Question about Cars & Trucks
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I had the same problem. I changed my fuel filter too.Your catalytic converter is clogged. I could put the pedal to the floor board and couldnt hardly pick up any speed. I could hardly make up a hill on the highway. Take it to a kia dealership and they will, they should replace it for free, they did mine and I didnt have a warranty. I think there is a warranty on that specific part. That's what it is though.
Posted on Jan 10, 2009
The exhaust manifold is right there as soon as you open hood , first disconnect neg batt cab, then jack up car remove bolts that hold pipe to manifold together , unplug any o2 that is in the way and that could get damaged. now from the top take shield off then take manifold bolts out. you might want to spray them with pb blaster and let set a few hours sense exhaust bolts love to break. Remember to use new gaskets installing new one.
Posted on Jun 09, 2009
TD4 engine suffers from faulty injectors, this is a common cause of poor starting on this model. The best was to diagnose this is to carry out an injector leak off test.
Posted on Nov 28, 2009
u need to check al or your fuses! first ! this truck has an electric fuel pump mke sure itcomes on! no white smoke! suspect faulty idm aka injector drive modual
Posted on Apr 06, 2010
p0560 is system voltage problem. open or short between the battery positive and the ecm.CHECK ALL FUSES. dosnt matter what they are labeled under dash and under hood replace any that are bad and retry to start. no start then check voltage to ecm grounds to. i dont have a wireing diagram to give you but for a small fee or free the dealer can make you a copy.make sure all the wires that go to battery terminals are not corroded and are making good contact [verified with volt meter]. if after all checks ok then replace ecm. as a side note i havent had to change one ever.
Posted on Apr 11, 2010
Testimonial: "Thank you for the help. We will continue to check all fuses and wires."
Tips for a great answer:
Oct 14, 2015 | Kia Cars & Trucks
Jun 26, 2015 | 2007 Kia Picanto 1.1
Feb 01, 2018 | Toyota Yaris Cars & Trucks
Apr 27, 2010 | 1997 Chevrolet Tahoe
Feb 14, 2010 | 2007 Kia Sorento LX 4x4
Dec 24, 2008 | 2002 Kia Spectra
192 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: