Question about 2001 Hyundai Accent
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Adjusting the low beam headlight
its all the same the headlight is a complete unit you adjust both/ look for screws behind the headlight one each side one is for horizontal annd the other is for vertical Please rate my response thank you very much
Posted on Jan 31, 2009
hi the clutch on accent is hydraulic operation so if pedal is very low on disengaging clutch ? you may have a problem with the hydraulics 1st thing to check is fluid level? this is the reservoir that feeds both brakes and clutch but is seperaterated inside if fluid low? top up and bleed the slave cyl however if fluid low indicates a leak ? possibly slave cyl? if no loss of fluid ? then prob may be fault in the master cyl ? check fluid come back with any update please ps if this problem has just occured? check for leaks ?
Posted on Feb 02, 2009
A car can overheat for a lot of reasons.First make sure this is the problem by checking the radiator hose or water level. Open the radiator cap when the car is cold, crank it, and then watch the water level. If it drops when the car warms up this is not the problem.
The tools you will need will depend on what you have to take off to get to it. If you can access the thermostat you should only need a ratchet or wrench to remove it and something to scrape off old gasket with.
Location:The thermostat should be inside the thermostat housing on the motor. Follow your top radiator hose to the place where it goes into the motor. There should be a sort of dome shaped housing there with probably a bolt on either side of it.The thermostat is inside that.
This is a reasonably easy job, but shouldn't be done carelessly. It's also kind of messy.
When the car is cold remove the bolts from the housing with a ratchet. Lots of coolant and water will drain out. But the thermostat will be visible.Pay attention to which side of the thermostat is up.It should just lift up. Remove all the old gasket from around the area and clean it up well. Replace the thermostat and gasket then the bolts. Be very careful not to over tighten the bolts or the housing will be ruined.
Posted on Apr 22, 2009
Under the dash fuse box ,fuse 15 (TCM ECT) is a combination of cluster, heater and headlights.probably a relay fuse!!!!! fuse 16is a relay fuse.
Posted on Jun 10, 2009
They nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
Posted on Sep 17, 2009
Testimonial: "The adjustment screw (for passenger side) is located between the battery & frame's second hole. Turning counter-clockwise, it adjusts downwards,Thanks"
Tips for a great answer:
Nov 07, 2014 | Hyundai Motor 2004 Accent
Jul 12, 2012 | 2001 Hyundai Accent
May 24, 2012 | 2005 Hyundai Accent
Aug 20, 2011 | 2002 Hyundai Accent
Headlight bulbs-2000-2005 Accent
Jan 23, 2011 | 2001 Hyundai Accent
Oct 19, 2009 | 1999 Hyundai Accent
Sep 01, 2009 | 2005 Hyundai Accent
Aug 23, 2009 | 1996 Hyundai Accent
May 17, 2009 | 2002 Hyundai Accent
96 people viewed this question
Usually answered in minutes!