Question about Cars & Trucks

Open Question

Camshaft sensor location

Vw bfq engine camshaft sensor location

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ajkill
  • 2035 Answers

SOURCE: Location of camshaft position sensor on a 2001 Hyundai Elantra wL

The camshaft position sensor is located on the engine near the timing belt cover and under the upper radiator hose.

Posted on Dec 26, 2008

savdragon
  • 37 Answers

SOURCE: locate camshaft sensor 2002 chevy trailblazer

Assuming you have a 4.2L engine here is the location.
b3031ef.gif

Hope this helps out,
if so please rate my answers.
Brett

Posted on Mar 19, 2009

  • 114 Answers

SOURCE: Camshaft sensor location

The cam sensor on the 4.7 is located toward the forward edge of the right cylinder head (passenger side). This has a 3 wire connector, tan/with yellow tracer is sensor signal, black / light blue tracer wire is sensor ground and the orange is the 5V supply.

Posted on Mar 22, 2009

  • 2 Answers

SOURCE: 1996 Jaguar XJ6: Diagnostic (Check Engine) Camshaft Sensor A

If your car is a 4.0L there are no camshaft sensor. Only crankshaft sensor and timing sensor. Dont know your problem but if your car is not running it is very common that the crankshaft sensor is faulty. It is fairly easy replaced and located just above the crankshaft wheel atthe front of the engine. It is mounted with one 8mm boult.

Posted on May 05, 2009

  • 144 Answers

SOURCE: Where is the camshaft position sensor located in a 2001 VW Passat

when you are looking at the engine pull off the plastic cover on top then the front cover that covers you timing belt there is a wire harness tha goes right to it in the left upper coner two ten mil bolts and it comes off careful not to drop bolts down in belt that could be bad. it is that easy

Posted on Sep 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the camshaft position sensor located in a


The camshaft position sensor is located on top of the engine near the ignition coils.
The camshaft position sensor is located on top of the engine near the ignition coils.
The camshaft position sensor is located on the engine near the timing belt cover and under the upper radiator hose.
The camshaft position sensor is either located near the top of the engine, passenger-s side, or on the right side of the engine near the ignition coils.
The camshaft position sensor is located on the engine near the camshaft pulley.
This sensor is located at the front of the engine near the camshaft gear this is what I got 6 different locations manual covers 99-05

Oct 10, 2014 | Cars & Trucks

1 Answer

Camshaft sensor location


It's on the front of the cam shaft near the timing chain. You have to open the camshaft cover to access it.

Feb 21, 2014 | Cars & Trucks

1 Answer

Location of camshaft position sensor on 2009 saturn aura


2.4L cmp sensor exhaust located upper rear of the engine near camshaft cover. 2.4L cmp sensor intake located upper front of the engine near the camshaft cover. the 3.5L cmp sensor located right side of engine compartment above the timing chain cover.below power steering pump.3.6L cmp sensor located right side of the engine near the front and rear.

Sep 26, 2013 | Cars & Trucks

1 Answer

I need to find the Cam Sensor location on a 2007 VW Beetle


To replace the camshaft position sensor, you must remove the toothed cam belt (loosen the tension and pull the belt off of the cam sprocket) and the cam sprocket. The sensor is located behind the sprocket - it is easily replaced. Although this may seem daunting, the hard part is relocating the cam sprocket correctly to the camshaft. You see, there is no key or fixed marks to get it back on correctly. I do recommend that you get a repair book to try the yourself. The VW book is somewhat difficult to use and I have never looked at the Haynes manuals
Courtesy of wiki

Sep 07, 2012 | 2007 Volkswagen Beetle

1 Answer

Camshaft position sensor


ON THE 4 CYLINER ENGINE CAMSHAFT SENSOR LOCATED AT THE LEFT DRIVERS SIDE OF THE TIMING COVER. THE V - 6 ENGINES CAMSHAFT POSITION SENSOR LOCATED AT THE FRONT OF ENGINE BLOCK BELOW THE POWER STEERING PUMP.

Aug 28, 2012 | 2000 Oldsmobile Bravada

1 Answer

Do you have to remove the cam gear to change the camshaft senaor.


Courtesy of a Beetle forum.

The camshaft position sensor is located at the front of the cylinder head under the timing belt cover. On 2.0L models, the camshaft position sensor is located behind the camshaft sprocket and is equipped with a pigtail lead and a remote connector. On 1.8L turbo models, the camshaft position sensor is located at the front of the intake camshaft. check the terminals in the connector and the wires leading to the sensor for looseness and breaks. Repair as required.

Before checking the camshaft position sensor, check the voltage supply and ground circuits from the ECM. Dosconnect the electrical connector from the camshaft position sensor and connect a voltmeter to terminals 1 and 3 at the harness connector from the camshaft position sensor and connect a voltmeter to terminals 1 and 3 at the harness connector. Turn the ignition key On - the voltage should read approximately 5.0 volts. If the voltage is incorrect, check the wiring from the camshaft position sensor to the ECM. If the circuits are good, have the ECM checked at a dealer service department or other properly equipped repair facility.

To check the camshaft position sensor operation, reconnect hte connector to the camshaft position sensor and using a suitable probe, backprobe terminal no. 2 of the camshaft position sensor connector. Connect the positive lead of a voltmeter to the probe and the negative lead to a good engine ground point. Turn the ignition key On. Rotate the engine slowly with a breaker bar and socket attached to the crankshaft pulley center bolt while watching the meter. The voltage should fluctuate between zero volts and 10.0 volts as the vanes in the reluctor wheel past the sensor. If the test results are incorrect, replace the camshaft position sensor. Note: Rotate the engine slowly through at least two complete revolutions. Removing the spark plugs from the engine will make the crankshaft much easier to turn. Warning: If you remove the spark plugs, unplug the primary (low voltage) electrical connector(s) from the ignition coil(s) to disable the ignition system

Jul 11, 2012 | Cars & Trucks

1 Answer

Where is the camshaft position sensor located in a 2001 VW Passat


when you are looking at the engine pull off the plastic cover on top then the front cover that covers you timing belt there is a wire harness tha goes right to it in the left upper coner two ten mil bolts and it comes off careful not to drop bolts down in belt that could be bad. it is that easy

Aug 31, 2009 | 2001 Volkswagen Passat

4 Answers

Where is the camshaft position sensor located on a 2004 dodge stratus 4 cyl 2.4L engine


the camshaft sensor is mounted on the camshaft housing located on the end of the cylinder head.

Jul 08, 2009 | 2004 Dodge Stratus

1 Answer

Both Cam Sensor issues-3.2L V6-Won't start after running for awhile. Starts after sitting for a few hours.


The 2 sensors are located at back-top of the engine, you should check the wiring first before you change the 2 sensors

Apr 27, 2009 | 2005 Volkswagen Touareg

1 Answer

Camshaft sensor


YES THERE IS A SENSOR, IT IS LOCATED ON THE FRONT OF THE ENGINE WHERE THE TRANSMISSION AND BLOCK BOLT TOGETHER NEXT TO THE STARTER AND ALMOST UNDER THE OIL FILTER COOLER

Feb 07, 2009 | 1997 Volkswagen Jetta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...