Question about Cars & Trucks

1 Answer

99 Mazda B4000 2-whl drv: "overdrive off" light is flashing. From standing stop, will not shift up unless take foot off accelerator then press to resume (manual shift w/accelerator). Error code indicates "shift solenoid".....What is it & where?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 16,429 Answers

That is most likely inside the transmission. IF the fluid level is ok and all the wires to the transmission are ok, it is time for an overhaul

Posted on Oct 21, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
keemo68
  • 1263 Answers

SOURCE: 95 Lexus ES 300 check engine light is on and the overdrive off light is flashing

chances are you don't have to replace the computer. the reason i tell you this is because you did not mention that the car is running lousy. no complaints of rough idle or missfire or hard starting. chances are that your engine speed sensor which sends the signal to the computer which then controls the transmission is most likely the culprit.. and it could just bhe that there is a loose connection between the two. if that is ok then your transmission control module is faulty. this is not the main computer, but the gobetween the trans and the ecm.. hope this helps please rate this...thanks(btw....the knock sensors control timing not the trans mission)

Posted on Sep 03, 2008

emissionwiz
  • 77202 Answers

SOURCE: hard shift and blinking overdrive

The blinking overdrive button is telling u that a serious fault has occurred in the electronic controls or a mechanical fault such as excess slippage is occurring.

Posted on Nov 06, 2008

emissionwiz
  • 77202 Answers

SOURCE: i was getting a po755

this code can be caused by worn out transmission fluid, I recommened you have the fluid and filter changed and clear code

Posted on Nov 05, 2009

gordanddar
  • 477 Answers

SOURCE: not shifting into overdrive and check engine light

I'm not a lexus guy , but I'm thinking that you have a vacuum leak somewhere.

Posted on Nov 06, 2009

  • 1 Answer

SOURCE: shift solenoid not engaging overdrive which

solenoid C

Posted on Dec 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I shifted my 2002 grand Cherokee Laredo sport from 2 whl to 4 whl and now it seems to be stuck in 4 whl when I shift back to 2 whl drv?


its grand cherokee, WJ jeep

if it has quadradrive,
its full time
but do no use 4wd low on pavement with no ice
got this, see the words there?
http://jeepdied.com/QD.JPG

it can also have quadra-trac2, but it has same rules.
missing 4wd low. requires no driver inputs.
(means full time)

first learn what is there (they are options,)
this 4wd system
then look it up
here and read

https://en.wikipedia.org/wiki/Jeep_four-wheel-drive_systems


post a photo of your stick shifts, related
and its obvious what your car had new, in 4wd.

ok.
check all fuses
then scan it.
using any OBD2 scan tool, modern.
that is first.
if the scans tell you there are problems
then work them or ask for help
or read the service manual on 4wd diagnosis.
or get it serviced.

Dec 13, 2016 | 2002 Jeep Grand Cherokee

1 Answer

How to switch on overdrive for mazda demio aletta


lots of mazda vehicles have a small button on the shifter, usually on the side or somewhere not very visible. Generally overdrive is actually ON and pressing the button will turn on a light that indicates Overdrive is OFF. since overdrive is kind of a passing gear - if you are going uphill or towing something and do not want the vehicle to shift to a higher, larger gear, you would turn overdrive OFF .

Jun 06, 2014 | Mazda B-Series Cars & Trucks

1 Answer

99 ford contour with flashing OD light and transmission shifts narly, also sounds like its stuck in 3rd gear and refuses to shift into 4th


normally most overdrives wont work unless proper fluid levels are maintained..check fluid level on stick and add to full..if still having issues, replace filter in trans pan and refill to full.if still having issue time to replace..good luck

Jan 17, 2013 | Ford Contour Cars & Trucks

1 Answer

99 protege 1.6.when put car in reverse it engages harsh and o.d. light flashes and engine light comes on code 0123. tried a new t.p.s. sensor and had same problem


that is your 3 and 4 shift solenoid in the transmission. it is stuck open and needs to be replace. it is very easy to do.

Jan 03, 2013 | 2000 Mazda Protege

1 Answer

1995 Mazda 626 won't shift into overdrive and overdrive light keeps blinking


Thats a sign you transmission is going bad when light flashes or may need a flush and new filter

Jan 04, 2011 | 1995 Mazda 626

1 Answer

04 Envoy xuv 4 wh. drv. stays in 4 wh drv. HI


Try putting your transmission in neutral and slowly shifting the 4wd selector to each position but you have to wait a few seconds between selsctions as it has to go through your vehicles computer, shifting to fast will cause your symptoms. I hope this helped you out. Roger

Feb 08, 2010 | 2004 GMC Canyon

1 Answer

Hard shift and blinking overdrive


The blinking overdrive button is telling u that a serious fault has occurred in the electronic controls or a mechanical fault such as excess slippage is occurring.

Jul 16, 2008 | 2000 Ford Ranger SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...