Question about Chrysler 300M

Open Question

Intermittent starting I'm having intermitent starting problems with my 2004 Chyrsler 300M. Sometimes I can go for days without a problem, but I swear everytime my trunk is filled with groceries the damned car won't start...give or take 30 minutes or so and it will start again. I've been to dealers, independent mechanics and they can't find the problem because the car starts for them...always...UGH. Any suggestions would be appreciated. Thank, Sue Van Dyck

Posted by Anonymous on


5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: 98 Grand Caravan 3.3 engine starting / running problems

A bad earth connection point on my New Zealand model Chrysler Voyager LE (same car as yours but right hand drive) caused similar problems, including the towing thing. My dealer told me that they would be busy for 3 weeks - dealer talk for "we would prefer to sell you a new one".

A bunch of black wires connect to a chassis ground bolt on my model on the right hand side wall, under dashboard height. I was "lucky" to have the fault present when investigating it, and testing I did afterwards proved this to be a definite cause. You have to remove some covers and pull the floor carpet away This may be on the left on your model. A plug in connector is used, to bring multiple wires together at this point. All I had to do was undo the nut and clean the metal of the bolt and earth lug - use a file or sandpaper, and maybe spray on some WD40 or CRC to impove conductivity. I added an extra washer to help the metal to metal bond also.This seems to have fixed the problem. It has been OK now for about 1000 miles. Good luck !

Posted on Jun 15, 2008

  • 6 Answers

SOURCE: 99 hyundai accent starts sometimes. not battery

ok when the check engine light comes on that usually indicates a engine malfunction...what you can do is go to your local autozone and they can do an OBDII test for bet says it is the cam or crank sensor.. DO NOT SHUT THE CAR OFF AT AUTOZONE..LOL

Posted on Jan 01, 2009

  • 68 Answers

SOURCE: 2001 300m overheating problem.

When the vehicle overheats, do u check the water/coolant level in the radiator? If it has reduced, it means ur leaking and u should inpsect to c where the leak is coming from. If the level has remained the same, probably ports are blocked or something to that effect. Keep me posted though

Posted on Jan 28, 2009

  • 71 Answers

SOURCE: sometimes my 2008 sonata won't

It sounds like this could be your fuel pump sensor also as mention in the earlier post the click could be the pump relay reseting allowing the pump to come on to deliver fuel to the engine. You may also want to check the ignition relay in the fuse box under the hood, a weak relay can heat up and need time to reset before letting the engine start, at the dealership they may not give it time enough to heat up to cause the problem. When the problem occurs again turn the key and listen for the pump to come on if it does come on, then move to the next solution. Hope this helps.

Posted on Jan 04, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2003 chyrsler 300m it went in limp mode codes p0700. P0340 p0344 p0430 p0888 came up cleared the codes and now it knocks.

clearing codes wont correct the problem and limp mode is designed to protect motor and transmission - p0700 is a transmission problem
P0700 Transmission Control System Malfunction p0340 is camshaft position sensor malfunction p0344 is also a camshaft position sensor circuit problem
P0344 Camshaft Position Sensor Circuit Intermittent your p430 is a cat converter problem and p0888 is transmission relay problem these reasons are limp mode the knock can be fuel not burning correctly or a lower engine knock can mean you damaged a piston

Nov 08, 2016 | Cars & Trucks

1 Answer

Why does my 2004 BMW 525 intermittedly have no power?


Apr 14, 2017 | 2004 BMW 525 i

1 Answer

99 chyrsler 300m runs hot when ac is on, but not if ac is on

Have the AC pressures checked, it may be overcharged.

Jun 29, 2012 | 1999 Chrysler 300M

1 Answer

2007 GMC Yukon intermitent starting problem. New battery in August 2011, which has been rechecked by dealer to be okay. Approx 30 days ago vehicle would not start with key, although all electrical power...

According with your comments (in other question), it's very difficult to tell how much longer it might be going this intermittent problem. You have informed about suspicions of failure in the NSS (Neutral Safety Switch)?

Other symthoms there? I could adventure to test the security system or some re-synchonized setting.

Oct 14, 2011 | Cars & Trucks

1 Answer

Is there an access panel to the fuel pump on a 2004 300m?

On your car there is an access panel in the forward part of the trunk that will let you get to the fuel pump without dropping the gas tank!

Pull back the carpet in the area between the rear wheels, thats the access panel! good day !!

Jun 21, 2011 | 2004 Chrysler 300M

1 Answer

Chyrsler 300m wont start and the alarm light is flashing. We have lost the remote lock and only have a key for it. How can we set it?

Try key in drivers door, lock, unlock then back to straight. If no luck try passenger as well.

Dec 12, 2010 | 1999 Chrysler 300M

2 Answers

2004 chyrsler pacifica front fan stops on high

Replace the resistor in the front fan system.

Nov 12, 2017 | 2004 Chrysler Pacifica

1 Answer

2004 chrysler 300m, speedometer and tach lights go out sometimes and stay off. the next time i drive the car they just might be working, intermittently they work.

These cars are very finicky when it comes to the electrical components. We have a 2001, try this: Make sure the battery is tightened down good. Because of the battery location on these cars, there is good chance that ****** is moving around and the connections are coming loose. What we did was remove the battery clean it and the terminals and then put it back in, and every thing has been working since then. I hope this helps. It would be a good idea to get a service manual for this car just in case. Here is link to an inexpensive one. Chrysler 300M Service Manual.

Sep 27, 2009 | 2004 Chrysler 300M

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides