Question about Toyota Celica

Open Question

1987 toyota celica gts oil pressure fluctuates and have oil blowing by my spark plug wires please give your opinion on cause of problem

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2001 Toyota Celica GTS Clutch

i paid a friend to do it because it's a lot of work! if you haven't already treid to or got it done just know that when my friend did it; it took him like 8 hours (he'd never done one on a celica, but had done them on american cars) so if your not familiar with it... not a good idea to do alone. I watched him do most, but i'm not the best to talk to about it.(plus i have a 2000GT) Some of the parts that i can remember that he took out to get to the clutch were the front driver's side tire, the axel on the same side, ....some other parts in there....and ALSO parts on top...the intake also had to be taken out just to have enough room to do the job. parts are cheap...just ask for a clutch kit at auto zone or whatever. around $150. another random tid bit that might help is make sure to tighten the engine mounts really good afterwards or else it will jump around in there when you turn it on and cut it off. buy gear oil before you start as well because you will need to put some in after the new clutch is in. i will need to put the car on a real lift... you need a lot of space underneath and on top to work. and most likely two people. well hope some of this helped.

Posted on Sep 06, 2008

  • 1 Answer

SOURCE: 1985 convertible celica fuse location

Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.

Posted on Nov 03, 2008

ginko
  • 19396 Answers

SOURCE: fluctuation on the oil pressure gauge reading

The oil pressure sending unit is a sensor with an internal diaphragm, if the internal diaphragm is damaged , or the line to the diaphragm is blocked you can get this kind of fluctuation on the oil pressure gauge.

The oil pressure value must be read by installing a mechanical gauge near to the oil pressure switch and checking the pressure.

If pressure is ok, replace the sending unit. If there is a real pressure drop, check the oil pump.

If you still get fluctualtion after replacing the oil pressure sending unit, replace the oil pressure gauge.

Posted on Nov 24, 2008

johnjohn2
  • 5763 Answers

SOURCE: Toyota Celica gts 2000 blowing cold air when heater is on.

nothing try back flushing heater core, they clog up due to litle water preasure,you might want to flush cooling system if you already havent, hope this hleps.

Posted on Oct 06, 2009

c17hydro
  • 2984 Answers

SOURCE: How to instal serpentine belt Toyota celica 2001

Removal & Installation

  1. Remove the right hand cover under the engine.
  2. Turn the drive belt tensioner clockwise to relieve tension on the belt.
  3. Remove the fan and generator V belt.
  4. Return the tensioner to the unloaded position.

    NOTE When retracting the tensioner, turn it clockwise slowly in 3 sec. or more. Be sure not to apply force rapidly. After the tensioner is retracted all the way, do not apply force any more than necessary.

To install:
  1. Turn the drive belt tensioner clockwise
  2. Install the belt.
  3. Install the right hand cover under the engine.

Posted on Feb 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wont run anymore


more than likely a earth problem or wiring problem check connector plugs in engine bay by unplugiing and reconnecting

Jan 15, 2014 | Toyota Celica Cars & Trucks

1 Answer

Intermittent or no heat in 87 Celica GTS. Has anyone done the solder fix as described by Rick89gts? Where are the solder points for the 87 celica?


Can you send a link to it? Sound like he had an electronic problem since he was soldering. Do you also have an electronic problem?

Dec 09, 2013 | 1987 Toyota Celica

1 Answer

Were is the fuse box inside the 1987 toyota celica gts?


Try looking under the hood around the driver side by the wheel well. Or on the driver side under the steering wheel, or slightly to the left of it.

Jul 11, 2012 | 1987 Toyota Celica

1 Answer

I have a 1987 celica gts hatch back...and my close button and down button doesn't work for my sunroof but the open and up does and it stuck opened....how can I fix this or close my sunroof before it...


Some cars have a small plugged hole in the ceiling above the back seat. You can use an allen wrench there to close the sunroof..

I know Acura has it and several other cars. Try looking around on the headliner.

Hope this helps you

good luck

Jun 29, 2011 | 1987 Toyota Celica

1 Answer

My son has 1987 Toyota Celica ST with a 3S-FE engine. It sometimes has acceleration issues. For lack of a better word, it jerks while accelerating. But it only does this at times. Other times it works...


Same problem happened to my 1993 Nissan 240SX SE Hatchback. Turned out to be the flywheel for some odd reason. Try that! Also in my opinion it could be bad spark plugs or a clogged fuel filter. Usually those would be the main reasons.

Mar 31, 2017 | 1987 Toyota Celica

1 Answer

I have a 2002 toyota celica gts, and just recently the check engine light came on. I had my friend read the code, and it came up as 301, misfire in cylinder 1. To try and diagnose the problem, I switched...


rotate the wires swap #1 with the "bad" one if you can, before you spend money on a new set of wires. This problem usually is caused by: either a broken sparkplug
carbon wire coreor, a mis-alined reluctor.

Jul 29, 2010 | 2002 Toyota Celica

1 Answer

Toyota Celica gts 2000 blowing cold air when heater is on.


nothing try back flushing heater core, they clog up due to litle water preasure,you might want to flush cooling system if you already havent, hope this hleps.

Oct 06, 2009 | 2000 Toyota Celica

1 Answer

1987 toyota celica st a/c light blinking and compressor does not come on blows hot air


with out asking a lot of questions I WOULD SAY that a/c system needs regasing low gas levels give that exact symptom

Aug 30, 2009 | 1987 Toyota Celica

1 Answer

1985 convertible celica fuse location


Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.

Jul 12, 2008 | 1985 Toyota Celica

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...