Question about 2000 Dodge Durango

Open Question

How to replace timing chain on 2001 dodge durango

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2001 Dodge Durango Power Lock Problem

Is this your problem?
http://dodgeram.info/tsb/2003/08-023-03.htm

Posted on Oct 15, 2008

  • 82 Answers

SOURCE: 2001 dodge durango v8 4.7

It is acually called the vehicle speed sensor I do believe. It should should be located on the top of your transmission with a wiring harness attached to it. It should also have 1 bolt holding it in also. Whatever you do, do not rotate the gear when you remove it. Try to mark the exact way it came out when you replace the sensor. When you pull the sensor out it will have this gear attached to it which will need to be placed into the new sensor and put back into the vehicle in the same way it came out or you will throw a code and it will not be pretty. Good luck, hopefully I didn't scare you it can be a simple repair just mind your P's and Q's.

Posted on Jan 07, 2009

  • 1 Answer

SOURCE: my 2001 dodge durango is overheating an leaking coolant from a round plug type thing in the corner on the passenger side near the windshield

What exactly is the "round plug type thing" near the firewall [passenger side]? Is it a sensor of some type? I, too, have a coolant leak here on my 2001 Durango; its tucked in rather tightly near the hood/firewall corner. My electric fan is not kicking on; vehicle overheated tonight. (4.7 liter)

Posted on Dec 28, 2009

  • 249 Answers

SOURCE: replace timing chain on 03 dodge ram 1500 with 5.7 hemi

i have an 02 and i purchased a repair manual from autozone

Posted on Jan 05, 2010

BCAS1298
  • 3092 Answers

SOURCE: how to change a timing chain/belt on a 2000 dodge

You will need all kind of tool's to do this job, tech rating for this job (A), here are some graph for you to look at and get an idea of the job your about to take on,good luck and hope this was helpful.3fc5fcf.gif1628b74.gif9978937.gif

Posted on Jul 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the location of the oil pump on a 2001 dodge durango,4.7 engine


It is in the front area of the engine, behind the timing cover and timing chain. You must remove the oil pan, timing cover, timing chain and tensioner to access it.

Oct 17, 2015 | Dodge Cars & Trucks

2 Answers

Where is the timing chain located on 2001 durango supersport


its on the front of the engine behind the water pump

Feb 28, 2015 | 2001 Dodge Durango

1 Answer

I have a 2001 Dodge Durango my sprockets dots are where they are supposed to be but the white dots on my chain or not do the white dots on the chain matter


I Assume you have a 4.7 liter V8, have you taken the chains or gears off yet, if so, did you line everything up before disassembly and lock the gears with a locking fixture and chock the chains in the guides? yes, all the dots and marks matter. it is an interference engine which means if the cams are out of time with the crankshaft, severe valvetrain/piston damage can result when started. get out the manual and go over all the marks and be absolutely sure everything is exactly lined up before trying to start. turn the engine over by hand at least 2 full revolutions to check for interference , then recheck all timing marks again. before cranking with the starter motor. timing is critical on the 4.7, if its off, bad thing can happen, please take your time and be careful

Oct 24, 2014 | 2001 Dodge Durango

1 Answer

Timming chain setings for my 2001 4.7 dodge durango


make sure you have correct firring order did you put a chain in it?

May 03, 2012 | Dodge Cars & Trucks

1 Answer

NEED TO KNOW WHEN TO CHANGE TIMING BELT OF A DODGE DURANGO 2005


Here's a helpful link for your vehicle, 2.5L engine:
http://www.ehow.com/how_4509007_check-replace-timing-chain-dodge.html

For the larger engines, try this link for info.
http://www.dakota-durango.com/forum/showthread.php?t=67844
From what I read, it doesn't seem that the timing chain is a regular replacement item.

For your question, the forum where this link resides would be a great place to search around. You'd be surprised how many people have already had a similar question. The link to this forum is: http://www.dakota-durango.com/forum

If this has helped, please give me the appropriate thumbs up! Thanks, and good luck!

Aug 15, 2010 | Dodge Durango Cars & Trucks

1 Answer

To install and take it apart/timing replacements? for a dodge durango 2001 4.7 2 wheel drive


What leads you to think your timing chain needs to be replaced? In the 4.7 motor, the timing chain is designed to last the life of the engine, or at least 150K.

May 19, 2010 | 2001 Dodge Durango

1 Answer

Need new tiing chains and gears


if you have to ask then i advise dont even think about it because if you time it wrongly you may bend valves & or smash pitons & thats big $$$$$$$

Jul 20, 2009 | 2000 Dodge Durango

Not finding what you are looking for?
2000 Dodge Durango Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...