Question about Cars & Trucks

Open Question

2004 toyota 4 runner brake system warning buzzer and lights on

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: replace front brake pad 2003 toyota 4 runner

Diagram is unnecessry.
Pull both front wheels
Work one at a time leaving the other for reference
Find the retention spring ... its a paperclip thickness wire spring... dislodge center retention loop and undo from both ends which engage brake pad retention rods.
Pull the rods out
Pull the old pads out... laying everything on the ground
Use scrap wooden wedges to pry between the rotor and the caliper ...inside and out until the calipers are fully withdrawn. Use the new pads to measure if they are far enough back.
Note... the brake fluid will have dropped in the master cylinder over many months of wear... do not fill it. When the calipers are pushed back they will fill the reservoir again... one wheel at a time.
Be sure to identify the correct pad based on what you took out and what is on the other side (if you screwed up the layout)
Make sure to take the old antisqueek backing plate from the old pad and place it on the new pad. They don't use lubricant on these anymore.
Replace the pads... the retention rods... then the retention spring
Do the other side
Then progressively step on the brake peddle until full tension is felt
Check the master cylinder reservoir... probably needs no additional fluid.
New pads will register in existing ridges in each disc in no time at all.
You should check the discs to see if they need to be replaced during this operation...using some calipers

Posted on Mar 25, 2009

Ad
  • 184 Answers

SOURCE: How to reset the ''Check Engine'' light on a 1999 Toyota 4-Runner?

http://www.obd-codes.com/faq/reset_obd_codes.php

Posted on Apr 04, 2009

  • 101 Answers

SOURCE: How to reset the ''Check Engine'' light on a 1999 Toyota 4-Runner?

You need to reset the light with a scan tool, the same one you used to read the code in the first place.

Posted on Apr 13, 2009

  • 1 Answer

SOURCE: changing spark plugs in a 2004 toyota 4runner

check www.4x4wire.com i was just there looking for the same thing and found step by step directions on how to do it

Posted on Apr 19, 2009

  • 242 Answers

SOURCE: On a 94 Toyota Rav 4. A warning light is on. It

its rear accel oil low light ,top up very soon as can do damage.there a nut on accel to drain and refil

Posted on Dec 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

ABS ON,BRAKE RED L ON ALARM ON HARD PEDAL HOW CAN I FIND THE PROBLEM


VSC ABS and ! lights plus red (!) - Toyota Prius Forum ...

www.priusonline.com/...toyota-prius.../19804-vsc-abs-lights-plus-red.ht...

Jun 3, 2008 - 8 posts - ‎3 authors
If the accumulator fails, you will get a red brake warning light and the pump will now run continuosly until it burns out. ... hydraulic pressure to the brake system and "no"red warning lights. .... Fog Lights, PassGas, Toyota Prius General Discussion, 4, 10-13-2005 09:12 AM ... 11-13-2015 10:01 PM by Tim Lee.

Alarm with Brake Light, ABS, VSC and amber warning lights ' PriusChat

priuschat.com > ... > Gen 2 Prius Care, Maintenance and Troubleshooting
Jul 26, 2005 - Later that same day - I started getting an alarm - as soon... ... Gen 2 (2004-2009) Toyota Prius Forums > Gen 2 Prius Care, ... Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by NorthStar, Jul 26, 2005. ... I am getting the red BRAKE LIGHT, the amber waming symbol, ABS, and ... VSC, ABS, (!) and emergency brake light on
Feb 5, 2010
Brake, Brake warning, ABS, VSC appear
Oct 5, 2008
More results from priuschat.com

Nov 24, 2015 | 2005 Toyota Prius

1 Answer

I have a 2004 4 runner that the brake light on the dash came on since i have replaced the front and rear pads and topped off brake fluid on the vehicle. The brake light is still on where is the sensor...


Any air left in the system can cause a light on. If you ran the system completly dry while bleeding your brakes, that can also cause the light to be on. There is a level sensor in the mastercylinder, when the level gets so low it will illuminate the light. lightly tap the mastercylinder resevoir and see it the light goes out. The plunger will get stuck from time to time.

Mar 10, 2011 | 2004 Toyota 4Runner

2 Answers

2004 4 runner: Low tire pressure warning light is on, even though there is no tire pressure issue. Is this a sensor problem? or maybe the light is not working?


the senors tell you if the tire is low or even if the tire is not low if the tires are off a couple pounds from each other then the light will come on.

Dec 07, 2010 | 2004 Toyota 4Runner

2 Answers

How do I reset the maintenance light on my 2004 toyota solara



The odo-button dance procedure to reset the light is listed in Page 122-123 of the US 2004 Toyota Prius Owner's Manual (Section 2-5 "Operation of Instruments and Controls: Gauges, Meters and Service Reminder Indicators", item (j) in the "Service reminder indicators and warning buzzers" section). It should be listed in a similar section in your Toyota Camry Solara's Owner's Manual.

Oct 01, 2010 | 2004 Toyota Camry Solara

2 Answers

How do I disable brake warning light and buzzer on 93 LaSabre?


have you checked the brake fluid level? what is the label for fuse #6???

Sep 27, 2009 | Buick Century Cars & Trucks

1 Answer

'96 Toyota 4-Runner makes a loud squealing noise and brake light


Sounds like one of the auxillary belts slipping it may just need tightening up. I think the 4-Runner has two belts one large and one for the steering pump

May 13, 2009 | 1996 Toyota 4Runner

2 Answers

Tire pressure warning light stays on all the time for no reason


The tire pressure monitor must be re-calibrated, this is a dealer only repair, no one else will touch it, these systems are very trouble prone.

Nov 25, 2008 | 2008 Toyota 4Runner

1 Answer

Replaced rear brakes, Alarms still active


i have a 2003 toyota 4-runner my brake and abs vsc are on and it has a beeping loud noise.....what do u think is the problem?

Aug 21, 2008 | 2003 Toyota 4Runner

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...