Question about Dodge Cars & Trucks

Open Question

Airbag trouble codes U0171 - Dodge Cars & Trucks

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can autozone pull the fault code for a 2009 Cadillac Escalade Service Airbag light


No, the scan tool that autozone uses will only get to the engine trouble codes. It will not access the airbag or antilock brake, or transmission codes.

Aug 26, 2014 | 2009 Cadillac Escalade

1 Answer

Airbag trouble codes


I would not recommend attempting to service the airbag system yourself, and if the AIRBAG light is illuminated there is a strong possibility that the air bag will not deploy in the event of an accident.
HAVE THE AIRBAG SYSTEM SERVICED BY A QUALIFIED TECHNICIAN.

Jul 23, 2014 | 2003 Lincoln Town Car

1 Answer

Toyota tundra 2007 airbag wiring diagram


Did you have the body computer scanned for trouble codes ?

Aug 04, 2012 | 2007 Toyota Tundra

1 Answer

P0012,p0013 air bag 2008 chevy hhr


Here is a complete diagnostic trouble code trouble, in which you may find the answer. By the way, you can also get some airbag reset tool to reset your airbag. Airbag is a very important protection tool. Chinasinoy supplies various kinds of diagnostic tools, including airbag reset tool.

Aug 01, 2012 | Chevrolet HHR Cars & Trucks

1 Answer

Airbag light stay on when you driving the ford escape


You need to access the Airbag ECU (Electronic Control Module) using suitable diagnostic equipment connected to the data link connector of the car in order to erase all faults - DTC (Diagnostic Trouble Codes) memored, unlock and reset the Airbag ECU. Then the Airbag light will turn OFF after approx. 4 seconds, ignition ON.
Good Luck!

Oct 25, 2011 | 2004 Ford Escape

1 Answer

ABS light comes on... but no noticble degradation in operation etc.


Most likely a wheel speed sensor, hopefully... The only thing that will change when the ABS light is on is that the ABS will not function as long as the indicator is on. I hope this info helps.

When the airbag system is in functioning condition, the airbag warning light will remain on for about 7 seconds and go out when the ignition switch is set to ON .

If there is any malfunction, the airbag warning light will either stay on or off continuously. In such cases, perform on-board diagnostic in accordance with the specified procedure to determine trouble codes.


  1. Turn ignition switch ON (with engine OFF ).
85091723



  1. Connect DIAG. terminal to No.2 terminal of diagnosis connector located inside lower cover.
  2. Check in accordance with the trouble code indicated by the AIRBAG warning light, and record the trouble codes.
  3. Turn the ignition switch "OFF " and remove the DIAG. terminal from No.2 terminal of diagnosis connector.
85091724


HOW TO READ TROUBLE CODES
The ABS lamp flashes a code corresponding to the faulty parts.

The long segment (1.2 secs on) indicates a "ten", and the short segment (0.3 secs on) indicates a "one".





NOTE: This is the only information provided by the manufacturer for clearing diagnostic trouble codes.

97511505


CLEAR MEMORY
After eliminating problem as per trouble code, clear memory as follows:

Make sure ignition switch is ON (and engine off). Connect one DIAG. terminal (1) on diagnosis connector (2) terminal No.1.

where warning light is flashing, connect the other DIAG. terminal (3) on terminal No. 2 for at least three seconds . After memory is cleared, normal warning light flashing rate resumes. (Warning light flashes every 0.6 seconds (ON-OFF operation.) Memory cannot be cleared if any problem exists.

After clear memory and then DIAG. terminals (1) and (3), extract from diagnosis connector (2)

Jul 27, 2011 | 1999 Subaru Legacy

2 Answers

Airbag light stays on in a 2003 audi a6 i've replaced airbag module & drivers seatbelt


You need to access the Airbag ECU (Electronic Control Module) using suitable diagnostic equipment connected to the data link connector of the car in order to erase all faults - DTC (Diagnostic Trouble Codes) memored, unlock and reset the Airbag ECU. Then the Airbag light will turn OFF after approx. 4 seconds, ignition ON.
Good Luck!

May 15, 2011 | Audi A6 Cars & Trucks

2 Answers

The Airbag light blinks 4 times ... pauses ... then repeats ... This is intermitent ...


Those are Lamp Fault Codes,they also go with
Diagnostic Trouble Codes

Solution---you can not diagnose that SRS System,
you will need Professional Help

Scanner and a Trouble Chart

Feb 17, 2011 | Ford Contour Cars & Trucks

1 Answer

98 toyota camry srs/airbag trouble code B0106 .i need to know what they are calling a passenger sqibb circuit


The 'passenger side squib circuit' is the wiring that goes from the center airbag computer (under the center console) to the passenger side airbag.

Feb 08, 2010 | 1998 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

196 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...