Question about 2001 GMC Jimmy

1 Answer

2000 gmc jimmy throttle cable is broken how do I fix it?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 32 Answers

The only fix is to replace cable. Fairly easy, there are plastic "tangs" that need to be depressed at the firewall. This will release the cable so it can be pulled through. Follow the cable thru to the pedal. It is just a matter of disengaging at the pedal and at the throttle body connectors. Pay close attention to the cable routing, as incorrect install can be detrimental to operation!

Posted on Oct 21, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 180 Answers

SOURCE: where is my 1 2 shift sensor 2000 gmc jimmy

Inside trans. pan at the rear of the valve body. They have a wire clip which holds them in.

Posted on Jan 21, 2009

  • 599 Answers

SOURCE: Antifreeze leaking from freeze plug

sorry not an easy fix, you must replace the freze out plug by taking out the old one and replace with a new one. needs to be done on a lift not a backyard job

Posted on Apr 08, 2009

  • 1 Answer

SOURCE: 2000 GMC Jimmy won't start

i had the same problem and replaced the fuel pressure regulator. Cost about $45 at advance auto store or about $90 at napa auto stores. Once i replace that my truck started right yup and runs like a champ

Posted on Jul 13, 2009

  • 593 Answers

SOURCE: 1998 GMC Jimmy hood release cable broken

Remove the cable from the latch and any hold downs or clamps. Push the rubber gromet through the fire wall into the car. Remove the handel assy. and pull
the cable assy.out through the fire wall. Now, if the
gromet can be removed. You can decide if you wan't
to put it back from under the dash, or under the hood.
Whatever is easiest for you, but if it can't, it has to go
back from under the dash. Hope this helps.
Good luck.

Posted on Jan 26, 2010

lindsay836
  • 677 Answers

SOURCE: How do you change a 2000 gmc jimmy blower motor?

How do you know the motor is bad ? Have you run 12 volts to it directly ?
We have the parts for you, and step by step instructions :
www.aescompaniesllc.com
Please click on contact us.

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I open the hatchback from inside(or outside) in my 2000 GMC Jimmy if its broken and won't open from the outside?


you will need to remove inside door panel and find rod from handle to latch and pull it and push door

Feb 21, 2015 | 2000 GMC Jimmy

2 Answers

My 2000 GMC/jimmy suv starts up but doesn't respond or rev up whenI push the accelerator pedal


Look for where the throttle cable connects at the throttle body. If you can move the throttle plate here and get the engine to respond, then the cable is either broken or disconnected at one end or the other. Any other situation doesn't seem likely.

Aug 22, 2014 | 2000 GMC Jimmy

1 Answer

Where can i find a fuel injeckter on a 2000 gmc jimmy


Your vehical uses Throttle body injection (TBI). Which is just like a regular caburator, except with 2 injectors inside. Follow the big tube from the air cleaner to center of engine, remove and underneath is your carb and injectors. Hope this helps.

Oct 25, 2010 | 2000 GMC Jimmy

1 Answer

Why does my 2000 jimmy keeping trying to go in to 4lo


i had the same thing happen to me i put a new 4by4 switch and it fixed the problem

Oct 27, 2009 | 2000 GMC Jimmy

1 Answer

My 2000 gmc jimmy will move real slow put the rpm's continue to rise as you press on gas pedal, then you let up off the pedal and press it again the vehicle will move normally, what would cause this?


This problem could be as simple as a TPS (throttle position sensor). Some vehicles are now drive by wire. This means that there is no actual throttle cable. When the gas pedal is depressed, it sends a signal to the CPU and tells how far the pedal has been pushed. How many miles do you have on this? Sometimes a plugged catalytic converter can cause a vehicle to accellerate slowly and cause you to "butterfly" the pedal and make it hard to get over 60-70 MPH. Hope this gives you some ideas.

Jun 15, 2009 | 2000 GMC Jimmy

2 Answers

4 wheel drive problem


Check drive shaft bearings , may be worn or broken. Good luck and thanks for using FIX YA

Jan 26, 2009 | 2000 GMC Jimmy

1 Answer

2000 gmc jimmy wont start


I also had this problem with mine. There's a main power cable that runs to the battery. The bolt was completely corroded, so there was no connection = no power to start the truck. Check that, it'll cost ya less than 5 bucks to fix.

Jan 16, 2009 | 2000 GMC Jimmy

1 Answer

TPS in a 1998 GMC Jimmy


the tps is ususally at the side of the throttle body opposite where the throttle cable / tv cable mount.
sometimes it won't start, run, or run erratically. there are ways of testing this unit (by output voltage) before you commit to buying a new one. to test it you will need a dvom (digital volt ohm meter).

just a note: straight from the book... "a broken or loose tps can cause intermitten burst of fuel from the injector and an unstable idle because the ecm thinks the throttle is moving."

Sep 22, 2008 | 1998 GMC Jimmy

Not finding what you are looking for?
2001 GMC Jimmy Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...