Question about Cars & Trucks

Open Question

Oops. Velox dbl hung vinyl window w moisture between glass. Possible to switch w diff window in house which is clear?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

'01 BMW 330Ci


Befor you put it all the way down try to change the fold with you hand so the window will clear the seat, or look the top on the inside to see if it is coming apart.

Mar 13, 2014 | BMW Cars & Trucks

2 Answers

Windows fog up


There is too much moisture inside the cabin. Either something is leaking water into the car, or your fresh air setting is not working on the hvac system. You can not run the system on recirculate and get rid of the moisture.

Feb 05, 2014 | 2003 Pontiac Sunfire

2 Answers

Toyota Camry 2004 Defroster fogs windows.


2 possibilities:
1 - HVAC External Drain Tube stopped up with dirt, bee nest, etc. Hard to get to w/out a car lift. Need to clear and drain HVAC box.
2 - Leaking heater core inside HVAC box. Moisture from defog will smell sweet and be hard to clean off glass. Requires Dash removal and AC service to replace Heater Core. Very time consuming and Expensive A-Freeze fumes are also lethal if inhaled.

Try Solution #1 First, Least Expensive, Non-Lethal Condition.

Oct 16, 2012 | 2004 Toyota Camry

1 Answer

How to get to drivers side window to repair it off track pontiac grand am 1999


Hi,

First you have to remove the door panel .Once the panel off, unplug the window motor and use a volt meter on the plug that plugs into the motor.Push the up/down button and check whether you get about 12 volts, if you do then your motor needs to be replaced. If not then the problem the main control switch on the driver door. You have to remove the motor in order to get that window up.

Thank you !!

The vinyl welt or glass run channel is curled up in the track binding the window glass fron coming up. After it sits for a minute or two like you stated it works its way up a little more each time. The reason is the curled up welt (vinyl) has to takes sometime to work its way back out somewhat. Then it will go up a little more and quit and so on as you said. To fix this you can add a lubracant called dri slide which will work possibly only if your window is fully up at that time. You will need to saturate it between the glass and the run channel (welt) that is curling up causing it to bind. I would do both sides for good measures. If this does not work to greta all you can do is to replace the welt for the glass run channel.

Jun 15, 2010 | 1999 Pontiac Grand Prix

1 Answer

How do you install a convertible sebring rear window? I just need something,like a sheet made of clear vinyl or something like that to replace the rear window with.Would Velcro work?


Nope, from my sports-car "roadster" days the rear window is either bonded in between the layers of the top or sewn-in. An auto upholstery or "trim" shop can probably put you in a new window fairly resonably. Velco, glue, etc. and the window will blow-out if you open the door window at speed. The rear-window would be sucked out at high-way speed by the draft behind the top. BTW: I thought Sebrings had real glass rear windows, like alot of "rag-tops" do these days. (back to the Model T's !)

Feb 11, 2010 | 1999 Chrysler Sebring

1 Answer

How do I replace the back window?


Remove the black vinyl trim from the edge of the glass. Remove broken glass & urethane adhesive from the metal pinchweld leaving a thin layer (approx 1/16") of urethane for new new urethane to adhere to. Vacuum broken glass. Prime nicks to the metal to protect from rusting (also insuring a good surface to bond to). Attach vinyl reveal molding to glass (unless it's a "T" shaped push in type - it would install after the glass is set). Clean and prime the replacement glass. Apply new urethane adhesive. Set glass in place.Slide the metal joint cover in place on the molding (at bottom in the center). Clean outer surface of glass. Allow for safe drive away as noted by urethane manufacturer.

Sep 25, 2009 | 1995 Oldsmobile Cutlass Ciera

1 Answer

99 Grand Am GT windows fog up


Fog on the windows is caused by moisture in the air condensing on the cold glass. You probably knew that. So the solution to your problem is to reduce the humidity in the car or warm the glass above the dewpoint. Running the AC will help because any moisture in the air will condense on the much colder evaporator coils before it gets to the windows, but as soon as you turn the AC off that moisture goes right back into the air. Fresh air from outside will help if the moisture level in the outside air is lower, which it ussually is in the winter. The only sure solution is to warm the glass.
You may want to check a service manual and see if there is an air filter somewhere in the cabin heat plenum. If so you may want to replace it. Defrosters and side vents should provide plenty of warm air to clear all windows and it sounds like your just not getting enough air flow. If you're not really into getting behind the dash and tinkering with the heater plenum, you might consider a small 12 volt heater like the ones available at auto parts stores, or you could just let the cabin warm up well before driving. There are also glass treatments that you can use to prevent fogging, I used one for years on a motorcycle helmet, These are ussually a wax and or soap base so they have to be cleaned off and reapplied periodically, but they do work well.

Nov 15, 2008 | 1999 Pontiac Grand Am GT

2 Answers

I had moistured on my 2004 sienna headlight, How can i removed the moistured?


I fixed this problem on my 2004 Sienna. The moisture seems to come in from the top of the headlamp assembly. I generously applied Permatex Super Clear VINYL SEALANT to the seam at the top of the assembly after drying out the moisture by remvoing the bulbs. There are vent at the bottom of the assembly which should be open; there's a liitle foam plug that let's air in so the assembly is not intended to be airtight. There has been no moisture problem for about a year.

Jul 31, 2008 | Toyota Sienna Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...