Question about 2002 Volkswagen Jetta TDI
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Never ever bring a jetta to a volkwagen dealer. They will bend you over and rape you.
All you have to do is remove the top plug with a hex wrench.
Posted on Jan 12, 2009
VW didn't put a "dipstick" on the trans for whatever reason. You technically have to use the VW Vag-Com scanner to properly check the trans fluid level as VW says it has to be checked at a specific temperature. But there is a "shade-tree" workaround. Start the car and leave the engine running the throughout the entire procedure. You have to get the trans fluid warm-a little under normal operating temp. 95F-104F is what you want-you can attain this after letting the car idle for 8 or so minutes. Continuing, leave the trans in park, and make sure you are on as level of a surface as possible. Then loosen the allen plug on the bottom of the trans pan. You will then see another plug. Remove this plug. Fluid should just trickle out of the hole if it is at the proper level. If it trickles out, you are good. If it doesn't you need to add fluid. Add VW spec ATF through the fill port.The fill port on the top front of the trans is capped off by a red cap and is very visible. Very carefully pry the cap off and then wiggle the plug out. I'd highly suggest having a spare red cap on hand-VW dealer has them. Then you can pour fluid into the trans. Add a little bit at at time, and all the while watching for the fluid to tricke out of the trans plug hole. When it trickles out, replace the inner plug and then the outer plug. That's it. Recheck after driving the car for a few miles. FYI- A flud and filter swap on the the VW auto trans takes 3 liters, so keep that in perspective. I hope this helps you out.
Posted on Apr 14, 2009
THE 5 SPEED AUTOMATIC TRANSMISSION
At the bottom of the automatic gearbox (tiptronic) you will find one threaded plug on below surface, (follow red arrow in the picture below). This is for emptying.
The oil level threaded plug is placed on the car front lateral automatic gearbox surface, (follow yellow arrow in the picture below).
The filling oil plug is placed on the upper automatic gearbox surface, (follow green arrow in the picture below).
Automatic Transmission Fluid (ATF) checking:
1. Requirements for check:
1.1. Vehicle standing on level surface.
1.2. Transmission must not be in fail-safe mode.
1.3. Shift lever in "P" position, parking brake applied.
1.4. Engine idling.
1.5. Air Conditioner and heater OFF.
1.6. ATF temperature must not exceed 104 Fahrenheit degree (40 Celsius degree) at start of test.
1.7. Automatic gearbox oil capacity: 2,5 liter. Only ATF with VW designation may be used. Do not use any lubricant additives.
1.8. Automatic Transmission Fluid ATF - part number: VW G 052 990 A2
1.9. An ATF level check when transmission oil temperature is too low results in overfilling, when too high results in underfilling.
2. CAUTION: Too much or too little ATF will affect the operation of the transmission. The ATF level must be checked at regular intervals.
Posted on Apr 10, 2011
Tips for a great answer:
Jul 29, 2017 | 2003 Volkswagen Jetta TDI
Apr 10, 2011 | 2003 Volkswagen Jetta TDI
Mar 15, 2011 | 2003 Volkswagen Jetta TDI
Aug 17, 2010 | 2003 Volkswagen Jetta TDI
Dec 27, 2009 | 2001 Volkswagen Jetta TDI
Sep 16, 2009 | Volkswagen Jetta Cars & Trucks
Apr 12, 2009 | 2001 Volkswagen Jetta TDI
Apr 10, 2009 | 2004 Volkswagen Jetta
Dec 17, 2008 | 2000 Volkswagen Jetta TDI
Jul 21, 2008 | 2000 Volkswagen Jetta TDI
62 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: