Question about SsangYong Cars & Trucks

Open Question

SsangYong Actyon Driver door will not open from inside! All other doors will by remote, Handle out side works. Could this be mechanical problem or electronic you think?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
maklean
  • 1665 Answers

SOURCE: door handle

942f95a.gif
Door inside hande may is disengaged Remove door inside panel to inspect.

Posted on Jul 13, 2008

Ad
warlock61
  • 659 Answers

SOURCE: Driver side door lock seems mechanically "stuck"

there are several screws you have to remove remove the trim piece around the inside handle the panel lifts off dont pry it off or it will break the door latch usually binds and has to be replaced

Posted on Mar 09, 2009

  • 20 Answers

SOURCE: Front driver door won't open from the inside only

The linkage is probably broken or snapped out of place from inside the door panel.
You'll feel that the handle is much easier to move than the other doors.

If you are confident and able, take the door apart removing the screws and snap pieces and look for the missing linkage. It's usually a snap piece that holds a rod in place on the back of the handle. They break all the time, or dry rot, or jarr out of place. They're easily available at your local auto parts place or even dealership for just a few bucks!

Good luck!

Posted on Jul 30, 2009

  • 1 Answer

SOURCE: Rear pass. door locking mechanism

I have been dealing with the same problem and I'm a little further than you are. You need two people to do this job. Open the front door and it will give you access to the hinge pin. If I remember correctly you can pop off the snap rings and pull the pins. This will allow you to open the door just enough to get the interior panel off the door to allow you access to the actuator. Unfortunately, both my rear door actuators have been done twice in the last 5 weeks, But they are seized in the locked position again. I,m pretty sure its not just the actuators that are bad. Something else is causing this and that is why I'm here. Good luck with that one.

Posted on Aug 28, 2009

  • 1 Answer

SOURCE: BMW X5 2001 -DRIVER OUTSIDE DOOR HANDLE WILL NOT OPEN DOOR.

DRIVER OUTSIDE DOOR HANDLE WILL NOT OPEN DOOR. FROZE UP IN ICE STORM AND APPEARED TO BREAK WHEN TRIED TO OPEN DOOR. INSIDE HANDLE STILL WORKS. IS DIY REPAIR FEASIBLE?

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 Hyundai Elantra SE - Driver side rear door won't open from the inside or outside.


You will need to remove the inside door panel, what that takes I don't know, but it must come off to access the door latch, there you will likely find the latch release control rod has come off or the latch is defective.

Jun 20, 2017 | Hyundai Cars & Trucks

1 Answer

2008 ford fusion driver side door will not open from the inside


You will need to remove the door handle, but you may have to pull the door trim plate first. Pull the handle assembly outward and inspect it to make sure the inner door connector rods are attached. These are held in place with plastic pieces, and plastic parts on the door handle. Replace the handle if the rod loop is broken. Replace the door rod ends with new hardware. This can all be done in your driveway, and requires very little mechanical knowledge or skills.

Jan 02, 2013 | 2008 Ford Fusion

1 Answer

Driver side door handle not working. Can open door from inside but not outside...outside door handle must be broken. Remote works to lock and unlock door. Need to be able to get into my car from the driver...


your linkage rod to the outside door handle has disconnected , if you open up the door panel to access the lock linkage rods you will find the rod that is disconnected . There is a plastic bushing the rod is secured with if it is broken you must replace it , if the rod will not stay in place replace the bushing , hope this helps you out

Jul 31, 2011 | 1999 Oldsmobile Aurora

1 Answer

Driver side door is jamed shut. ouside door handle and inside door handle broke. can't open door. how do i get the door open or can you take inside driver side door panel off with door closed?


i don't know about taking the panel off with the door closed, but you should be able to remove the inside handle. there should be just one screw holding it in it should be right in the middle usually it is covered with a plastic cap. once you get the handle off manually pull the mechanism and open the door.

Apr 18, 2011 | 1999 GMC Suburban

1 Answer

Driver side door wont open from outside


Fortunately, it means that the mechanicals of the door opening device are working right, if you can open from the inside. The rigid wire that connects the outside handle to the door opening mechanism became loose, or a plastic connector broke. Disassemble the door panel, reach the handle from the inside, and see if there is a thin rod dangling somewhere, and if not broken, just put it back in place.

Jan 10, 2010 | 2008 Audi Q7

1 Answer

2003 Nissan Maxima driver side door will open from outside door handle, but will not open using inside door handle.


You have a problem with the linkage that goes from the inside handle to the door mechanism. You need to take off the door lining and make an inspection. It could be a broken clip, spring, retainer or a little over centre mechanism that has seized up. Should be an easy fix once you can see whats happening with the door liner off.

Sep 11, 2009 | 2003 Nissan Maxima

1 Answer

I have a 99 528i, driver side door won't open from inside or out.


to be honest i would need the car in front of me to diagnose correctly but from the sound of it the mechanism inside the door is worn,the lever that springs open the jaws has worn to the extent that it will not push the two contacts inside the lock open to allow the door pawl to swivel around releasing the door.Only way is too remove the door trim if you can and operate the mechanism with a big screwdriver to open the door then renew the mechanism

Mar 08, 2009 | 2008 BMW 528i Sedan

1 Answer

Driver side outside door handle does not work


the trim should just pop off with a screwdriver but make sure you have all the screws taken out first

Jul 03, 2008 | 1997 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top SsangYong Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

terry stevens

Level 3 Expert

991 Answers

Are you a SsangYong Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...