Question about Chevrolet Blazer

Open Question

How do I program a cool start remote model #vvj-t612s434 to my 2003 chevy blazer

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

matney68
  • 426 Answers

SOURCE: i have a remote doorlock

there is a number on the back of the key fob you would have to see that it is the same number for both for it to work. it is a very small print number. you could call a gm parts department and they could give you details on the part number if you dont have original one so you can see if the one you do have matches

Posted on Jul 30, 2009

Testimonial: "VERY GOOD INFORMATION"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 02 blazer i want to put a motor out of a 98 in it will it interchange


Chevy Blazer Engine Swap Part 1 of 2 - YouTube

? 10:29
https://www.youtube.com/watch?v=Dt_7AKP2WcI
Aug 13, 2011 - Uploaded by Dave R
Replacing the engine in a mid-size Chevy Blazer 4x4 with oneout of a Jeep Cherokee 2wd. Original engine was low and motoroil and spun a bearing. ... Chevy Blazer Intake Gaskets Replaced & Cooling System Rebuilt - Duration: 16:45. by ... 4:02. 94 4.3l Vortec V6 GM (black motor) - Duration: 6:01. by ...

4.3 vortec engine removal - YouTube




Jan 01, 2016 | Cars & Trucks

1 Answer

Chevy blazer will start then dies, wait 15 minutes it starts and runs good


Trail Blazer has a very cool 'plastic' intake on the Vortex series. I would have the intake checked out, or just replace it with a new one. Don't reccomend a used one since it was a common problem.

Jan 15, 2014 | 2000 Chevrolet Blazer

1 Answer

1999 chevy blazer wiring harness diagram for remote start


Large purple wire is your starter engagement wire, I believe you will have to tie into more than that wire to get your remote start to work properly, maybe get me brand and model number so I may research more and point you in the right direction as far as installation goes.

Nov 30, 2011 | 1999 Chevrolet Blazer

1 Answer

Can't find the keyless remote module under steering column to reprogram my remotes 1195 Chevy Blazer


Here is what i found for your 95 blazer. Hope it helps a little bit.

1. Locate the red two wire programming connector located near the central
locking control module. Behind LH lower instrument panel.

2. Inside the red programming connector you will see two pins.
Jump the two pins with a section of wire. A paper clip bent in a "U" shape will also work.

3. System should now lock and unlock doors to indicate vehicle has entered
programming mode.

4. Press any button on keyless remote once. System should now lock and unlock
doors indicating the keyless remote has been programmed.

5. Repeat step 4 to program the other remote.

6. Remove jumper wire from programming connector to exit programming mode.

7. Test Remote(s).

Sep 02, 2011 | 1995 Chevrolet Blazer

1 Answer

I have 2 identical remotes for my 02 Chevy blazer I cannot get them both to work at the same time. Whenever i program the 2nd one the first one doesnt work. Then when i program the first one the second one...


when you go into programing mode and program a new remote the vehicle forgets the first one. you will have to program both remotes one at a time while the vehicle is in reprogram mode

Jan 06, 2010 | 2002 Chevrolet Blazer

1 Answer

Why wont my 99 chevy blazer temperature warm up?


You may have vapour lock in your heater lines. Start engine, put heat lever on high, disconnect one of the lines on your heater core, the one on the flow out side, & see if you have any air coming out. Once antifreese comes out stick line back on & retighten clamp. Make sure your cooling system is topped off. Also your water pump may not be functionihg to it's maximum. Take rad cap off cold & view flow rate. If inadequate you may have to replace the water pump. Good luck!

Dec 09, 2009 | 1999 Chevrolet Blazer

2 Answers

Program fob


Instructions to program a keyless entry remote for a Chevy Silverado. They also work on 2003, 2004 and 2006 Suburbans.
  1. Close all the vehicle doors.
  2. Insert the ignition key into the ignition lock cylinder.
  3. Press and hold the DOOR unlock switch.
  4. While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
  5. Release the DOOR unlock switch. The doors will lock and unlock to confirm the program mode.
  6. Press and hold the LOCK button and the UNLOCK button simultaneously on one keyless remote. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
  7. Repeat the previous step to program up to four transmitters.
  8. Turn the ignition switch to the RUN (one more click forward) position in order to exit the keyless entry transmitter mode.
  9. Operate the transmitter functions in order to verify correct system operation

Apr 19, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Reprogram keyless entry


It took me a few attempts to program a new keyless remote for my 2002 Chevy Blazer.
Insert key into ignition but don' turn it yet. While holding down the UNLOCK switch on the door, the trick is to cycle the ignition ON OFF ON OFF as quickly as possible then release the UNLOCK switch. If done correctly the door locks will cycle 1x to acknowledge. Then hold both the unlock and lock buttons down on the remote for about 15 seconds. The locks should cycle again to confirm...Hope this helps.

Mar 19, 2009 | 2002 Chevrolet Blazer

2 Answers

My chevy drives for 45mins then shuts off


Your ignition module is bad. Known to stop working when it gets hot and work again after it cools off. Replace it. Good luck

Feb 10, 2009 | 2001 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

289 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...