Question about 2005 Nissan Sentra
Take it back to whoever changed the bearing.
Either they didn't or they have tightened the Drive belt too much.
Posted on Oct 22, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I have the same problem. When I let the car sit over night it cranks right up, but if I cut it off it is off for hours and won't crank.
Posted on Oct 05, 2008
Check for vaccume leaks and also you PCV valve. check the hose too. Visually inspect every vaccume hose you can find. Sounds like a leak .
Posted on Nov 10, 2008
If not low on refrigerant, Things that could be wrong are expansion valve inopt, condensor fan not working or possible bad compressor.
Posted on Dec 07, 2008
I had such a problem in mine. It would work intermittently.
The thing to look at is whether the little green light on the aircon pushbutton is ON when the aircon should be running.
If like mine was it is OFF at any time, the problem is in the clutch control circuitry.
In my case, I removed the entire aircon control assembly. To get to it, it is necessary to start at the top panel, centre of dash. It prises off. I don't remember the entire sequence, but the front panels around the radio and aircon panels, and the air inlet ducts above the radio, also come away.
The radio has to be unscrewed and removed to gain access to the cables and connectors on the aircon panel. It is wise to disconnect the battery, but as I was not sure if I had the code to reset the radio, I left the battery connected, and just swung the radio clear after unplugging the antenna lead.
Now you can remove the control cables and connectors, the control cable outers can be released with a screwdriver from behind the plastic clips, and the cable inner unhooked from the control levers. Undoing the screws holding the panel in place will facilitate this.
In my case, having opened the control panel out of the car, resoldering all the connections between the 2 circuit boards and for the pins the plug connects to in the control panel solved my problem. I tested it without reconnecting the operating cables before reassembling everything back into place.
It has worked fine ever since... Good luck!
Posted on Jun 05, 2009
Have your compressor check. Squeaking sound is caused by a metal to metal contact. Your compressor bearing needs to be replace, to get it aligned. So that the metal to metal contact will be eliminated. Reload your compressor with refrigerant, before getting it activated. Replace the burnt wiring and the relay. Since a lot of work must be done, it is suggested that you take this to the car aircon service
Posted on Nov 03, 2009
Testimonial: "Thank you for giving time answering my problem.I also did my research over the internet and found the same solution as you've written.Thank you again!"
Tips for a great answer:
Feb 26, 2014 | Cars & Trucks
Nov 04, 2013 | Cars & Trucks
Jan 27, 2013 | Cars & Trucks
Aug 23, 2011 | 1989 Nissan Sentra 4 Door
Dec 08, 2010 | 2002 Nissan Sentra
Jan 28, 2010 | 1996 Kia Sephia
Nov 03, 2009 | 1994 Nissan Sentra 4-Door
Jun 21, 2009 | 1989 Toyota Corolla 2 Door
Dec 07, 2008 | 1992 Nissan Sentra 4 Door
95 people viewed this question
Usually answered in minutes!