Question about GMC Sierra 1500
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2005 GMC Sierra Overheating
If your sure there is no trapped air in system after refill and air bleed off, is fan clutch pulling good air thru radiator? Even if it is, the heater should have coolant as hot as what temp gage is showing! Try backwards flushing heater core (dex cool is notorious for plugging these up). There is a TSB for cracked cylinder heads from GM for unexplained coolant loss.Remove drivers side valve cover, and look at center three head bolts for coolant around them, if coolant has been getting in thru this suspect area, there will be a milky/pudding like goo under valve cover and on head. GM had a company called Castec cast these and the areas near the head bolts were found to be too porous (NO recall YET!) Ya, you guessed it, replace heads! Unfortunately, if its gotten hot to many times, it has probably hurt the heads/gaskets. Hope this helps. PS: The castec logo is under the rearmost pair of rocker arms,may have to remove them to see.
Posted on Feb 05, 2009
First thing unhook positive battery cable, unhook main cable on starter selanoid and small wire on selanoid (there may be 2 small wires) There may be a bracket on front of starter that has to be removed, and then the 2 main bolts that hold it to engine block and it should come out.
Posted on Feb 14, 2009
take off the cover on the top and bottom of the steering column just behind the wheel. pop the tilt lever out simply just by grabbing it and give it a good tug. then once you have the new switch and you get in there your going to need an inverted torx socket to remove the small bolts that hold the switch to the column. do not move the gear on the new switch make sure it lines up exactly as the old one did!!!!!!!!!!!!
Posted on Mar 15, 2009
The switch or the wire harness at the blower motor has gone bad. The highest setting 5 has no resistor, so the blower runs on high but the high current flow ends up burning up the switch's contact on that setting or the resistor wire harness at the blower motor has gone bad. Common would be the switch it self, if the switch is good. Then it's going to be the wire leads at the speed resistor by the blower motor under the glove box by the passenger leg compartment. Keep me posted, be glad to help you get your Sierra running 100% again soon.
Posted on Jan 06, 2010
Tips for a great answer:
Jan 25, 2016 | GMC Cars & Trucks
Jun 06, 2015 | 2008 GMC Sierra 1500
Feb 24, 2015 | 2008 GMC Sierra 1500
Jul 16, 2014 | 2008 GMC Sierra 1500 Denali
Mar 25, 2014 | 2008 Chevrolet Silverado 1500
Jan 06, 2013 | 2008 GMC Sierra 1500
Dec 14, 2009 | 2008 GMC Sierra 1500 2WD
Mar 23, 2009 | 2008 GMC Sierra 1500 2WD
Jan 10, 2009 | 2002 GMC Sierra
14 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: