Question about Chevrolet Malibu

1 Answer

Replace flywheel i am a mechanic know the low down just wondering if i could get a rough book time on this job flywheel on 1999 chev malibu auto

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 1,250 Answers

I would say 3 or 4 hours if you know what to do

Posted on Oct 22, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 350 Answers

SOURCE: repeated broken flywheel/flexiplate

hi when you drove the car before was the box changing the gears ok if not it puts extra tension on the retaining bolts or did the flex plate break around the crankshaft and how do you drive the car if you like to set off fast it will have the same effect and did you change the converter as well yates210456

Posted on Oct 18, 2008

awcforever
  • 359 Answers

SOURCE: Price of timing chain replacement job?

It may cost "close" to $800 at some shops, I have seen $550 as well. But that is the basic range. I believe they put 6 hours on it. It really all varies, but thats what your looking at. If its above $800, don't do it. $800 is definitely a max. Any more than that, and you might as well spend $1000 for a new motor. Hope that helps!

Posted on Mar 12, 2009

  • 3640 Answers

SOURCE: replace blower motor resistor unit on 99 Malibu ?

the blower motor resistor is below glove box. remove panal under box. slide the pcm out of the way, resistor is beside blower motor. unplug wiring, take out screws holding it in then pull straight out to remove.

Posted on Jan 05, 2010

reisdos
  • 1297 Answers

SOURCE: Fan belt broke on my son's 2000 Chev Malibu -

yes... easy

you should have one belt called a serpentine

here is the 3.1 routing
e88cb98.gif

here's the 3.8 routing
fade3e8.gif

Posted on May 15, 2010

wiedmerf
  • 18 Answers

SOURCE: I have a 1999 Chevy Malibu and the symbol that I'm

this is your radiator signal that the radiator is low on antifreeze probably due to a slow leak or just possible evaporation over long periods of time w/o checking the anti freeze reserve tank and or radiator

Posted on Feb 28, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Asking about timing chain


I'm going to assume you have the V6 engine. I would want to know what the trouble codes are in the computer to cause the check engine light to come on.
It could be a problem with the cam or crank sensor.

Jun 08, 2013 | 1999 Chevrolet Malibu

1 Answer

How to replace a flywheel on a ford five hundred


Remove the inspection plate and undo the bolts attaching the torque converter to the flex plate Remove transmission If you are not familiar with that procedure give the job to a mechanic. Remove the clutch if not auto again know how to replace clutch pressure plate and clutch plate. Something tells me that the flywheel isn't stripped but the flexiplate has fractured as it is unusual for the teeth of the ring gear to be completely stripped. Moving on use an impact gun to undo the bolts holding on the flywheel/flex plate Installation is reverse to removal. But I recommend you have good advice handy to do this job

PLEASE RATE THIS REPLY FOR ACCURACY

Mar 23, 2013 | 2007 Ford Five Hundred Limited Sedan

1 Answer

1999 Chev K2500 Suburban (Old Body) 5.7 / auto started running rough at accelleration, under slight load (hills, trailer, starts). No codes or MIL light. Replaced plugs & wires (only owned truck for...


If you can determine the ignition system is ok, I would look at fuel pressure and the fuel filter. If the distributor was loose you may have to check base timing.

Dec 05, 2012 | Cars & Trucks

1 Answer

98 Malibu 2.4


install vacuum gauge at intake manifold and get back with me. should be stedy around 19-21 inchs vacuum. if bouncing you have a valve or lifter stuck or burnt valve.. a c.l.t. should confirm the valve condition

Aug 30, 2012 | Chevrolet Cars & Trucks

1 Answer

I have a 1999 Chevy Malibu and the symbol that I'm


this is your radiator signal that the radiator is low on antifreeze probably due to a slow leak or just possible evaporation over long periods of time w/o checking the anti freeze reserve tank and or radiator

Feb 28, 2012 | 1999 Chevrolet Malibu

1 Answer

Where is the low presure port on the 1999 chevy malibu


it is on the passengers side by firewall underhood about 2 feet down from alternator. you can buy a extension hose because it is to close to alternator. they have these hoses at auto-zone and most auto-parts stores. they are about 14-15 inches long. have a good day !

May 29, 2011 | 1999 Chevrolet Malibu

2 Answers

Changing the water pump in the 1999 oldsmoble alero involve the timing chain? and is it easy to chance it?


YEP THE 2.4 ENGINE YOU HAVE TO REMOVE TIMING CHAIN TENSIONER AND TIMING CHAIN.THIS JOB NOT EASY OR HARD BUT IF YOU NEVER DONE ANY KIND AUTO MECHANIC WORK BEFORE JOB WILL BE HARD.IF YOU WANT TO TRY IT.BUY A HAYNES REPAIR MANUAL READ THROUGH IT.THAT WAY YOU KNOW WHAT YOU HAVE TO DO TO REMOVE AND REPLACE WATER PUMP.

Sep 21, 2010 | 1999 Oldsmobile Alero

1 Answer

Replacing a Daytime Running Light in 1999 Chev Malibu


yes you can just be careful no to touch the new bulb , the oil from your fingers will cause it to fail prematurely.

Apr 25, 2010 | 1997 Chevrolet Malibu

3 Answers

Leaking coolant at intake gasket area but not into oil


$400 is a very good price for it, very long process. Took my mechanic 6 hours on my 99 Malibu, have to remove the head. $700 for my malibu

Dec 02, 2008 | 1991 Chevrolet Corsica

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...