Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
wow i feel sorry for you because Cadillac designed this bulb to be a don't get to bulb but OK here's what you do take the bottom cover off or skid plastic panel under neath the front end theirs little plastic clips holding it on just get come dikes and don't cut them but just use it to help pull them out. after you get that off use a flash light and locate your light housing you should see two screws holding the house in i think those screws are 8mm i cant remember remove those two screws and be careful the metal from the bumper cuts you pull the light housing out and remove all the screws around the housing and open the housing up replace the bulb and make sure your contact to the bulbs clean and then reassemble the way you took apart. if you cant get it well then best bet is take it somewhere i know Cadillac charges an arm and a leg so you can go somewhere else.
Posted on Jan 25, 2009
I have a 2000 ford focus no brake lights. with the brake lights the transmission would not go into drive .replaced the brake light switch checked fuse replaced turn signal switch with no results then i moved onto the wiper switch and replaced it as much to my supp rise it fixed the problems
Posted on Aug 06, 2009
SOURCE: 2006 Ford Fusion SEL - TPS
The TPS is an easy part to replace. It has 2 screws and 1 electric connector. It is about the size of a butane lighter and attaches to the metal airhorn.
There is only a slight adjustment possible for this part. One end has an elongnated slot for the screw. Just look at where the old part was adjusted and replace it that way. The only thing you need to watch is aligning the slot on the throttle shaft with the indentation on the TPS.
While you are replacing the part, disconnect the battery on the POS cable and this will reset the "check engine" light on the dash. Then reconnect and drive your car.
Posted on Apr 30, 2010
This link is from the handle to the latch. The door panel has to be removed in order for this problem to be fixed. The linkage is inside the door panel, it is a small diamater metal rod called a link. If you do the job yourself be careful not to break the door panel. In a shop, the labor is 1 hour for the job & if any, parts will be a seperate charge.
Posted on May 08, 2010
Tips for a great answer:
Dec 01, 2013 | 2006 Ford Fusion 1.4
Oct 13, 2012 | Cars & Trucks
May 26, 2012 | 2006 Ford Fusion
May 17, 2012 | 2006 Ford Fusion
Apr 04, 2011 | 2006 Ford Fusion
Aug 10, 2010 | Ford Fusion Cars & Trucks
Mar 17, 2010 | 2006 Ford Fusion
46 people viewed this question
Usually answered in minutes!