Question about 1995 Dodge Intrepid
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1995 dodge intrepid
The ignition switch is faulty if the gauges and dash lights will not come on, change the fuses first. Transmission fluid and filter change needed. Differential gear oil change also needed.
Posted on Nov 08, 2008
Naturally you need to remove the tire then the brake caliper. After the brake caliper is removed then you need to remove the 34mm axle nut that is inside the hub. After that is removed then you can remove the hub. Becareful not to damage the hub seal on the back or you will have to buy a new hub (100 or more). Then you need to remove the strut knuckle assembly. Once the knuckle assembly is removed then you can pull the CV axle. Take care the inner CV housing is held in place by an inner snap ring. You will probably have to pry off the inner housing. Once the axle is off then install the new axle (if you buy complete axle). Make sure if you are doing both that you take care which side you are installing. I made that mistake and double the work. Slide the new axle on the spline and make sure it is seated completely. Then put back together the reverse of removal.
Posted on Mar 24, 2009
You MIGHT not have to drop the tank. On the 95 LHS (same frame) you can go through the trunk. take the trunk lining out. Underneath it near the back seat there may be an access panel. If so it will make it MUCH easier to replace! Worth the time to check it out!
Posted on Aug 21, 2009
There is a nut in the center of the balancer... loosening may require an "impact" or a sharp blow with a hammer to begin to loosen the nut. Once loose, you can use a harmonic balancer puller (rentable at a local rental yard) Since its a very tight fit you'll need the puller to persuade it loose from the crankshaft.... watch your knuckles...
Posted on Oct 14, 2009
Tips for a great answer:
Jan 01, 2011 | 1995 Dodge Intrepid
May 17, 2010 | 2001 Dodge Intrepid
Apr 08, 2010 | 1995 Dodge Intrepid
Feb 13, 2010 | 1995 Dodge Intrepid
Jan 03, 2010 | 1995 Dodge Intrepid
Oct 17, 2009 | 1995 Dodge Intrepid
Oct 14, 2009 | 1995 Dodge Intrepid
Sep 03, 2008 | 1995 Dodge Intrepid
Sep 19, 2015 | 1995 Dodge Intrepid
35 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: