Question about Cars & Trucks

Open Question

Polo playa 1.4 1999model, change lifters I still have the lifter noise, that to do?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 15 Answers

SOURCE: 89 Ranger 2.9L 150k mi. Lifter noise, power lose, oil pres zero

the lifter noise might have been a bearing going bad or a piston ring. if you lost power you probably lost compression on one cylinder. Try checking your compression with a compression tester screwed into your spark plug socket. here is a site with a procedure.
http://www.automedia.com/Engine_Compression_Test/ccr20050801cc/1

Posted on May 18, 2009

Ad
  • 6 Answers

SOURCE: lifter making noise

The hydraulic lifters depend on small channels that can get clogged. Had lifters replaced and tap remained. Decided not to spend hundreds more once audi mechanic discovered the fix (reopen head and **** oil channel). Changing oil and filter frequently helps quiet the lifter.

Posted on Jul 31, 2009

Elradiuzi
  • 127 Answers

SOURCE: lifter noise on a 4.8 liter chevy motor. do i need

You usually don't need to pull the heads. I'm not exactly familiar with that engine but 50% of the time you can get a magnet and pull them out through the valve covers. But to make sure it's the lifters. Let it run until it's warm and remove the valve covers. You at that point should push with your finger on the push rod side of the tappet. If one of them ticks (you will be amazed you just did it with your finger) thats the bad one. However the whole cause of the problem with hydraulic lifter is oil pressure. The 0-ring seal between the oil pump screen and the oil pump may be cut, causing aeration of the oil. Thus lowering oil pressure causing the tick. It is normal for some LIGHT ticking to occur in the 4.8L and some noticeably louder ticking on startup. Good luck!

Posted on Jun 28, 2010

  • 92 Answers

SOURCE: how to solve engine lifter tick noise

Get the heads worked on or replaced it might need a valve lashment.

Posted on Jul 01, 2010

  • 63 Answers

SOURCE: Loud lifter noise

Over time and miles the lifters tend to collapse and the only way to quiet the noise is to replace them or use something like lucas to try to keep the pressure up in the lifters. If you did replace the lifters it would help with performance because when the lifters start to collapse the valves do not open all of the way. Hope this helps!

Posted on Jul 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My engine has intermittent lifter rattling what could be the problem


Chevy Vortec lifter & valve tap how to repair it - YouTube

? 10:08
https://www.youtube.com/watch?v=KPAMIeeY-q8
May 22, 2012 - Uploaded by AdirondackNY
this video has info on how to fix a severe valve tap or sticky lifterusing 1 quart of ... Chevy 5.3 liter lifter noise and motor flush solution How to ...

4.3 engine knock lifter or bearing? - YouTube

? 1:22
https://www.youtube.com/watch?v=oSbyAbS6e2c
May 27, 2010 - Uploaded by jerjer0241
any idea weather its a rod bearing or a lifter or even summin else? the service engine light is on because i have the air intake off. Just did an oil change ... ... Up next. Engine Knocking or Ticking?!? This Could Be Your "FIX" ...

Ticking Noise From Valve Lash Adjusters Due to Infrequent ...

repairpal.com > Problems > Mazda > Mazda6


Jan 19, 2016 | Cars & Trucks

1 Answer

How to stop lifters from tapping for 1997 lincoln towncar?


Lifter noise is typical of an oil pressure issue, or when oil channels are clogged from infrequent oil changes.
You can start by changing the oil and REPLACING THE FILTER. Marvel Mystery Oil or other oil treatments will help clean the oil system and quiet the lifters. If an oil change and crankcase oil additive helps quiet the noise, change your oil every 500 miles for at least 2000 miles, and the lifter noise is likely to stop.
Are you getting a CHECK ENGINE light, or an OIL PRESSURE warning? Have ODB codes checked, and be prepared to replace the oil pump or oil pickup tube, especially if the car has over 150,000 miles. Once you have correct the issue, change oil more frequently.

Jul 21, 2014 | Lincoln Town Car Cars & Trucks

1 Answer

Lifter problem on a Honda odasey 2000


lifter noise could be oil too thin contaminated with coolant or gasoline in which fuel mixture too rich.replace oil filter change engine oil if lifters noise continue valve lifters and camshaft need replacing.

May 14, 2013 | Cars & Trucks

1 Answer

2002 polo playa all belts changed serviced.car still sluggish.what's the cause of car still being sluggish?


I just bought a polo playa 1.6 from a personal owner and I want to do a
major service on it how much am I looking at to service it?

Mar 31, 2012 | 2004 Volkswagen Polo 1.4

2 Answers

I have a 2000 Yukon that appears to a bad lifter


sounds like you have either a stuck valve, or a failed lifter or a bad plug wire, if you have a high amount of miles I would lean towards the lifter or the valve itself you need to get a compression test done both wet and dry, look on your plug wires for any signs of resistance like white dots that is resistance find it's own path

Jul 27, 2010 | 2000 GMC Yukon XL

1 Answer

Is installing new lifters in a 2003 4.0 hard for


NOISE ON START UP DONT MEAN OVER HAUL TIME.FIRST MAKE SURE YOU ARE USING THE RIGHT OIL WEIGHT.DO A OIL CHANGE AND CHANGE OIL FILTER IF IT HAS BEEN A WHILE.I NOTICE PEOPLE WITH NEW CARS COMPLAIN ABOUT LIFTER NOISE. SOME GUYS HAS PUT A LIFTER QUIETNER IN THEIR OIL DURING A OIL CHANGE. PUTTING LIFTERS IN A ENGINE.YOU HAVE TO HAVE AT LEAST SKILL LEVEL CODE B MEANING YOU MUST HAVE BASIC KNOWLEDGE OF COMPLEX SYSTEMS.

Sep 25, 2009 | 2003 Jeep Wrangler

1 Answer

Noisey tappets on citroen c5, just fitted new silencer.


WELL NOISEY LIFTERS CAUSED BY DIRT TRAPPED INSIDE THE LIFTERS OR NOT DOING OIL CHANGE OIL IS DIRTY.LOW OIL PRESSURE CAUSES LIFTER NOISES.WORN LIFTERS ALSO CAN CAUSE NOISEY LIFTERS.

Sep 18, 2009 | Peugeot 405 Cars & Trucks

1 Answer

Noise motor on 03 santa fe a guy told me it sound like the lifters but i want to be for sure


Hi if your getting a tapping noise on the top of the engine then yes it's the lifters making the the noise but before changing the lifters check that oil pressure is where it's suppose to be and that the oil is circulating and you have a good amount of pressure getting to the lifters if that's ok then replace lifters good luck

Sep 02, 2009 | Hyundai Santa Fe Cars & Trucks

3 Answers

Lifter making noise


depends, how long between oil changes, how many miles, try and engine flush, sometimes debrise adn sludge will cause a lifter to stick and not move freely causing the tapping noise you hear, if this doesn't fix or quiet the problem it may be to far gone, but if you really love the car get a tear down manual and go to work....put aside a weekend and about 500 dollars it'll be a job

Nov 12, 2008 | 1992 Audi 100

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...