Question about 2002 Nissan Frontier Crew Cab

Open Question

2006 Nissan frontier changed thermostat still runs hot

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
c17hydro
  • 2984 Answers

SOURCE: where is the location of the thermostat on a 2001 Nissan Frontier

on the nissian frontiers the thermostat is most likily in the lower radiator hose if you look from under the vehicle you will likily see a round housing with three bolts or nuts just follow the hose up from the rad

Please don't forget to rate!

Posted on Mar 20, 2009

Ad
Mr BrokRench
  • 1623 Answers

SOURCE: how do I change the thermostat on a 6 cylinder

Hello Wayne...the thermostat on your truck is located on the engine under the thermostat houseing. It is positioned in a fairly tight place. It can be replace with regular hand tools, ratchet extension, swivel socket and wrench. Follow the radiator hose to the thermostat houseing to locate. I suggest you replace it with a Nissan thermostat, they seem to last longer than an aftermarket, and come with a new houseing. Enclosed is a picture of the houseing you will be removing.
Make CERTAIN you install the new thermostat in the correct position...if installed backwards it will NEVER open and your engine will overheat in minutes possibly causeing severe damage.
Good luck..i hope this helps, please take time to rate me a fixya.
198dad1.jpg

Posted on Jul 15, 2009

  • 484 Answers

SOURCE: 2006 Nissan frontier 4 cylinder belt diagram + tensioner pulley

They are under the hood or on the front crossmember.

Regards,
matt

Posted on Sep 14, 2009

  • 4088 Answers

SOURCE: Frontier 2000 2.4L King Cab 100K miles. Temp

I've had problems with Datsun (later Nissan) engines hanging the closed thermostat until it boiled, then the thermostat released and operated normally. If you increase the small vent hole in the thermostat valve plate a small amount, the problem disappears. It seems that steam from engine operation gathers behind the thermostat sensing bulb and delays opening. The increase in vent hole size lets the steam through and allows the hot water to open the valve. Hope this helps!

Posted on Oct 12, 2009

Testimonial: "Thanks for this possible solution. I'll give it a shot."

  • 1 Answer

SOURCE: Timing belt change for a Nissan Frontier

how to replace the timing belt on my 2000 frontier 2.4

Posted on Jan 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WOULD A EGR VALVE CAUSE THE ENGINE RUN HOT?


Hi , Probably Not . Check the thermostat bulb position, and the coolant flow with the radiator . Check the oil pressure , flow and consistance ( viscosity an d cleanning) Good Luck

Jul 03, 2014 | 2000 Nissan Frontier

1 Answer

2006 Nissan Frontier 2.5l PCV valave location


http://www.clubfrontier.org/ please go to this site. it is a lenghy job on this vehicle.when page comes up, just type in on left top of page--- pcv replacement on 2.5. good-day !

Apr 11, 2012 | 2006 Nissan Frontier

1 Answer

There is no heat in my truck. I have the


make sure coolant is at proper level. if ok change thermostat. if the thermostat sticks it will make hot coolant go through bypass hose at thermostat, and therefore no heat. if that does not help much try bleeding air from coolant system.

Feb 09, 2010 | 2006 Nissan Frontier

1 Answer

My 2005 Nissan Frontier often puts out cold air from the heater


no i think the water pump impeller is starting to spin on the drive shaft ,the impeller is plastic on a metal shaft ,fairly common fault

Dec 24, 2009 | 2006 Nissan Frontier

2 Answers

Frontier 2000 2.4L King Cab 100K miles. Temp guage indicates overheating. Will intermittently spike then drop to normal. Engine does not "smell" hot or run rough at any time. Grab upper hose, you can...


I've had problems with Datsun (later Nissan) engines hanging the closed thermostat until it boiled, then the thermostat released and operated normally. If you increase the small vent hole in the thermostat valve plate a small amount, the problem disappears. It seems that steam from engine operation gathers behind the thermostat sensing bulb and delays opening. The increase in vent hole size lets the steam through and allows the hot water to open the valve. Hope this helps!

Oct 12, 2009 | 2000 Nissan Frontier

1 Answer

Gauge reads Hot but truck doesn't appear to be overheating - help


is antifreeze dirty looking and if was changed was it chemically flushed?

Jul 06, 2009 | 2002 Nissan Frontier Crew Cab

Not finding what you are looking for?
2002 Nissan Frontier Crew Cab Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...