Question about 2011 Cadillac SRX

Open Question

No remote detected - 2011 Cadillac SRX

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2012 Buick Verano that won't start replaced battery, starter, and battery in remote. Says no remote detected


If all of that died, the remote will have to be reprogrammed. By the way, unless your car has more than 50,000 miles on it, it's still under the factory warranty and the dealership should be doing all of this for free. Your car has a 4-year/50k mile bumper to bumper warranty.

Aug 30, 2015 | Buick Cars & Trucks

1 Answer

Remote start stopped working


could be battery in remote or a system not allowing remote start because it detects a warning light on, jeep does this

Jan 22, 2014 | 2007 Chevrolet HHR Special Edition

2 Answers

How program the key remot


Keyfob remote reprogramming is not very difficult but on some cases it can be done by dealer service tools.If the remote s faulty then keyfob will not get programmed.Insert the key in ignition.Turn the key to on position,and cycle the key three times off-on-off-on-off-on.Then with the keyfob remote select your remote and then try to operate the vehicle with remote.These is just the basic procedure,but sometimes it will not help.
On that case dealer is the only option.
---------There are few very relted troubleshooting links mentioned below for remote key fob reprogramming.I suggest you to go through the list and click the link below to go through its details and procedure:-------
2009 Toyota Highlander: Smart Key Not getting Detected? http://whatisbyme.blogspot.in/2012/05/2009-toyota-highlander-smart-key-not.html
----------2007 Toyota Prius: Reprogram Remote Keyfob? http://whatisbyme.blogspot.in/2012/05/2007-toyota-prius-reprogram-remote.html
----------- Pin that holds the flick key part to the key fob? http://whoisbyme.blogspot.in/2012/07/pin-that-holds-flick-key-part-to-key-fob.html
-------------
2006 Toyota Hilux: Programming New Key? http://technoanswers.blogspot.in/2012/04/2006-toyota-hilux-programming-new-key.html
----------Where is Key chip memory located on 2004 ford Freestar? http://technoanswers.blogspot.com/2012/01/where-is-key-chip-memory-located-on.html
----------Ford Keyless Remote Fob Reprogramming?


http://schematicsdiagram.blogspot.com/2011/12/ford-keyless-remote-fob-reprogramming.html
----------After getting car washed, check engine light is ON and key less entry not working, tried reprogramming. Also car shows fuel pressure? http://schematicsdiagram.blogspot.com/2011/12/after-getting-car-washedcheck-engine.html
-----------Audi A8 Key Fob Programming?


http://technoanswers.blogspot.com/2011/12/audi-a8-key-fob-programming.html

----------------
Oldsmobile Aurora Key Fob Reprogramming?

http://technoanswers.blogspot.com/2011/12/olds-aurora-key-fob-reprogramming.html

-------------
Buick Lesabre Key Fob Reprogramming?

http://technoanswers.blogspot.com/2011/12/buick-lesabre-key-fob-reprogramming.html

---------------
Keyfob remote not working on 2003 Ford E350 Econoline?

http://technoanswers.blogspot.in/2012/01/keyfob-remote-not-working-on-2003-ford.html

-----------
KeyFob will open the doors but not start on BMW?

http://technoanswers.blogspot.in/2012/02/key-will-open-doors-but-not-start-on.html

------------
Mitsubishi Car Key Not getting detected after replacing ECM http://repairhelpcenter.blogspot.com/2012/11/mitsubishi-car-key-not-getting-detected.html
----------- Key Fob will not lock and unlock doors?

http://technoanswers.blogspot.in/2012/02/key-fob-will-not-lock-and-unlock-doors.html

-------------
2000 Jeep Cherokee Limited: KeyFob Remote Not Working? http://schematicsdiagram.blogspot.in/2012/06/2000-jeep-cherokee-limited-keyfob.html
----------- Chevrolet Malibu: Key Stuck in ON position? http://technoanswers.blogspot.in/2012/04/chevrolet-malibukey-stuck-in-on.html
----------- Theft indicator not letting car to start?

http://technoanswers.blogspot.in/2012/02/theft-indicator-not-letting-car-to.html

-------------
2012 Dodge Ram: Ignition Key will not release? http://whoisbyme.blogspot.in/2012/07/2012-dodge-ram-ignition-key-will-not.html
--------------
These details will help.Thanks.

Nov 23, 2012 | 2006 Toyota Tacoma

1 Answer

Can't lock my car with remote key with cover on


A multi-purpose sensor cluster which detects RF and visible light frequencies is usually mounted at the junction of the windshield and the dashboard. This is used by automatic lighting systems as well as remote entry systems. Older vehicles used the embedded windshield antenna for RF detection.

Jun 29, 2012 | Mercedes-Benz SLK Cars & Trucks

1 Answer

I have a 2000 ford mustang. Suddenly my keyless entry remote stopped working. I replaced the battery and turned the off and on 8 times and the locks cycled. after which i pushed the unlock but nothing...


The keyless entry system is controlled by the (GEM) - generic electronic module .
Keyless Entry The electronic door lock system has two main components:
  • generic electronic module (GEM)(14B204)
  • keyless entry remote transmitter (15K601)
  • NOTE: Battery power and ground must be remove before disconnecting the GEM connectors to avoid setting false codes.
    Power Locks Operation The power locks feature allows the customer to lock and unlock the doors via momentary switches located on the driver and passenger door. When the GEM detects a momentary press of the driver or passenger lock button, the GEM will supply power to the driver or passenger lock actuators for approximately 250 ms from relays internal to the GEM. When the GEM detects a momentary press of the driver or passenger unlock button, the GEM will supply power to the driver or passenger unlock actuators for approximately 250 ms from relays internal to the GEM.
    Remote Keyless Entry Door Locks Operation The remote entry feature allows the customer to unlock the driver door, unlock all doors, and lock all doors using a valid remote transmitter as long as the ignition switch is not in RUN or START. The driver door is unlocked whenever the GEM detects a valid remote transmitter unlock transmission. All the doors are unlocked when the GEM detects a second valid remote transmitter unlock transmission within three seconds of the first transmission. All the doors are locked when the GEM detects a valid remote transmitter lock transmission. If the GEM detects a second valid remote transmitter lock transmission within three seconds of the first transmission, the doors will lock again, the horn will sound for 20 ms and the parking lamps will flash for 200 ms to indicate the doors are locked. If the GEM detects the driver or passenger door is ajar during the second lock transmission, the doors are locked again and the horn is sounded twice. If the GEM detects a valid remote transmitter lock transmission within three seconds of detecting a valid remote transmitter unlock transmission, the GEM will lock all the doors
    • The doors do not lock/unlock using the remote transmitter
    • Ignition switch.
    • GEM.
    • Remote transmitter.
    • Remote transmitter batteries.
    • GO to Pinpoint Test C .
    You followed the program instructions to the letter ? Programming -Keyless Entry Remote Transmitter NOTE: All keyless entry remote transmitters (15K601) must be programmed at the same time.
    NOTE: All previous transmitter identification codes (TIC's) will be erased when programming mode is entered.
    NOTE: To program (or reprogram) the keyless entry remote transmitters into the generic electronic module (GEM)(14B204), perform the following steps.
    1. Turn the ignition from OFF to RUN eight times within 10 seconds, ending in RUN. If the GEM has successfully entered program mode, it will lock and unlock all the doors.
    1. NOTE: The first TIC must be entered within 7.5 seconds of entering the program mode and additional TICs must be entered within 7.5 seconds of the first TIC. The programming mode is exited whenever the timing constraints are not met.
      Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed.
    1. If the door locks do not respond for any keyless entry remote transmitter, wait for several seconds and press the button again.
    1. Turn the ignition switch to the OFF position, or wait up to five minutes after step 1, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the GEM will lock and unlock all the doors one last time.
    1. Take an have the vehicle checked for DTC'S
B1396 Power Door Lock Circuit Short to Battery GEM GO to Pinpoint Test B . B1397 Power Door Unlock Circuit Short to Battery GEM

Apr 12, 2017 | Ford Mustang Cars & Trucks

1 Answer

2005 sts wont start. Says no FOBS detected. Please help?


Are both FOBs doing this? If it's only one I would replace the FOB battery.
NO FOBS DETECTED Message on DIC, No Crank/Start Unless Fob in Center Console Pocket or Remote Keyless Entry (RKE) Button Inoperative (Replace Remote Control Door Lock, Theft Deterrent Receiver Assm) #04-08-52-008

Tell the Dealership to look at this. They should be able to fix it quickly.

Keep us updated.

Feb 08, 2011 | 2005 Cadillac STS

1 Answer

I have a 2007 Yukon with a remote starter that will not work. I can hear relays, but the engine will not crank. I assume there is another relay that is bad. any thoughts


{: ) You can hear relays, you may even see the exterior lights work when you press button. Normally before you remote start, you should make sure that the vehicle doors are locked.
The RVS (Remote Vehicle Start) system will not operate if any of the following conditions are present:
• A current vehicle DTC that illuminates the malfunction indicator lamp (MIL) • The vehicle is in valet mode. • More than 2 remote starts have been attempted. • The hazard switch is in the ON position. • A current hazard switch DTC is set. • The vehicle hood is opened. • A current hood ajar DTC is set. • The CTD system detects an alarm trigger. • Excessive engine RPM • Excessive coolant temperature • Accelerator pedal position greater than 0 percent • Vehicle not in park • Vehicle theft deterrent malfunction • A current automatic transmission shift lock control system DRC is set. • A vehicle speed sensor signal is detected by the ECM.

Jan 05, 2011 | 2007 GMC Yukon Denali

1 Answer

My factory remote starter won't work, when button on key fob is pushed the parking lights flash like they're suppose to but the engine doesn't start.


Make sure to hit the lock button twice then hold the start button until starting. There can be several issues for a malfunction.If this does not work we can definitely look into other options but the biggest reason for an factory remote start not functioning is the check engine light being on.It completely disables the remote start function. Here is a list of possibilties of why the remote start will not function.
A current vehicle DTC that illuminates the malfunction indicator lamp (MIL)
• The vehicle is in valet mode. • More than 2 remote starts have been attempted. • The hazard switch is in the ON position. • A current hazard switch DTC is set. • The vehicle hood is ajar. • A current hood ajar DTC is set. • The CTD system detects an alarm trigger. • Excessive engine RPM • Excessive coolant temperature • Accelerator pedal position greater than 0 percent • Vehicle not in park • Vehicle theft deterrent malfunction • A current automatic transmission shift lock control system DRC is set. • A vehicle speed sensor signal is detected by the ECM.

Dec 16, 2010 | 2006 Chevrolet HHR

3 Answers

NO FOB DETECTED


Slight glitch from what I've found. Has happened to me at the gas pump. One other time while talking outside my car with out opening the doors. If No FOB detected then step out of the car lock and unlock, get back in and try. If still dosen't detect then you need to walk twenty feet away with your key and it should reset.

Nov 18, 2009 | 2005 Cadillac STS

Not finding what you are looking for?
2011 Cadillac SRX Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...