Question about Cars & Trucks

1 Answer

Mitsubishi Repair A/c leak where the low pressure line is put together, can it be fixed?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 198 Answers

If it is at a junction there are o rings that are serviceable. If not you can remove the line, aluminum can be repaired as well as the rubbed section of the line

Posted on Oct 22, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is it possible repair leaking a/c low pressure pipe


No you need to replace the low pressure line.

Jul 17, 2016 | Peugeot Cars & Trucks

1 Answer

My 93 galant have low fuel presure at mornings so hard to start


If the pressure is low then you have a leak down (fuel in the lines leaking back into the tank) Early signs of fuel pump failure. Put a pressure gauge on the fuel rail and make sure the pressure is in fact dropping before you spend money to replace the pump.

Oct 13, 2012 | 1992 Mitsubishi Galant

1 Answer

1999 mercury cougar power steering leak


it depends if it is your high pressure or low pressure line if it is the high pressure line you can purchase at an auto parts store for about $60-$70. If it is your low pressure line good luck finding a replacement. But what I did that cost me about $5 was buy a gas line that fit and a couple clamps and I cut out the section with the leak and installed the gas lin in its place. But remember you can only do that simple fix with the low pressure line.

Sep 05, 2012 | 1999 Mercury Cougar

1 Answer

Is there a quick fix for a leak in the power steering hose?


It depends, if it is the low pressure hose held on with regular clamps... then those are generally cheap from a local auto store... you may also be able to trim it down with a blade and reinstall the clamp.
If it is the pressure line, then no. Those lines are pressurized and they are held together by threaded rubber hose that deteriorates over time. Not to mention the clamps are machine pressed and you cannot replace them. In that case, the line would have to be purchased and replaced.
Goodluck

Mar 27, 2011 | 1997 Dodge Grand Caravan

1 Answer

I have a 1997 chevy blazer that has a brake fluid leak just underneath passenger rear seat on drivers side and cannot find how to see what the heck is leaking what is the best procedure to figure out what...


you most likely have a brake line rusted threw, cut the line ahead of the leak and after the leak and splice in a new piece of brake line, it will have to be steel, you can not use rubber. if you take the line to a parts store they can size it up and get you a piece of steel line and some pressure fittings to put it back together, after you repair the line then you will need to bleed the rear brakes.

Feb 17, 2011 | 1997 Chevrolet Blazer

1 Answer

I have a twisted and leakin fuel line The leak is between the tank and the fuel filter, what is the easiest way to fix this?


The easiest way is to cut it out and replace it with a piece of steel brake line and a pair of compression fittings. Use a small tubing cutter to cut out the bad piece and clean up the ends with some emery cloth so that the ferrule will slide on the old line. Don't forget to put the nut on first.Put it together loosefirst and make sure you push the lines all the way into the fittings before you tighten the nuts. IT could leak if you don't but don't overtighten them or you will squash the line. If you can't get the old line smooth enough to slide ferrules on then get some rubber gas hose and clamps. Be sureto push the steel lines together before you tighten the clamps because the line is pressurized. You may have to double clamp the lines to prevent leaking. Once you have it together start the truck and crawl back under and check for leaks. Tighten what is leaking enoughto stop the leaks and you are good to go. Don't forget to bring a pail to catch gas when you cut the line. Hope this helps.

Jul 05, 2009 | 1988 Chevrolet Blazer

1 Answer

I need to put R134a in my montero and can`t find the low pressure


The low pressure line is the larger line out of the two and the cap is larger then the high side. follow the two line from the fire wall to the compressor and evaporator.

Good luck and hope this helps. keep me posted if you still can not find it.

May 25, 2009 | 1994 Mitsubishi Montero

2 Answers

Very bad oil leak around oil pump, very low oil pressure


maybe u should try changeing the oil pump before u tgo any change the motor

Mar 15, 2009 | 1994 Mitsubishi Eclipse

1 Answer

Repair/Replace 1994 Isuzu Rodeo Fuel Line


Is the line plastic or steel? They make repair kits for plastic lines, if you can find them. They are hard to find. If it is a steel line, you can go to the parts store and buy a pressure fitting. Cut the line and put the pressure fitting on. If it is the end of the lines, where they hook together or hook to fuel filter, it could be bad O-rings. Need more info.

Nov 16, 2008 | 1994 Isuzu Rodeo

2 Answers

Power Steering Leak. 1986 Toyota Cressida


The power steering system is very simple check all of these and you will find it. the pump has a high pressure line and a low/ return line. check for leaks in the line fill-up with fluid with some ne inside turning steering when looking for leaks if none in line check rack and pinnion/gear box. Its just (4) components to check Pump, reservoir, Lines(pressureline/ return line) rack and pinion. Good Luck

Nov 15, 2008 | 1986 Toyota MR2

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13723 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...