Question about 2007 Chevrolet Tahoe

Open Question

Tahoe jacking points - 2007 Chevrolet Tahoe

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Can I track my 99 tahoe if it has been stole And how?

If ur onstar was enabled, onstar can track the location 4 u. Otherwise unless u had lo jack or a similar aftermarket device installed, u r out of luck

Aug 17, 2014 | 1999 Chevrolet Tahoe

1 Answer

Tire jack on the 2008 tahoe z71?

Dec 25, 2017 | Chevrolet Tahoe Cars & Trucks

1 Answer

Getting an evap code on a 2000 tahoe, how far does the tank need to drop to check the pressure sensor on the tank

well it makes it alot easier if you block the wheels and remove the rear drive shaft first. watch your fingers at the pinch points ( U-JOINTS ) and i had to drop my yukon xl tank for a pump replace , you need to put a piece of wood ( large enough to cover your floor jack platform and to balance tank. It would be best to wait till tank is almost empty. Then you can handle it by hand,as tank is only like 15 pounds with a little fuel) and lower to floor.

Jan 14, 2011 | 2001 Chevrolet Tahoe

1 Answer

Where is the spare tire and jack on the 2007 chevrolet tahoe

open the rear door..the jack gonna be right or left out door compartment on the wall and you will see the jack and the tire wrench...connect the wrench together and it gonna be like 4 feet long...look under the truck on the rear and there you will see the tire...put the long wrench in the hole next to lic plate and start turn counterclockwise and the tire will come down..good.luck

Apr 21, 2010 | 2007 Chevrolet Tahoe

1 Answer

Where is the Jack and tools to change spare on 2007 Chevy tahoe

look under the rear sewat or the rear side compartment. Different options equiptment in these vehicles changes the location of the jack and tools

Jan 24, 2010 | 2007 Chevrolet Tahoe

1 Answer

Just need to replace the rear suspension springs. I have a replacement set, but need to know if I can do myself easily- or do I need special tools/equipment.?

u can do it yourself if u have some experience, u will need jack stands and floor jack heavy breaker bar and tape measure. u jack truck up until tires in the air support frame with jack stands and then jack axle loosen blolts and lift axle up/ down til u can pull bolys out put in new spring retighten measure both sides to common point to make sure axle is staright then do other side when done remeasure adjust if needed

Jul 06, 2009 | 2002 Chevrolet Tahoe

1 Answer

Tahoe engine warning light is on, amber in color and looks like an engine 2004 tahoe

take your tahoe to autozone for a free "check engine" light test. This will not tell you the pin point problem, but will narrow is down to at two to three errors.

May 12, 2009 | 2004 Chevrolet Tahoe

1 Answer

Po 751 code 99 tahoe

The solenoids are located in the transmission. There is one for the 1-2 shift point, one for the 2-3 shift point, and one for the 3-4 shift point. You have to drop the transmission pan to access them.

Apr 10, 2009 | 1999 Chevrolet Tahoe

2 Answers

Can I add a jack to play an ipod to my factory 6 cd stereo?

I believe so, there are some audio jacks that are converters from a power source, such as, a lighter jack.

Feb 04, 2009 | 2004 Chevrolet Tahoe

Not finding what you are looking for?
2007 Chevrolet Tahoe Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides