Question about 2010 Ford Transit Connect

1 Answer

Hi I have a 2007 ford transit and the power train light is on I have had it checked and there is no fault code the van struggles to start but eventually does,sometimes not very often it loses power,then a few minutes later drives ok can anyone help please

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

If light is on there is a code stored . Use a correct scan tool. No free auto part stuff. Go to a shop get it scanned the proper tool.

Posted on Jan 10, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tommyboinow
  • 324 Answers

SOURCE: changed the gear box on the ford transit van

did you reset the computer after replacing it?

remove the positive battery cable for 10 mins.....

Posted on Nov 26, 2008

  • 3 Answers

SOURCE: I have an 18 month

most likley a sensor...you have a code stored in the computer...need a code reader to figure out problem

Posted on Dec 13, 2008

  • 1986 Answers

SOURCE: 2007 ford e350 van, reverse lights wont work

On the side of your transmission will be a switch with several wires coming out of it. This is your reverse switch that turns on your reverse lights and most likely needs to be replaced

Posted on Oct 01, 2009

  • 1 Answer

SOURCE: ford transit van dashboard display not working

ive got a 55 plate 85 T260 swb crewcab 68000 miles, , i bought it 12 months ago, red light flashes on dash board most days, some times arratically, sometimes quite slow, and all clocks, speedo and dash does not work?????????
the smallest scratch and the van rusts, no under seal, there just a use it and dump it van.

i would just like to say fords are ****

Posted on Dec 12, 2009

alicantecoli
  • 22095 Answers

SOURCE: i have a 2007 ford focus 1.8 diesel and the engine

sorry but the local ford garage are right its got to do it when the mechanic has it ,i would suspect the alternator ,but who knows with these weird faults like this .Best advice i can give here is leave well alone till till it packs up completly

Posted on Dec 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My hane break light and my abs light stays on i have a ford transit lwb van 2004 reg


You must have the system scanned with a special scan tool to see what ABS fault codes are present and then based on those codes diagnose the problem.

Feb 27, 2017 | Ford Transit Cars & Trucks

1 Answer

Ford transit gearbox diagrams


Have the fault codes read. Replace faulty items. Use only genuine items as non-genuine replacement are not always compatible with the OEM fitted CPU units. I suspect servo solenoid faults. Have a pressure test done on the gear box

Jun 11, 2013 | Cars & Trucks

1 Answer

My 2004 sienna hit bumpy corner express road at 45mph, seconds later the whole van shakes like I'm driving on 4 flat tires then vsc and check engine light comes on. The van refuse to move as if I


Hello


The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.


Sep 20, 2012 | 2004 Toyota Sienna

1 Answer

Limp mode 2002 ford transit


Hello
The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.

Sep 12, 2012 | Ford Transit Connect Cars & Trucks

2 Answers

My 2007 ford transit loses power and then cuts out


I have a 2.4 diesel 375 nm model and i have been told that the problem is solved by installing the correct fuel filter. Mine loses all power and stops, and the curly light comes on, and I switch it off and start it again. It works every time but is bloody dangerous on a hill when passing someone and towing a trailer.

Mar 24, 2012 | Ford Transit Cars & Trucks

1 Answer

Got a yellow cog with exclaimation mark inside it on my 07 transit van


Hello! It is the Power train warning light. Reduce speed and have vehicle checked by an authorized ford dealer ship immediately...Guru......Saailer

Aug 16, 2011 | Ford Transit Connect Cars & Trucks

2 Answers

Ford transit van dashboard display not working


ive got a 55 plate 85 T260 swb crewcab 68000 miles, , i bought it 12 months ago, red light flashes on dash board most days, some times arratically, sometimes quite slow, and all clocks, speedo and dash does not work?????????
the smallest scratch and the van rusts, no under seal, there just a use it and dump it van.

i would just like to say fords are ****

Dec 27, 2008 | 2003 Ford Escort

Not finding what you are looking for?
2010 Ford Transit Connect Logo

2,171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...