DOHC 4cyl the Engine Control Computer is located: Front seating area, passenger side, under dash, mounted behind kick panel.

102cb0a.jpg

Components locations-1MZ-FE engine (click for zoom).

I hope helps (remember to rate this).

Oct 09, 2010 | 1994 Toyota Camry

2 Answers

Where is the Engine Control Computer located on a 1994 Taurus with a 3.0? and are there any memory cards that have to be taken from the old one and placed in the rebuilt one that i purchased?


Your ECC has no memory cards that have to be transfer to the other ECC, the ECC is a seal unit, just install, no reprogramming needs to be done, ECC is under hood, passenger side, rear engine area, above passenger side blower motor, mounted on fire wall.

Sep 15, 2010 | 1994 Ford Taurus

3 Answers

Where is my ecm located? I want to bypass the VATS.


vats can be bypassed by locating wires from key lock cylinder under dash. this is common problem with this type of system. you must determine resistence valu of key resister and cut wires ind solder replacement to ends of wires that go to vats module which is seperate from ecm module.

Apr 18, 2010 | 1994 Cadillac Fleetwood

1 Answer

Scanner reads code (060)


Location of "ECM" is Under the Air Filter Box

  1. Disconnect the negative battery cable.
  2. Remove the air cleaner box, refer to the air cleaner box.
  3. Remove the gray and black connector from the PCM.
    1. Remove the harness clip bracket from PCM bracket.
    2. Remove the nut from the upper bracket mount.
    3. Raise vehicle and support on hoist.
    4. Remove 2 lower bracket bolts.
      1. Remove 4 screws from bracket and remove bracket from PCM.
      INSTALLATION
      1. Install bracket to PCM and tighten screws.
      2. Install PCM and bracket to body and tighten the 2 lower bolts.
      3. Lower vehicle.
      4. Install upper bracket nut and tighten.
      5. Clip in wiring harness bracket.
      6. Install gray and black connectors to the PCM.
      7. Install the air cleaner box, refer to the air cleaner box.
      8. Connect the negative battery cable.

Mar 14, 2009 | 2001 Dodge Neon

2 Answers

Location of the fuel pump relay or fuse


fuel pump in the fuel tank note that all ford are equipt with cut of suitch (interuptor) located under dach board in case of colision ,towing, ect.....this electrical devise wil stop the flow of the fuel to prevent car fire

Dec 21, 2008 | 1988 Mazda B2600 Cab Plus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...